Question about 1998 Honda Civic

1 Answer

Civic 1996 motor mounts

Location of all mounts, and how to remove.

Posted by on

Ad

1 Answer

  • Level 1:

    An expert who has achieved level 1.

  • Contributor
  • 1 Answer

One is on the right side of moter on top then one below that on the right side one in the back and two on the trans if you need them off and they all unbolt

Posted on Feb 23, 2012

Ad

4 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya Mechanic can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repair professionals here in the US.
click here to Talk to a Mechanic (only for users in the US for now) and get all the help you need.
Goodluck!

Posted on Jan 02, 2017

Ad
  • 1 Answer

SOURCE: need to remove window crank on 1996 honda civic

I have a 97 honda accord and it is helpful to have the tool to remove the clip. you can pick one up pretty reasonably at the local car store. it's pretty much a flat tool that fits between the handle and the door pane.'

Posted on Mar 15, 2009

MNfisherman
  • 11896 Answers

SOURCE: how to remove transmission on 97 honda civic dx

remove crossmember, axles, cables, tranny mount bolts (3), tranny to engine of course bolts

Go to autozone.com and register for full free online repair manual

Posted on Sep 11, 2009

CMR_Racing
  • 24 Answers

SOURCE: front wheel bearing removal and installation 1996 civic

http://honda-tech.com/showthread.php?t=2517273 go to this site it has a step by step including pics

Posted on Dec 13, 2009

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

1998 Honda Civic LX engine motor mount replacement


You will need a suitable jack to support the engine for mount replacement. Some mount removel/replacement will require additional parts to be removed for access to the mounts. Experience is the biggest tool to have in your tool box for this type of repair as info on mount replacement is usually very scant

Mar 03, 2016 | 1998 Honda Civic LX

2 Answers

How to locate and remove the blower motor resistor in a 1996 GMC Sierra?


It is located on top of the heater box in the passenger side remove the glove box to gain acess there are two 7mm srews and a relay braket holding it in place it is a tight squeeze but can be removed with a 1/4 inch ratchet.
source: fixya
thanks for using fixya

Hope this helps

Jan 13, 2011 | 1996 GMC Sierra

1 Answer

Where is the starter located on a 91 grand prix se?


e12c4da.jpg

Fig.: Starter motor mounting-2.2L engine


58c758a.jpg

Fig.: Starter removal and installation-2.3L engine


8204771.jpg

Fig.: Starter motor mounting-2.5L engine


b967f34.jpg

Fig.: Starter motor mounting-1996 3.1L engine shown


Hope helped (remember comment and rates this).

Apr 16, 2010 | 1991 Pontiac Grand Prix

1 Answer

How to change fuel filter on 1996 Honda Civic


It is located Under hood, center, upper firewall, mounted in fuel line (basically back of dash). Take note of how it is mounted not to install backwards. Unhook battery ground. Unhook two fuel lines one on top one on bottom of filter.Mark fuel lines top/bottom tape helps not to get mixed up. Remove from clamp. place new filter in clamp noting proper top and bottom. replace fuel lines. reattach battery, cycle key on and off 3 times slowly. (when you turn key foreward you will hear pump kick on. when stops turn off. Do again 2 more times then start.

Jan 27, 2010 | 1996 Honda Civic

1 Answer

Need to change speed sensor on automatic 1996 civic honda,how do I perform install?


The Vehicle Speed Sensor (VSS) is located underneath the thermostat housing.
  1. Disconnect the 3-P connector from the vehicle speed sensor (VSS).
  2. Remove the mounting bolts, then remove the VSS.
    NOTE: The VSS drive link is a very small part, be careful not to lose it.
  3. Install in the reverse order of removal.

bcf1276.gif59b7f5a.gif

Sep 17, 2009 | 1996 Honda Civic

1 Answer

I cant figure out how the ac belt goes on....94 civic vtech


You have to support the engine with a floorjack and then disconnect the left motor mount. The belt slides through the gap and then you reconnect the motor mount. You probably have to remove the left front tire.

Aug 15, 2009 | 1990 Honda Civic

1 Answer

Changing A/C belt


yes sometimes the upper mount or center mount located on the pass side of the motor compartment has to be removed to replace the belts,just put a jack under the motor to support it when you undo the mount.

Mar 30, 2009 | 1995 Honda Civic del sol

1 Answer

1996 honda civic air bag controller module


The air bag module is located below the center of the dash in front of the center console mounted to the floor.Be sure to disconnect the batt. before removing and not to drop or bang the module.Good luck!John.

Mar 09, 2009 | 1999 Honda Accord

1 Answer

Where is the starter located on a 1996 honda civic ex 2 dr coupe


The rear of the motor above you drive axle left side

Mar 05, 2009 | 1996 Honda Civic

1 Answer

96 civic shakes while gaining speed, okay when up to speed


If you had an aliment and tire balancing done, the only thing I can think of that would cause vibration of the car at higher RPM (3500+) Would be a motor mount. Check your motor mounts and get back to me :)

Feb 11, 2009 | 1996 Honda Civic

Not finding what you are looking for?
1998 Honda Civic Logo

Related Topics:

90 people viewed this question

Ask a Question

Usually answered in minutes!

Top Honda Experts

yadayada
yadayada

Level 3 Expert

77499 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22306 Answers

Kevin Daniels

Level 3 Expert

1455 Answers

Are you a Honda Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...