Question about 2003 Dodge Durango

Open Question

Blend door heater assembly 2003 dodge durango

Posted by Anonymous on

Ad

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Ad
  • 245 Answers

SOURCE: location of speed sensor for a 2003 dodge durango

the speed sensor for this vehicle is actually in the rear differential of the vehicle. this is the sensor that runs the speedometer also known as the vehicle speed sensor. there are also two speed sensors in the front one on each wheel known as wheel speed sensors these are for the abs system only

Posted on May 17, 2009

Ad
  • 323 Answers

SOURCE: 1999 dodge durango heater core

It's a big job. Drain the coolant down, recover the freon in the ac system and disconnect the lines and heater hoses. Lower the steering column, remove the instrument panel assembly, remove the heater housing. Split the case halves on the housing and there you are. Usually around 500 to 700 dollars at a dealership.

Posted on May 29, 2009

  • 1757 Answers

SOURCE: 2003 dodge durango front heater/ac blower motor

Check the Blower Motor Resistor. This controls the Blower Motor/Fan Speed.

Posted on Dec 27, 2009

wracefans24
  • 1985 Answers

SOURCE: 2003 dodge durango front heater will not blow

Since your blower is working and it is a heat issue,thats where we'll start,First thing is have you checked the coolant level in the radiator when engine is cold,make sure it is filled to top,next verify you have coolant in reserve ,Start your van and get it up to normal operation temperature,If your heat gauge on the dash works correctly it should be 190 degrees,Now lift the hood and locate the two heater hoses going into the heater assembly at the fire wall,Both hoses should be hot to hold on to,if both are hot and no heat inside your problem will be the blend air door in heater assembly.
if neither hose is that hot you need to replace the thermostat in the engine to get it up to 195 degrees.
if one hose is hot and one is luke warm then the heater core is blocked and to blame. hope this helps you.

Posted on Jan 09, 2010

  • 645 Answers

SOURCE: 2003 Dodge Ram 1500 quad cab. While replacing a

it may be the switch itself they do go bad.Otherwise he could have pinched a hose or left one off. But it sounds like he is trying to help.

Posted on Feb 11, 2010

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

98 Dodge Durango only blows out cold air out of my heater please help


If the heater core is getting hot (check hoses under the hood for being hot that go to the core) then you have a failed air temperature control door (referred to as a "blend door") issue, in most cases the door warps and this causes the little motor drive that operates the door to fail due to the stress of the warped door being difficult to move. To remove the these parts for service/replacement you must remove the dash assembly form the vehicle.

Dec 22, 2016 | Dodge Cars & Trucks

1 Answer

2012 Durango. Heat coming out of driver side only. Blows cold air on passenger side and rear. Fluids fine. Any ideas?


Blend door broken inside heater case assembly need to remove dashboard to remove case to split case apart to replace

Jan 01, 2015 | 2012 Dodge Durango SXT 4dr SUV 3.6L V6 FFV...

1 Answer

ACCESS BLEND DOOR


blend door is inside the heat/ac box that contains the heater core that you changed. It is vacuum operated, so check all of your vacuum lines. There is a vacuum line that goes thru the firewall, right above or below the 2 heater hoses.

Jan 01, 2014 | 1999 Dodge Durango

1 Answer

Location of heatercore for rear heater


there is no seperate heater core for the rear. there is a flat tube under the carpet that goes from the heater box to the rear. If you have no heat in the vack, it could be blend doors not functioning correctly which could be from a vacuum leak.

Dec 12, 2013 | 2003 Dodge Durango

1 Answer

2003 Durango blowing warm air in the front and cold air in the rear.


Sounds like the blend door in the heater box is stuck on the warm side. Could be the actuator/motor that runs it. in some cases the door inside the box is actually broken. Hope this helps, not the easiest of repairs. if the controls in your dash are electronic, could be the controller, but less likely.

Jun 26, 2010 | 2005 Dodge Durango

3 Answers

2003 dodge durango front heater will not blow heat. but when driving heat will slowly come throught the heater vents. what should i check?


Since your blower is working and it is a heat issue,thats where we'll start,First thing is have you checked the coolant level in the radiator when engine is cold,make sure it is filled to top,next verify you have coolant in reserve ,Start your van and get it up to normal operation temperature,If your heat gauge on the dash works correctly it should be 190 degrees,Now lift the hood and locate the two heater hoses going into the heater assembly at the fire wall,Both hoses should be hot to hold on to,if both are hot and no heat inside your problem will be the blend air door in heater assembly.
if neither hose is that hot you need to replace the thermostat in the engine to get it up to 195 degrees.
if one hose is hot and one is luke warm then the heater core is blocked and to blame. hope this helps you.

Jan 08, 2010 | 2003 Dodge Durango

2 Answers

Dodge Durango 2003 a/c not cooling relpaced a/c


No offence but did the system get refilled properly?
Also be sure the blend door under the dash is moving corectly and completely

Jul 05, 2009 | 2003 Dodge Durango

1 Answer

1998 Dodge Durango blows cold air when using heater


The problem that has caused this cold air only issue is the Air Temerture Control Blend Door Actuator Motor, this motor is on the ouside of the air duct about center of the dash, in order to access and replace it u must remove the entire dash assembly. this is about a 12-15 hour job.

Jan 09, 2009 | 1998 Dodge Durango

Not finding what you are looking for?
2003 Dodge Durango Logo

Related Topics:

86 people viewed this question

Ask a Question

Usually answered in minutes!

Top Dodge Experts

yadayada
yadayada

Level 3 Expert

76164 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22156 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

8273 Answers

Are you a Dodge Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...