Question about Peugeot 206

1 Answer

How do I change the radiator in a peugeot 206 verve?

Posted by on

Ad

1 Answer

  • Level 2:

    An expert who has achieved level 2 by getting 100 points

    MVP:

    An expert that got 5 achievements.

    Sergeant:

    An expert that has over 500 points.

    Governor:

    An expert whose answer got voted for 20 times.

  • Expert
  • 192 Answers

Pug 406 radiator change -
drain the coolant
remove top and bottom hose clips and the thin hose remove sensor multi plug
remove hoses
flick up clips at top of rad
lift it out!! that's it !!
replace in reverse order making sure the bottom locating pin rubber grommets are in place.
Hope this helps youKind regards

Posted on Feb 07, 2012

Ad

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya Mechanic can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repair professionals here in the US.
click here to Talk to a Mechanic (only for users in the US for now) and get all the help you need.
Goodluck!

Posted on Jan 02, 2017

Ad
ccrozier_agr
  • 36 Answers

SOURCE: peugeot 206 glowplugs

If your not good at mechanicing I suggest you take the car to someone that is experenced.
The reason I say this that we have loads of cars into the workshop with glowpugs broken in the head of the engine with the result of us having to remove the cylinder head.
What happens is that the tip of the glowplug breaks in the head when being removed if it is not done properly.
There is a way that we have found that they can be removed easily without breaking them.
Firsty run the car engine until warm, then we pour a little Diesel fuel onto each plug & let them sit for 15mins or so.
Then we remove them with a deep socket 1/4" drive so we don't put to much pressure on them.
they should screw out easily but we turn them out 1 whole turn then back a 1/4 add a little more diesel ( thimble full) & gently screw them out.
If they start to get really tight screw in again a little then screw out again.
The nuts that hold on the wires just need to be nipped up with a small 8mm spanner, but do not over tighten.

Posted on Dec 11, 2008

  • 1 Answer

SOURCE: peugeot 206 radiator fan relays

my fiancee's did this aswell, you need to get a new relay form peugeot (arounn £10) and 5 male conectors that will fit on the relay and cut the block off the wires and attach it this way. thats how i did it and it works a treat now mate.

hope that help mate, Ray.

Posted on Jul 05, 2009

  • 1986 Answers

SOURCE: How do i change 12v power / cigarette lighter! in a Peugoet 206

The cigarette lighter is connected to a harness that's being the unit. You need to most likely remove the panel that the cigarette lighter is attached to in order to remove the lighter unit out. Once the unit is out, disconnect the wiring harness to exchange it. I don't know how exactly your lighter will come out

Posted on Aug 25, 2009

  • 1 Answer

SOURCE: peugeot 206 cc fan belt change

hi ive a peugeot 206cc 02 reg, the STOP light keeps flashing ive checked the normal oil and water but alls ok so whats the problem still runs fine and temp stays where it should??? any tips??

Posted on Dec 28, 2009

  • 1 Answer

SOURCE: fuse box diagram peugeot 206

My car Lights all seem 2 b going slowly. dashboard went first and i keep changing the fuse for it and it will work for 3days or soo and then blow dont kno what the problem is? and then yday i fount out that my horn doesnt work now and my rear fog lights dont work, break, reverse and indecate still works... what could b the problem??

Posted on Feb 16, 2010

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Peugeot 206 temp gauge issue


Make sure the coolant level is correct. If it is, could be a bad water pump or a clogged radiator. Check the radiator to see if it looks like the inside has a lot of scale and deposits. Remove some coolant if necessary. If the radiator looks relatively clean , could be a bad pump.

May 06, 2014 | 2006 Peugeot 206 1.4

1 Answer

PEUGEOT 206 VERVE 06 PLATE WIPER SNAGS ON SIDE


remove the wiper arm and reposition it a bit further up on the windscreen. Make sure that the rubber is not much past the blade arm.

Dec 31, 2013 | 2006 Peugeot 206 1.4

2 Answers

Where is the brake light switch located on a peugeot 206 car


above the panel under the dash on a support bracket above the brake pedal ,twist and turn to remove

Sep 12, 2012 | 2001 Peugeot 206 1.6

2 Answers

Windscreen wiper snapped-Peugeot 206 Verve 52 plate


this just happened to us, the drivers side stopped working after getting tangled up with the passenger side...it was just a case of tightening up the 13mm nuts on the wiper arm.

Feb 26, 2010 | 2005 Peugeot 405

1 Answer

Peugeot 206 temperature gauge not working?


it could be a couple of things, first, check the wires to the temprature sender unit make sure they have not broke, as it was sudden this may be it, also it could be the sender unit it self as a freind of mine had with her car i changed that and the one for the radiator switch, but most of the time it will be something to do with the sender unit on the engine...hope this helps

Feb 15, 2010 | Peugeot 405 Cars & Trucks

2 Answers

Peugeot 206 cc fan belt change


hi ive a peugeot 206cc 02 reg, the STOP light keeps flashing ive checked the normal oil and water but alls ok so whats the problem still runs fine and temp stays where it should??? any tips??

Aug 28, 2009 | 2005 Peugeot 405

1 Answer

Hi, My peugeot 206 is leaking water at the front of the car just behind the reg plate from a pipe looking thing. Is that my radiator leaking?


sounds like the water feed from the radiator to the engine, may just be a damaged or worn hose...if so, its a cheap easy fix

Jul 28, 2009 | Peugeot 405 Cars & Trucks

4 Answers

Free online version of haynes car manual


can you help my pug 206 when starting from cold engine seems like it,s only firing on three cylinders then when engine is hot seems okay but looses power on hills 206 automatic 1.4 engine if anyone can help

Apr 14, 2009 | Peugeot Liberte Cars & Trucks

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

491 people viewed this question

Ask a Question

Usually answered in minutes!

Top Peugeot Experts

Colin Stickland
Colin Stickland

Level 3 Expert

22258 Answers

mike hayward

Level 2 Expert

279 Answers

Wahs Team

Level 2 Expert

215 Answers

Are you a Peugeot Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...