Question about 2003 Ford Escape

Open Question

Need to replace fan blower motor for a 01 ford escape.do i need totake dash off to get to blower motor

Posted by Anonymous on

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

  • 3 Answers

SOURCE: Heater fan only works on high speed 4.

sounds like the switch is bad. Test the power coming in to the connector and use jumpers to get the fan to operate at all 4 speeds. if it works then it the switch.

Posted on Nov 22, 2008

  • 8 Answers

SOURCE: 2000 ford explorer fan blower only works intermittently

On ford vehicles the blower motor resistors are the most common problem when this happens.

Posted on Dec 21, 2008

chuck943
  • 783 Answers

SOURCE: 2006 Ford Explorer XLT the Blower Fan only works on 4 and 3 Sp

Look under the dash on passenger side and just to the left of the blower motor housing you will see the 4WD control module.Remove the 2 screws holding the module and let it hang down and your resistors are behind this.Remove the 2 screws holding the resistors and remove.
Now I am assuming you have manual climate control and not electonic.

Posted on Feb 26, 2009

  • 1 Answer

SOURCE: My blower motor fan speed switch will work only on High.

I had a similar problem with my 03 Taurus. Does your floorboard on the passenger side get wet when it rains really hard? If so, Ford is aware of a defect above the fan motor which is behind the glovebox.
I contacted Ford directly and they had my local ford dealer fix it free and they gave me money towards a new blower motor which shorted out from the leak, it's possible it just your switch if there is no leak but you might need both the switch and blower motor replaced like I did. Hope this helps.

Posted on Apr 14, 2009

  • 288 Answers

SOURCE: 1998 Ford Expedition, 5.4, 4x4 with Air Cond. Blower Motor fan.

check the resistor first .

Posted on Jun 22, 2009

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Why are my cooling fans for radiator running constantly?


The cooling fans are supposed to run any time the a/c is on in order to keep air flowing across the condenser. Your a/c will not work properly at idle if they quit.

Jul 27, 2015 | 2010 Ford Escape

3 Answers

Finding the relay for heat and a/c blower motor


It's called a resistor. Under the dash, on the passenger side. Close to the blower. Usually behind the blower motor. Has five to seven wires going to it.

Jun 16, 2015 | 2005 Ford Escape

1 Answer

Ford escape air conditioning blower problem


replace blower motor under passenger dash or resistor

Sep 10, 2014 | Ford Escape Cars & Trucks

1 Answer

Low speed fan doesn't work


this could be the blower motor resistor with a burnt low fan speed resister wire. its part of the blower motor resistor board which means the complete board needs replacing. this is the most common problem. it could also be the fan switch on the dash.

Aug 06, 2014 | 2006 Ford Taurus

1 Answer

2008 Ford Escape heater blower no longer runs in position 1. Works great in positions 2 thru 4.


It could be the blower resistor. While I'm not familiar with the 2008 Escape, most resistors are located near the blower motor under the dash on the passenger side. It'll have a plug with several wires, and usually 2 screws holding it in.

Aug 07, 2011 | 2008 Ford Escape

2 Answers

01 grand.prix ac fan switch only works on high. has a duel temp controller when you turn fan off the only way fan comes back on is to move the temp controller levers


Hi!!
When the Blower Motor Resistor (controls blower speeds) goes bad, the blower motor works only on HIGH SPEED. REPLACE IT.
BLOWER MOTOR RESISTOR Removal & Installation
  • Disconnect negative battery cable.
  • Remove right lower instrument panel insulator panel.
  • Disconnect blower resistor connector located behind right side of dash.
  • Remove blower resistor screws and blower resistor.
To install, reverse removal procedure
Good Luck!! A HELPFUL - 4 THUMBS - rating for this solution would be greatly appreciated. Thank you for using FixYa!!

Feb 18, 2011 | 2001 Pontiac Grand Prix

1 Answer

Replacing heater fan please advise access to fan motor


the heater blower motor is located under the dash on the passengers side,there's a single plug with two wires that you have to disconnect then there is three bolts to remove and then remove the blower motor, sometimes there a plastic (or carpeted)cover you have to remove first under the dash to gain access to the blower motor .

Dec 30, 2010 | 1999 Ford Escort

1 Answer

Fan motor


The switch in the dash is known to go bad commonly in 01-04 Fords

Sep 03, 2009 | 2002 Ford Taurus

2 Answers

The blower motor on my 2005 ford escape only works on high.


Your blower resister has gone bad .The resister is located under the passenger side of the dash and is not expensive:)

Aug 26, 2009 | 2005 Ford Escape

Not finding what you are looking for?
2003 Ford Escape Logo

Related Topics:

28 people viewed this question

Ask a Question

Usually answered in minutes!

Top Ford Experts

yadayada
yadayada

Level 3 Expert

75197 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22095 Answers

fordexpert

Level 3 Expert

5481 Answers

Are you a Ford Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...