Question about 2001 Dodge Intrepid

Open Question

How to change out valve cover gaskets in 2001 dodge intrepid -2.7

Posted by Anonymous on

5 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

  • 1596 Answers

SOURCE: possible bad ignition coil and valve cover gasket

No start on 97 dodge intrepid. I Know that Coil pack is Below Valve cover and Have repaired Numerous Ignition coils due to there becoming Oil soaked , the oil will gather dust dirt and thus Insulating ( Retaining Heat) i and this Causes them to Over heat and Fail , in short Burning them out. I say this Because of your Mention of it as a symptom. you must first Determine if it is getting spark ,have someone Crank Engine over While you are Holding the Spark plug wire 1/4 inch away from coil tower (TERMINAL) do this to all 6 if no spark at any of them ,that coil could be bad (Most Likley), If all Have NO SPARK then it is One of the fallowing,,

  1. Cam Sensor
  2. Crank Sensor
  3. Ignition control module
If Control module is wet with Oil most likely needs replaced some Parts stores can test coil and Modules.

NOW if you have Spark on All 6 Cylinders Check for fuel delivery, Do this at the shrader Valve on the fuel rail,(LOOKS LIKE AIR FILL VALVE ON WHEELS) Simply remove cap turn key on for 5 seconds then turn it OFF Depress the Stem at shrader valve If you get a Good SPRAY of FUEL upon doing this 3-4 times then you have Fuel Pressure !!!!WARNING !!! Test Equipment is Recommended for all Procedures but their certain steps to take if you don't have a DIGITAL VOLT METER or Fuel Pressure tester. I Hope this helps you with your Diagnosis od the problem. Have A Good Day

Posted on Jan 13, 2009

landsend
  • 1066 Answers

SOURCE: changing valve cover gasket on 2001 dodge stratus, how

remove all the components in the way of the valve cover.  Then remove the valve cover and replace the gasket and reassemble.
usually about a 3 to 4 hour job.

Posted on Mar 23, 2009

c17hydro
  • 2984 Answers

SOURCE: how to change valve cover gaskets

No, not at all!

Take your time....take pics of it BEFORE you remove the next piece.

No special tools required.

Posted on Mar 31, 2009

wilsodfarm
  • 986 Answers

SOURCE: Why do I have excessive oil blowing out the valve cover.

Your engine has exceive blowby ,compession is getting past your rings and pistons.it could be one or all of your cyliners,but you need to check your pvc before we condem other things ,I hope this helps you

Posted on Oct 01, 2009

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Can I replace my chain tensioneer with out removing valve cover 2.7 intrepid 2001


You also have to remove everything in the front of the engine. Valve cover is just the first thing to come off. You need a manual.

Jul 05, 2016 | 2001 Dodge Intrepid

1 Answer

Hay i got a 1997 dodge intrepid and on the driver side the bk spark plug i went to pull it out and when i got it out my spark plug and scocke was coveger in oil do u no why and how to fix it


Sparkplug tube seals are leaking. You will need to remove the valve covers and replace the valve cover gaskets and the round seals in the middle of the cover. the tube seals should come with valve cover gaskets.

Nov 20, 2010 | 1997 Dodge Intrepid

1 Answer

99 Dodge Intrepid 2.7L no power to ignition. Receiving Code P1684 but battery connection okay.


I have a problem with a 1999 Dodge Intrepid 2.7. Looking for some help or suggestions.


Problem: I only have a spark from the #2 coil.


Background:


Vehicle purchased from an Auction and would not start. The vehicle would only backfire. When I removed the valve covers I found that one of the rocker arms had popped out. I replace the heads with heads from a 2001 Intrepid 2.7. I used the cams, primary and secondary timing chains from the 1999 heads. Not sure if I used the original primary (left) cam sprocket from the 1999 or one I purchased in a kit from a Dodge dealership. I tried to use the new primary timing chain but it was not the same. The replacement heads were surfaced and a new head gasket was used. When I tried to start the vehicle it had no spark. The vehicle had set at several locations and parts may have been removed or changed.


Solutions Tried:


I tried 4 ASD relays with no effect. I then tested all 4 on a 2002 Intrepid 2.7 that runs and all worked. I then discovered that the Crank PS has missing. I replaced the Crank PS with one from a 2002 Intrepid 2.7 with no effect. I then replaced the Crank PS with a Crank PS from a 1999 Intrepid 2.7 and got a spark at the #2 coil only. I then replaced the PCM and TCM from the same 1999 Intrepid I got the Crank PS from and still only have spark from #2 coil. I then changed the Cam PS, still spark only from #2 coil. I have tried several coil packs on connector #2 and all have spark. Each coil pack that sparks on #2 will not spark on any other connector. Spark from #2 coil is weak.


I then replaced the wire harness from the PCM to the coils and fuel injectors and still only have spark from the #2 coil. What am I missing? Any suggestions, advice or related information will be greatly appreciated!


Thanks!

Keith P. Richardson

Kpricha2@yahoo.com

404-606-0728

May 20, 2010 | 1999 Dodge Intrepid

1 Answer

Changed head gaskets n put chains back exactly as they were car was running before now it wont start a couple of cylinders only have 70 lbs compression


2.7 engine? Valves are bent. These engines are famous for timing chain problems, replace all of the chain, guides tensioner and water pump if its apart.

May 12, 2010 | 2001 Dodge Intrepid

2 Answers

White smoke from tailpipe


this is oil from leaking valve stem seals

Mar 03, 2010 | 1999 Dodge Intrepid

1 Answer

Why do I have excessive oil blowing out the valve cover port hose that goes into the intake breather of my 2001 dodge intrepid se.


Your engine has exceive blowby ,compession is getting past your rings and pistons.it could be one or all of your cyliners,but you need to check your pvc before we condem other things ,I hope this helps you

Oct 01, 2009 | 1998 Dodge Intrepid

1 Answer

2001 dodge 2500 4x4 high oil consumption


These are know for having a leaking gasket on the bottom of the intake that will cause oil consumption. To test for this take the pcv valve out of the passenger side valve cover and the crankcase filter out of the driver side. With the engine running put your thumbs over the holes in both valve covers. It should build pressure. If you feel it pulling a vacuum, the gasket is leaking. You have to remove the intake and flip it over on a bench to change the pan gasket on the bottom.

Apr 05, 2009 | 2001 Dodge Ram 2500 Truck

2 Answers

Changing valve cover gasket on 2001 dodge stratus, how


remove all the components in the way of the valve cover.  Then remove the valve cover and replace the gasket and reassemble.
usually about a 3 to 4 hour job.

Mar 16, 2009 | 2004 Dodge Stratus

1 Answer

Oil return blocked?


Oil around plug boot on that car is due to leaking valve cover seals.If you remove the valve cover,you will see big O rings that go around each of the plug holes,Just replace valve cover gasket set and problem should be solved.While you have it off,tou can look at the return for obstructions.

Jan 09, 2009 | 1997 Dodge Intrepid

Not finding what you are looking for?
2001 Dodge Intrepid Logo

Related Topics:

308 people viewed this question

Ask a Question

Usually answered in minutes!

Top Dodge Experts

yadayada
yadayada

Level 3 Expert

74896 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22095 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

7688 Answers

Are you a Dodge Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...