Question about Peugeot Liberte

Open Question

What is fuse number for wiper motor on peugeot boxer van?

Posted by Anonymous on

Ad

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya Mechanic can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repair professionals here in the US.
click here to Talk to a Mechanic (only for users in the US for now) and get all the help you need.
Goodluck!

Posted on Jan 02, 2017

Ad
chiquititas
  • 1010 Answers

SOURCE: Peugeot Boxer 2005

If your vehicle has one. it usually snaps or threads into the back of the speedo at the upper end, and attaches to a drive gear on the transmission at the lower end.

Posted on Jun 26, 2008

Ad
alicantecoli
  • 22265 Answers

SOURCE: boxer van gear select problem

need to feel it ,could be clutch ,if it goes in without the running then its the clutch.But i think your problem is more like the linkage and if its a builders van,then you could have rubble dropped down inside the gearchange boot.???Boxer isnt the gearchange on the dash on this model??if so then the problem could be the linkage cable ,--they get a bit rusty and sticky and you can only buy a complete pair as one unit .Try oiling with a proper oil can and some engine oil ,and not that obnoxous fish oil wd stuff

Posted on Oct 30, 2009

  • 1 Answer

SOURCE: peugeot speedo mileage counter and speedo dont

Had this problem on mine & the main dealer were stumped. Eventually found it myself after a lot of pocking about.Have a look at the wiring loom in the engine compartment. Looking under the bonnet look closely on the right hand side of the engine above the gearbox where the wiring loom passes from the rear of the engine over a metal bracket/support to the front. The loom has a tendancy to rub against the bracket and eventually damage the cables within. You will have to remove the air filter canistor & a few air hoses to get to the bracket. Good luck!

Posted on Jan 11, 2010

  • 4885 Answers

SOURCE: i have a peugeot boxer van and need code for radio

Normal 0 false false false MicrosoftInternetExplorer4 /* Style Definitions */ table.MsoNormalTable {mso-style-name:"Table Normal"; mso-tstyle-rowband-size:0; mso-tstyle-colband-size:0; mso-style-noshow:yes; mso-style-parent:""; mso-padding-alt:0cm 5.4pt 0cm 5.4pt; mso-para-margin:0cm; mso-para-margin-bottom:.0001pt; mso-pagination:widow-orphan; font-size:10.0pt; font-family:"Times New Roman"; mso-ansi-language:#0400; mso-fareast-language:#0400; mso-bidi-language:#0400;} Please quote ALL the LETTERS+NUMBERS on ANY BARCODES , LABELS or STAMPED IN THE METAL CASING.

There should be a 14 character Serial Number beginning with RG or RN or PH or similar (often found stamped in the metal casing ) and maybe a Security Number in the format of TOA123 or TA123 or just A123 at the end of a barcode so please quote EVERYTHING you can find

Posted on Mar 21, 2010

iambanshee74
  • 3489 Answers

SOURCE: Windscreen wipers not working on peugeot 206hdi

The relay for these should be in the motor assembly itself. If there is no power getting to the motor, replace the switch on the column. This should rectify the issue. I have a manual for a 406 if that may be of some assistamce to you.

Posted on Oct 25, 2010

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Where is the horn located on an 2009 peugeot boxer


Anon, I am not familar with this vehicle, so I searched the net for horn replacement of your vehicle. Check the attached links,instruction and guides, Good luck
"I hope this helped you out, if so let me know by pressing the helpful button. Check out some of my other posts if you need more tips and info."
mendmy com How do fix replace horn on my peugeot boxer 2 van Vehicles Vans...
Horn not working
Boxer horn fault Motorhome Forums Motorhome Discussion Motorhome Chat

Jul 14, 2016 | Peugeot Cars & Trucks

1 Answer

Replace a fuel filter on peugeot boxer 2ltr hdi


Hello kenny mc kay, this article can tell you How to Replace Fuel Filter ,good luck!

Mar 01, 2014 | Cars & Trucks

1 Answer

What can be the problem of peugeot boxer van 2013 with an diesel engine stars but accelerate only at 2000 rpm


Hi all I have same problem I solvit it's from fulte cooling fan my men it's have problem in your car

Feb 14, 2014 | 2006 Peugeot 505

3 Answers

Where is the cigarette lighter fuse on a peugeot boxer


Thank you but I have just checked all of them by removing them & they are all ok :-/ Everything else is working & ok apart from that.. Puzzled....!!

Nov 04, 2012 | Peugeot Cars & Trucks

1 Answer

Peugeot boxer van 2007 changed interior light bulb blew fuse, renewed fuse, lights worked, but emissions lights on dash board came on and won't go out. Help


Try reading the OBDII with a code reader and see what it is then erase codes and see if it stays off ,could be more than one circuit on this fuse so the fuse blowing has thrown the light on for whatever reason ,Also try disconnecting the battery just out of interest for a few minutes and reconnect it might go out if your lucky

Feb 27, 2012 | Cars & Trucks

1 Answer

I have a peugeot partner van and the wipers dont work. A have put on a new switch, but they still dont work, is it the switch


Hi

Most likely it will be a fuse, if you have already checked that then the wiper motor may have packed up. by switch I pressume you mean the main switch to turn them on? from inside the van.

I had one of these some time ago a 1999 version that had many problems with the wipers before I had the motor changed.
Hope that helps
Regards
Dan

Sep 30, 2010 | Peugeot 405 Cars & Trucks

1 Answer

I have a peugeot boxer van and need code for radio


Normal 0 false false false MicrosoftInternetExplorer4 /* Style Definitions */ table.MsoNormalTable {mso-style-name:"Table Normal"; mso-tstyle-rowband-size:0; mso-tstyle-colband-size:0; mso-style-noshow:yes; mso-style-parent:""; mso-padding-alt:0cm 5.4pt 0cm 5.4pt; mso-para-margin:0cm; mso-para-margin-bottom:.0001pt; mso-pagination:widow-orphan; font-size:10.0pt; font-family:"Times New Roman"; mso-ansi-language:#0400; mso-fareast-language:#0400; mso-bidi-language:#0400;} Please quote ALL the LETTERS+NUMBERS on ANY BARCODES , LABELS or STAMPED IN THE METAL CASING.

There should be a 14 character Serial Number beginning with RG or RN or PH or similar (often found stamped in the metal casing ) and maybe a Security Number in the format of TOA123 or TA123 or just A123 at the end of a barcode so please quote EVERYTHING you can find

Jan 21, 2010 | 2006 Peugeot 504

1 Answer

Boxer van gear select problem


need to feel it ,could be clutch ,if it goes in without the running then its the clutch.But i think your problem is more like the linkage and if its a builders van,then you could have rubble dropped down inside the gearchange boot.???Boxer isnt the gearchange on the dash on this model??if so then the problem could be the linkage cable ,--they get a bit rusty and sticky and you can only buy a complete pair as one unit .Try oiling with a proper oil can and some engine oil ,and not that obnoxous fish oil wd stuff

Sep 09, 2009 | 2005 Peugeot 405

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

407 people viewed this question

Ask a Question

Usually answered in minutes!

Top Peugeot Experts

Colin Stickland
Colin Stickland

Level 3 Expert

22265 Answers

mike hayward

Level 2 Expert

279 Answers

Wahs Team

Level 2 Expert

215 Answers

Are you a Peugeot Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...