Question about 2004 Jeep Grand Cherokee

Open Question

How do i change/remove rear fog light on jeep grand cherokee overland 2006

Posted by Anonymous on

Ad

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of.(from cars to computers, handyman, and even drones)
click here to download the app (for users in the US for now) and get all the help you need.
Goodluck!

Posted on Jan 02, 2017

Ad
FoRdMaStEr
  • 51 Answers

SOURCE: how to change fog light bulb on 2004 jeep grand cherokee

you have to crawl under the front of the vehicle and look at the back side of the light you will find the connector and the bulb

Posted on Jan 06, 2009

Ad
polarcycle
  • 1392 Answers

SOURCE: 2005 Jeep Grand Cherokee rear seat removal

For the seat bottom, you just need to pull it up. The seat backs would have to be unbolted.

Posted on Mar 06, 2009

johnnyblazen
  • 6 Answers

SOURCE: change the time on the clock in a 2006 jeep grand cherokee

Hold the time button down until the time blinks and you can use the Tuner to set the time. Push the tuner in to switch from Hours/Minutes and when you're done just wait till it stops blinking.

Here's the manual too if you want it.

Posted on Mar 11, 2009

  • 6982 Answers

SOURCE: 2004 Jeep Grandcherokee - Transmission Maintenance

I'm going to guess since you didn't mention which fluid...Transmission?
First find out which unit you have (usually an id tag on it somewhere ) Then look up what kind and how much fluid in your owners manual (usually around four quarts...unit holds more but you can't remove it from the pan) Remove all pan bolts and lower pan. (some units have a drain plug, use it first if you have one ) you will see the filter attached to the valve body. remove it and install the new one, Make sure all gasket material is removed from pan and trans. Clean any metal etc from pan and internal magnet (there is always some in there but should not be a ton of it) Then put pan and gasket back. Make sure you can turn each fastener easily to make sure they are not cross threaded and only tighten them after they are all in there. Bolts do not have to be tightened down like they never should be removed again (snug then a little bit more)tighten in an X pattern not a circle.Replace about half of the fluid with car off, then put in remainder while running. Put your foot on the brake and shift to reverse then drive a few times then check fluid level.Low is bad, a tiny bit (less than half inch) over is OK.
Drive for a short ride, check again for leaks and re-tighten if any are found.
If trans was exceptionally dirty and yours has a drain plug, I recommend that you use a generic oil on the first change, then in a week, drain oil again and re-fill with good brand name stuff. and perhaps a bottle of lucas conditioner.
Good luck!

Posted on May 14, 2009

  • 90 Answers

SOURCE: HOW TO REMOVE HEADLIGHT ASSEMBLY 2006 JEEP GRAND CHEROKEE

remove the 7mm bolt in the centre top of lamp unit then with a big screwdriver just behind headlamp prise outwards quite firmly

Posted on Jul 03, 2009

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

How to change starter 2002 Jeep grand Cherokee ?


Depending if you have the Reg, sport, or high end like overland you may have to remove the subframe to facilitate getting it out

Aug 20, 2014 | 2002 Jeep Grand Cherokee

1 Answer

I need wireing diagram for a caravan plug for a 2007 jeep grand cherokee


Check on your motor you have some where a place how you have your number of your celynder

Jul 16, 2014 | 2007 Jeep Grand Cherokee Overland

1 Answer

I need to replace the rear fog light cover in the bumper of a 2006 grand cherokee. Do I need to take the bumper off to do so?


FSM 101 or the parts list. shows this.
the parts list show 2 types.
one in the main lamp. ID 7 in drawing
then the optional bumper fog kit, rear.
so bumper. but since its and option, its not that well covered.
not in fsm i bet. did you look.?
so here is my best guess.
the kit shows NO SCREWS.
so just pry's off
see it here.

http://www.factorychryslerparts.com/showAssembly.aspx?ukey_product=4612193&ukey_assembly=1122497

or im wrong and you must gain inside access
to trip the plastic locking lever on lamp.
as you see the lens is not SOLD.
so?

Mar 31, 2014 | 2006 Jeep Grand Cherokee

1 Answer

How do I replace the offside rear fog lamp unit?


the online, parts pages dont show screws. so...............
and is a OPTION kit.
so it must pry off.?
you can see it at jeep parts
look here and see it.
http://www.factorychryslerparts.com/productSearch.aspx?ukey_make=1064

only the FSM covers how to remove a lamp , to such details.
buy one. or try alldata.com
rear fog options are, weak on documentation.

Mar 15, 2014 | 2006 Jeep Grand Cherokee

1 Answer

Both malfunction indicator light and electronic throttle control warning light is burning after I had my 2006 jeep crd overland serviced. The car is losing power wile driving. What do I need to solve


have the fault codes read and replace the faulty units. Ask the service person if they pressure cleaned the engine as that quite often causes problems with water getting into the connections and shorting out

Apr 07, 2013 | 2007 Jeep Grand Cherokee Overland

2 Answers

Need to remove and install driver's side tail light on 2007 Jeep Overland


OPEN HATCH AND REMOVE TWO SCREWS FROM THE INSIDE OF THE BODY PANEL FACING THE TAIL LIGHT. GENTLY PULL THE LIGHT BACKWARDS UNTIL THE WHOLE LENS AND LIGHT FIXTURE COME OUT FROM THE BODY. UNSCREW THE SOCKET AND REPLACE THE BULB. I HOPE THIS HELPS. THANKS FOR USING FIX-YA.

Aug 28, 2009 | 2007 Jeep Grand Cherokee Overland

1 Answer

2004 Grand Jeep Cherokee, Overland. Rear lights and brake lights not working. Drove last night with no lights at all in back - completely dark. Turn signals work. Checked fuses (I think I checked the...


After checking the fuses I would replace the fuse for the tail lights just to make sure it wasn't a fuse issue and if that doesn't do it I would check the bulbs on both sides to make sure that the bulbs are good.

Aug 16, 2009 | 1996 Chevrolet K1500

1 Answer

Left directional light intermittent to plain out...


I was once a fleet manager with many Jeep Grand Cherokees 1999-2002. We had TREMENDOUS problem with REAR tailight housings. It seem the tailight/signal/back-up light circuitry is embedded in the plasticx of the housing. NO WAY to repair. Replaced with a new one from Jeep. Problem gone. ( at least until the other side went bad ) Not a guarranty, but it's a good chance it has the same problem.

Mar 31, 2009 | 2007 Jeep Grand Cherokee Overland

2 Answers

How to change fog light bulb on 2004 jeep grand cherokee


There's a small space behind inside fender. You can get your hand in there to grab and twist the back of the bulb to release it. You need a flashlight.

Jan 04, 2009 | 2004 Jeep Grand Cherokee

Not finding what you are looking for?
2004 Jeep Grand Cherokee Logo

Related Topics:

300 people viewed this question

Ask a Question

Usually answered in minutes!

Top Jeep Experts

yadayada
yadayada

Level 3 Expert

76848 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22246 Answers

Kevin Daniels

Level 3 Expert

1455 Answers

Are you a Jeep Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...