Question about Cars & Trucks

Open Question

2008 S550 MERCEDES BENZ

CAR WILL NOT START

Posted by Anonymous on

Ad

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Ad
  • 2 Answers

SOURCE: Ignition failing to start -S280 MERCEDES BENZ 1999 MODEL

Crank shaft position sensor is bad. This is the most common failure. Its location is on the rear drivers side of engine, where the transmission bell housing mates to the engine, only one small bolt and a two prong electrical connector hold it on. Usually will not throw a trouble code. If you remove it you can test it with an ohm meter, will have an erratic reading or read open loop, can malfunction intermittently or permanently after parking vehicle and won't restart. Applying some heat source to it during ohm testing with a hot air heat gun will usually cause the sensor to read open loop if your not sure if its bad or not. This reply is probably way to late, but I just happened to come accross it while online. Harry (master certified MBZ diagnostic tech)

Posted on Dec 06, 2008

Ad
  • 14 Answers

SOURCE: reset oil change indicator 2008 mercedes benz E350

With the key in position 1, hit the odometer reset button on the left on the cluster 3 times in a row. The cluster should beep once. scroll through the multifunction display with the page buttons until the display shows the onboard voltage screen. It will say something like "UB: 12.2 V" scroll threw this menu with with the up/down until you reach the "service menu" page. scroll down to "confirmation" press +, confirm full service with +. Wait till it says service confirmed. cycle the key off and then back on to position 2. Scroll to the normal service menu where it normally says how many days or miles till next service. If the service was reset correctly, it will say "service display not possible" for a few minutes while it recalculates. You must cycle the key off and back on before it will back out of the onboard diagnostic mode. If you dont back out, the esp/abs/bas lights will illuminate when the car is started

Posted on Apr 13, 2009

  • 32 Answers

SOURCE: 2008 mercedes benz ml63 amg oil consumption problem

Is the merc dealer serviced??, sometimes if you change brands of oils in synthetics >>semi synthetics you will get excess oil useage. City driving will tend to use more oil, but the merc should be able to do its 10,000k betwwen oilchanges.
Anyway, check what oil is being used in both weight example 0-60w, 5w-30 etc and by brand, check that the API oil spec meets what is required for your vehicle example API SM, SJ, SL etc.

Posted on Aug 08, 2009

  • 1596 Answers

SOURCE: MERCEDES BENZ 1996 C220 WONT START,GETTING FIRE AND GAS

Ignition Timing is Most Common Mistake for this Repairs No Start Problem

Posted on Oct 04, 2009

Testimonial: "info was very helpful"

  • 8404 Answers

SOURCE: Mercedes Benz car will not shift out of park. It

You are putting your foot on the brake before you try to move the shift lever, right?

Most cars have a locking device that prevents the shifter from moving unless the motor is running (key inserted into the wheel lock and on) and the brake petal is depressed.

Posted on Jan 02, 2010

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

How to reset the check engine light on a 2008 Mercedes Benz S550


The best way to reset it is to have the problem repaired that caused it to come on. Another way is to disconnect the battery negative cable for a few minutes and then reconnect it. This may cause other problems - loss of presets on the radio, and possibly loss of radio functionality if you don't have the appropriate code. And, depending on what caused the light to come on initially, it may just come back on soon after you start driving again.

Nov 28, 2016 | 2008 Mercedes-Benz S 550

1 Answer

How do i deactivate the sbc control on a 2007 s550 mercedes benz


as far as i am aware you will have to take to a dealer or some where that has the equipment to turn it off its not really a diy job if any light come on there is a problem with that system abs srs lights all need resetting

Nov 12, 2014 | 2007 Mercedes-Benz S550 Sedan

1 Answer

Cost to replace 2007 s550 key fob


Far that car maybe $100.00

Ask or call the dealer parts dept

Mar 19, 2014 | 2007 Mercedes-Benz S550 Sedan

1 Answer

My mercedes s550 cd player scans cd then says dics error


same with my problem .it's mean the eye laser is bad. you can't fix it.i have to go to the ebay buy the use one for $800 dollars. mercedes s550 tech such...too many problem. my is 65.000 mile i already replace lower arms control on 2 side A/C blower fan 2 struts suspension. now is the font lelf window not working. my god. i think the old toyota corola the tech is better then. (S550)

Feb 01, 2013 | 2007 Mercedes-Benz S550 Sedan

1 Answer

I changed the battery on my Key for an S550 and it wont start


need to go through relearn procedure...usually a key on (no start) key off and key on process..contact dealer for steps or search online.. if you are challenged by that post and i will obtain the code reset proceedure for you

Sep 30, 2012 | 2007 Mercedes-Benz S550 Sedan

1 Answer

Mercedes s550 clock


Hi Aamer, Salaam, When the vehicle has the ignition switched off the visible readout is also turned off but power feeds the clock memory. Once you restart the vehicle the visible read out is illuminated and the figures become visible. If however the clock needs to be reset each time you start the vehicle, that means that the power feeding the memory of the clock has failed, which usually means a broken cable or a bad contact. Regards and Shalom John

Sep 16, 2012 | 2007 Mercedes-Benz S550 Sedan

1 Answer

How to replace a taillight bulb on a S550 Mercedes?


how to change tail lights on 2007 Mercedes benz s550

Nov 23, 2011 | 2007 Mercedes-Benz S550 Sedan

3 Answers

Fuse location on Mercedes Sprinter 312D 1999


Mercedes Benz S550 problem with taking park and wont turn on

Apr 26, 2010 | 2007 Mercedes-Benz S550 Sedan

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

289 people viewed this question

Ask a Question

Usually answered in minutes!

Top Cars & Trucks Experts

yadayada
yadayada

Level 3 Expert

76164 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22156 Answers

Randy Ohler

Level 3 Expert

14585 Answers

Are you a Car and Truck Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...