There is an actual liscence plate bracket u can buy at a chrysler dealership thats fits perfectly on bumber it has teeth that perfectly center the bracket right below the grill it looks great i just had one put one on my 2005 300
- If you need clarification, ask it in the comment box above.
- Better answers use proper spelling and grammar.
- Provide details, support with references or personal experience.
Tell us some more! Your answer needs to include more details to help people.You can't post answers that contain an email address.Please enter a valid email address.The email address entered is already associated to an account.Login to postPlease use English characters only.
Tip: The max point reward for answering a question is 15.
Most factory kits come with the hardware to install it will be plastic push ins, bolts with j-nuts, or pointed hex head bolts. The push ins just push in line up the plate holder to the holes in bumper, if bolt and j-nut must slide j-nuts into slots then line up and install, if pointed bolts there are dimples that can be seen in bumper install at dimples, if no dimples just line up and install.
The fuse labeled REAR PARK LP 15A in the right instrument panel fuse box powers the rear park lamps, and the tag lamps. If your rear park lamps are working then you most likely need to replace the tag lamps (bulbs). Use the following procedure to replace the lamps.
Remove the two mounting screws from the license plate lamp.
Remove the license plate lamp from the rear bumper fascia.
Remove the license plate lamp socket by turning it counterclockwise.
Install the license plate lamp socket by turning it clockwise.
Position the license plate lamp to the rear bumper fascia.
You will have to install an after market license plate holder, as Mitsubishi Eclipse spyder does not have a front plate holder. Where you install it on your bumper is up to you , but remember to follow your local laws in regards to placement and the proper amount of screws holding the plate.
for a simple item like that, get it from a local scrapyard. Holes are already where they need to be as it would actually be very expensive to make "special runs" of bumpers for areas that don't use front plates. (same goes for wiring harnesses...they are made with plugs for all options and whatever does not get ordered is just not plugged in. Shouldn't cost you more than $5.00!!!