Question about 1986 Toyota Pickup 4WD

1 Answer

1986 toyota pickup horn malfunction

The horn does not work. The fuse is ok. the same fuse protects both the horn and emergency flashers. the flashers work fine. I cannot hear any clicking noise for the horn's relay. Where is the horn's relay?

Thanks
Will

Posted by on

  • 1 more comment 
  • wrbpilot Oct 24, 2008

    Good Day Thafa!!!!

    Thanks for the advice. I did disconnect the horn and used a multimeter for a few tests. I tested the voltage at the end of the wires connected to the horn and got a reading of +- 29 volts. I used the continuity tester on the horn itself and got a "short" alert, less than 50 ohms. A resistance test showed -+ 2ohms. I think this means new horn time but I am a real amateur when it comes to auto electrical systems and would really appreciate your insight on these tests.
    Thanks in advance

    Will Brown


  • wrbpilot Oct 24, 2008

    Wow, that was the best $10.00 I have spent on car repair in a long long time.
    Thanks again for a quick and helpful response

    Will Brown

  • Anonymous Mar 14, 2014

    the horn relay just clicks horn does not work

×

1 Answer

  • Level 2:

    An expert who has achieved level 2 by getting 100 points

    MVP:

    An expert that gotĀ 5 achievements.

    Sergeant:

    An expert that hasĀ over 500 points.

    Champion:

    An expert who has answered 200 questions.

  • Expert
  • 200 Answers

Hi

Check whether power is coming to horn.

if ok means then check the horn

thank you

Posted on Oct 22, 2008

  • 1 more comment 
  • Thafa Oct 24, 2008

    Hi

    Thank you Mr. Will Brown this our duty to say solution for ur problems once again i say thank you Brown. Have a nice day..




  • Thafa Oct 24, 2008

    Hi

    Change the horn.. Mr.Brown

    thank you


  • Thafa Oct 24, 2008

    Hi Brown

    Thanks once again this our job have good day Mr.Brown...


×

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

The horn does not work on the 1986 Toyota pickup - what can I do?


Start with the fuse. If good, then check the wire. It is a single brown wire, horn is grounded at it's attachment point to the body, between the front grille and radiator on the driver's side. Starting there is easiest. Use a test light at the connector clip while pushing the horn button. If the circuit is good, but no sound, you need a new horn. Often times, wear and tear will cause the clip to fall off the blade contact. If the circuit is no good, pull the center plug from the steering wheel and check the circular contact ring and tab. The ring can build up gunk and also wear through, then not make proper contact with the horn button contact tab.

Jun 07, 2014 | 1986 Toyota Pickup 4WD

1 Answer

1986 oldsmobile cutlass turn signal not working anymore...emergency flashers work brake lights work just not turn signals


OMG. Someone with a car older than my '87 toyota. Possibly a bad switch, but first locate your turn flasher, maybe that is bad, easier to try than another switch. Turns should have a fuse, too. check that.

Oct 30, 2011 | 1986 Oldsmobile Cutlass Supreme

1 Answer

Turn signals wont work bulbs ok dont have a manual to the car dont know wich fuse goes to the turn signals


pickup a test light and check all the fuse if the fuses are good then you probably have a bad signal flasher.make sure you change the signal flasher and not the emergency flasher as they look the same.

Jul 30, 2011 | 1995 Ford Mustang

1 Answer

My turn signals are NOT working, but emergency flashers are. Any ideas? They just went out today-- wondering if it's 1/ fuse 2/ turn signal relay or...?


Check for the FLASHER. For 1991 Toyota Truck Pickup 4WD (4 cyl) 2.4L FI 4cyl the Flasher is located front seating area, driver side, under dash, mounted driver side of steering column.

Hope this helps.

Feb 03, 2011 | 1991 Toyota Pickup

1 Answer

The manuel to the truck is ate up by rats and we cant find the fuse or relay to the horn????


There are three fuse boxes in the pick-up,One is located in the engine compartment,and one at the drivers side kick panel, and the last one is located behind the glove box.Each fuse box has the fuse numbers and circuits protected on the lid of the box.Good Luck.

Dec 08, 2010 | 1986 Toyota Pickup 4WD

1 Answer

2001 Toyota Sienna-no turn signals, fuse ok, emerg flashers ok.


The flasher relay is under the driver side dash down near the pedals. If you lie on your back and slide under there you'll see it right away.

Sep 13, 2009 | 2008 Toyota Sienna

3 Answers

86 toyota pickup fuse box diagram


When I use my turn signal in my 1986 toyota pickup every 5-6 uses it blows the fuse and my blinkers, backup lights, gas gauge and temp gauge stop working. What is going on

Jan 07, 2009 | 1986 Toyota Pickup 4WD

1 Answer

1994 toyota pickup turn signals blowing fuses


it could be the turn switch, and or a lose contact, or as well bulb seating is having problem,and check the wiring system

Dec 12, 2008 | 1994 Toyota Camry

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

1,196 people viewed this question

Ask a Question

Usually answered in minutes!

Top Toyota Experts

yadayada
yadayada

Level 3 Expert

60867 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

21949 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

6811 Answers

Are you a Toyota Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...