Question about 2000 Renault Sportwagon

1 Answer

Renault extra petrol 1986 - no power at starter motor

Van was turning over just about to start then cut out and 1 x 5 amp fuse blown from ? 2nd from drivers side on fuse box and now replaced.

No power to starter motor at all

Posted by on

  • myad51 May 11, 2010

    Do the wire to the solonoid have a fusible link that could have blown.

×

1 Answer

  • Level 1:

    An expert who has achieved level 1.

    Problem Solver:

    An expert who has answered 5 questions.

  • Contributor
  • 5 Answers

Sounds like maybe your starter fried???

Posted on Dec 08, 2008

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

3 Answers

I checked all the fuses. No fuses are blown. The battery is fully charged & the electrical, lights, & radio all work fine. The 2004 Toyota Sienna van still doesn't even turn


Can be a bad contact in one of the cables. A bad contact in a switch or electronic switch. a bad relay, and a dozen other causes.
Please start measuring to where the power comes and where it stops. You are close to the car, we are not. For a correct diagnose use a multimeter and look under the hood.

Nov 20, 2014 | 2004 Toyota Sienna

Tip

My car starter motor does not turn over.


Hi.

If you do not have any power at all, and the dash is not turning on, then check the battery connections, and the connection from battery ground to the engine body.
Also ensure you have tested the battery. Read the voltage across the positive battery terminal and a ground connection on the engine body. It must be around 12.5V
If there is no problem in there , then the problem is the ignition cylinder. The ignition cylinder can be tested reading voltages at its contacts. This in case there is no power at all.

If instead the dash is turning on, but the starter motor does not turn over, then there may be more reasons for the fault.

To start, look for the starter fuse. This is a large fuse, probably a 30 Amps. Look also for a5 or 10 Amp fuse to the ECU/PCM (main car computer module. If any of this fuses has blown, it can cut power to the starter motor.

After testing the fuses, check the starter relay. This is usually located in the fusepanel under the hood, or under the dash. The relay must click when the key is turned. The relay can be tested in fullusing a Volt meter or an Ohm meter.
The starter relay can also be tested swapping it with a relay of the same kind.

Fuses and starter relay are the most common failure when the car dash comes on, but the car does not start.
If this test good, ensure that the anti theft system is not armed (starter should still turn over by the way).

If fuses and relay are good, read volts at starter motor, while machineis cranking. You will need to use Voltmeter on the contacts at theback of the starter motor solenoid. If there are 12 Volts at startermotor, but motor does not turn over, then starter motor or startersolenoid is faulty.

The starter solenoid can be tested using an Ohmmeter at its contact. Ifthe solenoid is bad, reading with multimeter set on impedance, it willhave no continuity (it will read infinite Ohms).

If there is no volt, or volt is much below 12 Volts, then the problemis either the ignition switch located in the steering column, or aproblem concerning wiring from ignition.

The ignition switch can be tested jumping its contact, reading Volts orOhms on its terminals. To access the switch it is necessary to takeapart the steering column.



Regards.



on Mar 25, 2010 | Ford Focus Cars & Trucks

2 Answers

I have a 2004 dodge stratus that has power to lights but does not turn over when i try to crank even after jumping it off.


Hi.

Check ignition switch fuse. This is a 20 Amps. see that it has not blown. In 2004 Fuse should be nr 8 in the power box under the hood (newer models #24).

Once you are sure that battery, fuse and wires are OK, check starter and ignition switch. Check if there is 12V to starter while cranking. If there is power and the starter motor does not turn, then the motor is gone.
If there is no power to starter motor when you crank, then the ignition switch located inside the steering column may need replacement. Before repairing, try reading error codes with a code scanner.

Apr 15, 2011 | 2004 Dodge Stratus

3 Answers

Renault Megane Scenic 1.6 petrol jerking in 1st & 2nd.


check hoses for splits...i had the same problem.

Jan 29, 2010 | 2000 Renault Sportwagon

2 Answers

Renault master van will not start with the key it turns over ok but will not start but it will start with a tow i leave it running for 5 mins it cuts out again


Renault master van will not start with the key it turns over but will not start it will start if i take earth lead off for 5 mins runs for 5 mins and cuts out again.

Jan 08, 2010 | 2002 Renault Sportwagon

1 Answer

My 1996 Ford Windstar Will Not Start....


Take all the fuses out and check them one by one and re install them and replace the blown fuse .
Tap on the relays to unstuck them .
Clean the batery terminals with sand paper .
Check the rear light and brake bulbs and sockets.
Vitally

Sep 03, 2009 | 1996 Ford Windstar

2 Answers

2001 Chrysler Sebring--'no start' and no sound when turn over key


There's a fuse under the hood. It's the relay/ABS fuse (20 amps). You have to pull it out to see if it's blown out. If I remeber correctly, it,s the 3rd or 4th fuse down in the 2nd column of fuses. This supplies power to the relays that control the starter, fuel system, AC, and others.

May 27, 2009 | 2001 Chrysler Sebring

5 Answers

Renault traffic 03 1.9dci low power until turbo cuts in and wont rev past 3800rpm in any gear also occasionaly cuts out with engine management/glow light on no faults on diagnostics


my trafic did the same.no power pulling away until the turbo kicked in and it turned out to be the airflow meter.Hope this helps as it cured mine.Plus non of them rev past 3800 revs its normal.

Feb 28, 2009 | 2006 Renault 181

2 Answers

Hiace van 2006 petrol engine not starting


check the ECU fuse and the efi fuse if the fuse is blown replace with the same rating and then attempt to start and also note if the mil comes on iyou have mil on then the vehicle is bound to start.

Nov 24, 2008 | Toyota Prius Cars & Trucks

1 Answer

Renault Trafic 1,9 dci 2002


check other fuses and relays and re set fuel cut off switch

Jul 10, 2008 | 2002 Renault Sportwagon

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

161 people viewed this question

Ask a Question

Usually answered in minutes!

Top Renault Experts

Colin Stickland
Colin Stickland

Level 3 Expert

21981 Answers

xxxxxx xxx

Level 3 Expert

4724 Answers

yadayada
yadayada

Level 3 Expert

63661 Answers

Are you a Renault Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...