Question about 1997 Mitsubishi Eclipse

Open Question

How do you replace the turn signal switch/lever on a 1997 Nissan Sentra GXE. It broke off at the steering column.

Posted by on

Ad

3 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of.(from cars to computers, handyman, and even drones)
click here to download the app (for users in the US for now) and get all the help you need.
Goodluck!

Posted on Jan 02, 2017

Ad
  • 548 Answers

SOURCE: The steering column on my 1997 mitsubishi montero

did you check the lock mechanism under the wheel at the dash? you have to relock the wheel it sounds like by pushing the lock lever

Posted on Aug 24, 2009

Ad
elix0411
  • 3530 Answers

SOURCE: Turn signal and hazard lights

Welcome to Fixya

Flasher is located underneath the dash (Driver side fuse panel). See picture of the flasher below.
elix0411_59.jpg Thank you for using Fixya!

Posted on Jul 14, 2011

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Low beams work but one works high beam and one dosent work


Either one of your headlight bulbs has burnt out it's high beam filament (which can be checked by swapping the bulbs over from one headlight to the other and seeing if the fault follows the suspect bulb) or the actual switch on the steering column has fried it's contacts..which means removing the switch assembly and having it overhauled by a good auto electrician, or replaced with a new switch assembly..then it will be good for another 13 years

Jul 12, 2014 | 2002 Nissan Sentra

1 Answer

Can u plug rear brake line on 1996 nissan sentra


The 1996 Sentra sedan is available in four models - (Base) Sentra, XE, GXE and GLE. The Sentra remaines unchanged. The Sentra features minor updated interior and exterior styling. Safety features include front and rear crumple zones, side impact beams, energy-absorbing steering column, child safety door locks and driver and passenger-side air bags. All models are equipped with five-speed manual transmission, four-wheel independent suspension, bucket seats, cup holders, tilt steering wheel.---------------------------------------------------------------------------------------
D900 CANSCAN OBD2

Mar 28, 2013 | Nissan Sentra Cars & Trucks

1 Answer

How to repair turn signal lever


In order to repair the lever you must replace the turn signal switch, this requires the **** shell covers on the steering column to be removed, they are held on by 4 screws recessed in holes, then the switch is bolted to the steering column tube by two machine screws, do not break the wire connectors to the switch, remove them carefully. Always disconnect the battery negative cable before working on the steering column

Feb 10, 2012 | 1997 Nissan Pathfinder

2 Answers

The 2004 Nissan Sentra I own intermittent wipers don't work. Can anyone tell me how to fix them?


The intermittent function for your wipers is controlled by the wiper control amplifier. This is an integral part of the wiper (combination) switch and is serviced only by replacing the switch assembly.

Nov 26, 2011 | 2004 Nissan Sentra

1 Answer

How do i install Switch Assembly turn signal Cruise control PART AUTO for a 2002 Impala.


Multifunction Turn Signal Lever Replacement - On Vehicle

Removal Procedure

83422682


  1. Verify that the multifunction turn signal lever is in the center of the OFF position.
  2. Disconnect the negative battery cable.
  3. Disable the SIR system.
  4. Remove the steering wheel.
  5. Remove the steering column trim cover.
  6. Remove the steering column knee bolster.
  7. Remove the steering column wire harness (1) from the steering column wire harness retainer (2).
  8. Remove the 2 wire harness straps from the steering column wire harness (1).
  9. Remove the steering column bulkhead connector from the vehicle wire harness.
  10. Disconnect the connectors from the multifunction turn signal lever steering column bulkhead connector.
85097560




  1. Remove the retaining bolts (1) from the multifunction turn signal lever (2).
  2. Remove the multifunction turn signal lever (2) from the steering column.
Installation Procedure

85097560




  1. Install the multifunction turn signal lever (2). Use a small flat-blade in order to compress the electrical contact and move the multifunction turn signal lever into position.
  2. Verify that the electrical contact rests on the canceling cam.
Notice: Refer to Fastener Notice in Service Precaution.


  1. Install the retaining bolts to the multifunction turn signal lever.
    • Tighten the retaining bolts to 7 Nm (62 inch lbs.) .
92905224




  1. Connect the gray and black connectors to the multifunction turn signal lever steering column bulkhead connector.
  2. Connect the steering column bulkhead connector to the vehicle wire harness.
  3. Install the two wire harness straps to the steering column wire harness (1).
  4. Install the steering column wire harness (1) to the steering column wire harness retainer (2).
  5. Install the steering column knee bolster.
  6. Install the steering column trim cover.
  7. Verify that the lever is in the center or the OFF position.
  8. Install the steering wheel to the steering column.
  9. Enable the SIR system.
  10. Connect the negative battery cable.
I hope this helps you.

Thanks

Nov 28, 2010 | 2002 Chevrolet Impala

1 Answer

What does the 00 off light mean on a 1997 nissan sentra gxe mean


Hello winman
I think the light you're refering to may be the OD off light. If this is the case, the on/off button for the electronic overdrive, is on the shift lever
and may have been pushed by accident. Just push the button again
and the overdrive will engage and the light should go out.
Hope this helps.

Jul 18, 2010 | 1997 Nissan Sentra

1 Answer

My dash taillights dont work on my 1997 nissan


Turn on the hazard switch to check if the bulbs light up. If they do, the problem is probably with the headlight switch itself.

Jan 26, 2010 | 1997 Nissan Sentra

2 Answers

1999 nissan sentra gxe headlight problem


do you have the right light bulb? i own a 98 sentre and
it takes a 9004 bulb, but walmarts computer said to use 9007. That made the high beam censor stay on till i replaced it. if you look at the bulb you can tell if it is a dual or single beam bulb.!!!!

Mar 11, 2009 | 1999 Nissan Sentra

1 Answer

1999 nissan sentra gxe headlight problem


I switched one of the new bulbs with a working older bulb, and the problem went away. weird...

Nov 09, 2008 | 1995 Nissan Sentra

Not finding what you are looking for?
1997 Mitsubishi Eclipse Logo

Related Topics:

211 people viewed this question

Ask a Question

Usually answered in minutes!

Top Mitsubishi Experts

yadayada
yadayada

Level 3 Expert

76846 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22246 Answers

Jeffrey Turcotte
Jeffrey Turcotte

Level 3 Expert

8548 Answers

Are you a Mitsubishi Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...