Question about Honda CR-V

1 Answer

I was putting gas from a gas can in my Honda CRV 2001 and the plastic nozzle on the gas can popped off and fell into my gas tank.

Posted by on

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

    President:

    An expert whose answer got voted for 500 times.

  • Master
  • 1,450 Answers

This should not cause you any problems it will just float around in tank. you can try and pull off filler neck to remove it may not have gone in tank.

Posted on Oct 22, 2008

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

2 Answers

Plastic object falling into gas tank while re-fueling


Yes it was just the top of the gas can so yeah it can be done cheaply basically all they will have to do is drain the gas and fuel injection and get it out of there, take it to your dealer or shop for more.

Jun 10, 2012 | 2004 Lexus RX 330

1 Answer

When pumping gas, the pump pops and shuts off like tank is full. It does this the hole time I am trying to fill the tank.


on the nozzle of the dispensers there is a safety kick off, this will activate whenever gas splashes back into the nozzle. there are two ways to make this not happen, the first is back the nozzle out so it does not have gas splashing back into the nozzle or find another gas station that have different nozzles.

Oct 13, 2010 | Hyundai Motor 2003 Elantra

2 Answers

How do your replace the clock bulb on the CRV 2001


There is no bulb for the 96-01 CRV clock, it is LCD based. If the fuses are OK (radio working etc) then the clock module is defective. I offer an affordable repair solution, check out www.autoclockrepair.com. I have removal instructions there as well.

Jun 20, 2010 | 2001 Honda CR-V

2 Answers

I cannot put gas into the tank of my 98 honda accord. it backs up. I think it is the flap in the tube. Could sugar have caused this


sugar in tank goes to bottom and clogs the rest of the fuel system. If you are thinking sugar...... than it's possible that someone could have put anything in the filler to block it

Oct 17, 2009 | 1997 Honda Accord

1 Answer

2003 GMC Jimmy 4x4 Cannot put gas in the the tank


Same problem yesterday on my Dad's Jimmy. Left my brother in law stranded cause they couldn't put gas in it. There is a pressure purge valve next to the tank that is supposed to release the pressure on the tank when the engine is shut down. These often fail in Jimmy's and Blazer's and because the tank is still pressurized, the antisiphon valve doesn't open up and this keeps you from putting gas in the tank. You need to replace the part.

Aug 01, 2009 | 2001 GMC Jimmy

2 Answers

I can't put gas in my car without the pump shutting off every five seconds. I think the metal flap where you put the gas pump into the car fell into the line. what can i do to get it out?


On most modern gas pumps there is a sensor in the tip of the nozzle. When it feels to much pressure or liquid it shuts the pump off. When you are filling your tank you need to leave a little room for air to come out. Try to not put the nozzle in as far and see if that will work. You will only need to leave a little bit of room. Hope it helps!

Jun 21, 2009 | 2003 Toyota Corolla

2 Answers

How to change a fuse in a 2001 honda crv


find the blown fuse, pull it out and pop a new one in with same rating, never use a higher rated fuse its a good way to have a car fire

Jun 18, 2009 | 2001 Honda Civic

2 Answers

2001 honda crv


start your cr-v and let idle for 10 or so seconds in park. shut it off and check the fluid with in 30 seconds. if you check the fluid running it will read low and get overfilled. level ground is also important.

Dec 31, 2008 | 2001 Honda CR-V

2 Answers

Spitting gas out


i think i can help you with that my sportage has done the same thing to me. but you ethier have air in ur gas tank due to not tighting the cap all the way and driving it on anyhting under than a full tank, and the second thing might be the little metal flap in the to of the tube may be bent or not sealing all the way.

Jun 13, 2008 | 2001 Kia Sportage

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

124 people viewed this question

Ask a Question

Usually answered in minutes!

Top Honda Experts

yadayada
yadayada

Level 3 Expert

61037 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

21949 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

6812 Answers

Are you a Honda Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...