Question about 2006 Chevrolet Cobalt

Open Question

How to remove starter on 2.2 l 2006 chevy cobalt

Posted by Anonymous on

4 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

brandyspoile
  • 61 Answers

SOURCE: how to remove inner window crank on 2006 chev cobalt 2 dr

the handle part of the crank is held on by a small ring, you will need a small flat head screw driver- i used a butter knife, as it works better- push the door panel back just enough you can see behind the round part of the handle, you should be able to see the foot of the clip, push it off, make sure you don't do this in the grass, the ring will roll when it falls off. **please note this is a flat ring and only about the diameter of your little finger**

Posted on Nov 25, 2008

  • 10 Answers

SOURCE: I need to remove the front headrest of a 2008 chevy cobalt lt

Push the button and pull up on it at the same time

Posted on May 25, 2009

  • 98 Answers

SOURCE: 2006 chevy cobalt - door won't open

Start with the basics. Check the fuses (all of them) with a test light and be sure you have power to each and that they are good. Then be sure that the power lock relay is good by swapping it with another relay in the fuse block. If the fuses are good and the relay is swapped and the locks still aren't functioning, you may have an issue with the BCM. The BCM can be programmed to change the behavior, but if the car has had water damage, or other stress to the BCM (voltage, heat, etc.), it can sometimes damage the BCM and you will need to replace it and reprogram it at a GM dealership.

Posted on Jul 25, 2009

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

How do I get to top bolt on starter of 2006 chevy cobolt


depends on the motor it has if has motor that use a coolant compressor ,you will have to remove it to gain access to starter connections and bolts .if not its easier,but first remove negative cable raise the car and look up in there.good luck

Feb 28, 2015 | 2006 Chevrolet Cobalt

2 Answers

How do i remove a 2006 chevy cobalt starter?


Some starters have 2 bolts and some 3 . Make sure your battery is disconnected. Remove he battery wires and some times you have to wiggle it to get it to move . Run your hand all around the starter to make sure all the bolts our out.

Jun 10, 2014 | 2006 Chevrolet Cobalt

1 Answer

2006 chevy cobalt ss how do i replace starter relay?


There is a start/run relay in the underhood fusebox

Dec 10, 2013 | 2000 Ford Explorer

1 Answer

R&r starter to 2006 cobalt ls


Park your Chevy Cobalt on a level surface, activate the emergency brake and place blocks behind the back tires for safety. Disconnect the negative battery cable with a terminal puller. Raise the front end of the car with a jack for easier access to the starter.
Remove the intercooler pump's outer bracket in models with a 2.0L engine. Place the bolt, and all other nuts and bolts, into the jar for safekeeping until later.
Disconnect the starter electrical connections, including the S-terminal and positive battery cable. Label the wires if you have concern about remembering where they go when you install the new starter.
Unscrew the starter mounting bolts and remove the starter from the vehicle's engine.
Take your malfunctioning starter to the parts store with you. Aftermarket distributors remanufacture most of the starters they sell, so you can likely obtain a partial credit toward your new starter by exchanging your old one. Be sure that you take care not to damage the starter in transit, because the better condition it is in, the more you can get for it.
Purchase a replacement starter that has the same or higher cranking capacity (power rating) as the original starter. Also, match the bolt patterns, drive gears and electrical connections. Your owner's manual may list specifications or the auto parts technician will help you determine them. Download a free owner's manual by registering with the Chevy Owner Center (see Resources).
Install the new starter by reversing the removal process. Torque the starter mounting bolts to 37 foot pounds (50 Nm). Tighten the bolt for the intercooler pump bracket to 15 foot pounds (20 Nm).
Lower your Cobalt back to the ground. Reconnect the negative battery cable. Turn the key in the ignition to see if your new starter motor functions correctly.

Nov 04, 2013 | 2006 Chevrolet Chevrolet Cobalt LS

1 Answer

My 2006 cobalt wont start


There can be a couple things, nutral saftey switch, AC DELCO, NEUTRAL SAFETY SWITCH Direct Replacement Part For OE Number 24219476 `$68.67 , ignition switch not adjusted correctly, try jumping the starter at the starter to see if the starter is working, of course I have just fixed a car that the guy didn't have the shifter in park, try these things and get back to me

Oct 18, 2011 | 2006 Chevrolet Cobalt

1 Answer

My car wont start and it is making a clicking noise someone said it might be the starter. Where is the starter located? It is a 2005 Chevy Cobalt


On the Cobalt's the starter should be on the rear of the motor attached to the transmission housing.But before you change the starter you might want to have the battery checked to make sure that you have enough starting power from your battery.This can be tested at any auto parts stores for free.

May 10, 2011 | Chevrolet Cobalt Cars & Trucks

1 Answer

Faulty chevy cobalt ignition


put a drop of engine oil down the barrel and work the key up and down a couple of times

Jun 22, 2009 | 2008 Chevrolet Cobalt

1 Answer

I need to remove the front headrest of a 2008 chevy cobalt lt


Push the button and pull up on it at the same time

Apr 04, 2009 | 2008 Chevrolet Cobalt

Not finding what you are looking for?
2006 Chevrolet Cobalt Logo

Related Topics:

413 people viewed this question

Ask a Question

Usually answered in minutes!

Top Chevrolet Experts

yadayada
yadayada

Level 3 Expert

74945 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22095 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

7697 Answers

Are you a Chevrolet Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...