Question about Cars & Trucks
Posted by Anonymous on
a 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of.(from cars to computers, handyman, and even drones)
click here to download the app (for users in the US for now) and get all the help you need.
Posted on Jan 02, 2017
SOURCE: VW Golf 2002 central locking
this sounds like a stuck switch in the door lock assembly. it will make the locking system work like its got a mind of its own. The best fix is to first try cleaning the latch on the door it has a switch to tell the car if the latch is open/closed. Use an old tooth brush with some degreaser scrub the base of the latch on the door. After its cleaned up relube it with some white grease or dry graphite. Then try the lock again. If this doesn't solve it then the lock assembly has a faulty switch inside and replacement is the best option
Posted on Dec 18, 2008
Hi there, this is a very common fault, you need to replace the drivers door actuator to stop the noise, ive done loads of these. hope this helps.
Posted on Jun 07, 2009
Tips for a great answer:
Mar 21, 2016 | Nissan Cars & Trucks
Nov 14, 2015 | Nissan Cars & Trucks
Apr 16, 2014 | 2001 Nissan Almera Tino
Aug 17, 2012 | Cars & Trucks
Mar 12, 2012 | Nissan Cars & Trucks
Remote Control Fob Procedures:
The Central Door locking is controlled by the Multi-Remote Control system which controls
the door locking, door super locking and emergency hazard reminders.
When the doors are locked and unlocked the unit flashes the hazard lights once for lock and twice for unlock.
A maximum of four remote controls are allowed to be programmed:
Ensure all the doors have been unlocked, either by using a good transponder key or remote
control plip key.
1. Turn the ignition switch from Position 0 to ON 6 times within 10 seconds.
2. Next, turn ignition switch to OFF position. Leave key in ignition switch.
3. Wait 2 seconds then the system will enter programming mode and will flash the warning
4. Press and HOLD the unlock button on the Plip.
5. While pressing the unlock button, press the lock button 3 times.
6. Release the unlock button.
7. The warning lights will flash once to indicate successful programming.
8. Repeat procedure 4 to 7 for up to 4 plip key's.
9. When completed turn ignition ON, and the warning lights will flash 2 times.
10. Remove key, and check all plip key's for operation.
NOTE : The programming mode will stop when either the ignition is switch ON, 4 plip keys
have been programmed or no input signal either from the switch or plip keys has been received
for 120 seconds.
i hope this can help you.. :)
Jul 28, 2008 | 2005 Nissan Sentra
114 people viewed this question
Usually answered in minutes!