Question about 2006 Volkswagen Passat
Posted by Anonymous on
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
Posted on Jan 02, 2017
SOURCE: 2003 passat key fob reset
My used 2003 Passat came with both fobs unable to hold a key. I had to break them open to retrofit a loop. These are some great links that I bookmarked. The first one should give you programmin instructions.Good luck!
Posted on Feb 26, 2009
press your mileage reset button then turn key on then off,then repeat,2nd time keep mileage reset button pressed(keep pressed all the time basically)while holding mileage reset left turn your didgital clock then your service light should be off! ive done it on my 05 plate passat.
Posted on Mar 11, 2009
On the driver's side door handle, there is a cap covering the key hole on the right side. On the bottom of the cap is a small ****. Use the valet key to pry it up and off. Then you may open the door, most likely sounding the alarm, so you will need to insert the remote in the ignition to stop the NOISE!!!! Hope this helps. This is how I lock my remote away when I go somewhere to run.
Posted on Nov 06, 2009
I hope this might help. -- I had the same problem yesterday and fix the problem today. The steps on the manual (page 32) was too simple and wrong for my case. Read carefully the followint steps and thank me if these steps work. -- JB (owner of Jetta 2.5, 2006 model)
* The most important thing is to make sure that the LED in the driver side window frame stays blinking. The blinking means that the receiver has entered a programming mode and is waiting for the signal from the key. Good luck!
1. Insert the key with a faulty remote into the driver door lock and turn the key to the UNLOCK position 3 times in succession for at least 0.5 seconds each time, and within a total duration of 5 seconds.
: The system should now enter so called a "programming mode" and the window frame LED should blinking once every 1~2 seconds for the next 15 seconds. The faulty remote must be programmed during this period.
2. Aim the key to the (infrared) window frame LED which can be considered as a key signal receiver and press the lock button of the key fob and keep it pressed. While the button is pressed, press the unlock button three times in succession for at least 0.5 seconds each time.
3. Release both buttons.
* After all the efforts described above, the system should now acknowledge a successful programming by flashing the LED once every 1~2 seconds for more than 10 seconds. (Someone said that the small LED on the key fob should also blink a few times; although it didn't in my case.)
JB // email@example.com
Posted on Nov 07, 2009
Tips for a great answer:
Sep 15, 2015 | 2006 Volkswagen Passat
Mar 31, 2015 | 2006 Volkswagen Passat
Feb 19, 2015 | 2006 Volkswagen Passat
Feb 11, 2014 | Volkswagen Cars & Trucks
Jun 27, 2011 | 2003 Volkswagen Passat
Nov 03, 2010 | 2006 Volkswagen Passat
Nov 06, 2009 | 2006 Volkswagen Passat
Mar 11, 2009 | 2006 Volkswagen Passat
Jan 31, 2009 | 2003 Volkswagen Passat
157 people viewed this question
Usually answered in minutes!