Question about Ford Windstar

Open Question

My 2002 Ford Windstar Van want pick up speed

The fast as it will go is 20 i got the spark plugs change and wires change now it want pick up speed

Posted by on

Ad

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
New users get to try the service completely Free afterwhich it costs $6 per call and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
Goodluck!

Posted on Jan 02, 2017

Ad
michigan man
  • 3533 Answers

SOURCE: engine light won't go off.

have the EGR valve tested because this will cause the engine light to come on and also check all vacuum lines

Posted on Mar 21, 2009

Ad
  • 41 Answers

SOURCE: my van when pressing on gas pedal jerks while

could be two things, 1; the coil is going bad. 2; the electronic egr valve has a piece of carbon in it. the latter is probably the problem. to fix this , just remove the valve, push on the piston and while holding it in the open position, spray with carb cleaner and blow it out, release the piston and be sure the valve is closing all the way. if the gasket is damaged you can get a new one at the parts store.

Posted on Dec 18, 2009

  • 1779 Answers

SOURCE: no heat in 99 ford windstar

Check the coolant level. If it's low, what you describe will happen. There is not sufficient coolant to flow through the heater core at idle. At 60mph the water pump is spinning quickly, managing to get some coolant through the heater core, so you get heat until the rpm's drop at idle. If it is due to low level, keep an eye on it to see if it drops again, as you may have a leak.

Posted on Jan 06, 2010

Testimonial: "Thanks for the great advice. I will try that and see what happens. Thank you again. This is a great blog for people like me."

czaa
  • 4535 Answers

SOURCE: 1999 Ford Windstar-Will Turn over but won't start?

fuel pressure regulator could hav failed-located by engine or the ignition module may not be workin-by dist area try not to be a parts replacer-buy a repair book

Posted on Jan 09, 2010

fingaz22
  • 1068 Answers

SOURCE: 2002 Ford Windstar Error Code P1131 And P1151

those two codes are for the o2 sensors. both are the upstream sensors on the front and rear banks. so they are desinagted bank 1 sensor 1 and bank 2 sensor 1. them most common cause for this is faulty o2sensors , bad gas and of a poor running engine. so if your car runs good (no misfire) and gas is ok then replace the o2sensor witch is the very most common cause.

Posted on Jan 28, 2010

Testimonial: " Help With Problem But Where Are These O2 Sensor"

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

I took my 2002 Ford Windstar LX 3.8L to a Ford Dealership to have three recalls fixed. My brakes, rear axle, sub-frame brackets. When I got it back it has a loud humming when I pick up speed from any


a hum is a very vague request a hum can be from tires ,engine ,driveshafts rear or front axles etc advise to bring back to dealer who preformed work on vehicle and advise them that the hum wasnt their prior to repair work also the work should be under warranty

Jul 24, 2013 | Cars & Trucks

1 Answer

What is an inition coil on a 1999 ford windstar van


The ignition coil (coil pack) is what generates the spark to the spark plugs. They're square black box with terminals that the spark plug wires run from to the spark plugs.

Jan 25, 2011 | 1999 Ford Windstar

1 Answer

Changed the spark plugs and wires on 1996 ford windstar 3.8 liter V6 put the wires back wrong. runs not right


STANDING IN FRONT OF VAN FRONT CYLINDERS FACING YOU LEFT TO RIGHT IS 4 5 6 BACK CYLINDERS LEFT TO RIGHT IS 1 2 3 GET A PIECE OF PAPER WRITE NUMBER 51 THEN WRITE NUMBER 62 UNDER 51 THEN WRITE NUMBER 43 UNDER 62 THATS YOUR COIL PACK WIRES LOCATION MATCH THEM WITH THE CYLINDER SPARK PLUGS YOU HOME FREE.

Oct 23, 2010 | Ford Windstar Cars & Trucks

1 Answer

Tune up


the rear plugs are accessed from under the van, they are a pain to change.

Apr 26, 2009 | 2001 Ford Windstar

2 Answers

Need know which cylinder is number one on 2000 ford windstar 3.8


#1 plug is the 1st plug on passenger side by firewall

Nov 15, 2008 | 2000 Ford Windstar

2 Answers

Van drops into 1st gear after 15 miles


What does the speedometer do when this happens? If it goes dead at the same time you need a Vehicle Speed Sensor which is mounted to the transmission. It tells the ECM what your speed is and without the input from the sensor, the computer assumes the van isn't going very fast and locks in 1st gear.

Jun 09, 2008 | 1998 Ford Windstar

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

49 people viewed this question

Ask a Question

Usually answered in minutes!

Top Ford Experts

yadayada
yadayada

Level 3 Expert

76630 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22219 Answers

fordexpert

Level 3 Expert

5537 Answers

Are you a Ford Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...