Question about 1995 Pontiac Bonneville

1 Answer

Fog lamps will not come on when i turn the headlights on.checked all the fuses,bulbs look good,wires and connecters seem ok.is there a seperate switch i do not know about?

Posted by on

  • brad_70 Oct 23, 2008

    thanx for the tip! for future reference the on/off switch is located on the headlight pull switch and foglights will only come on when headlamps are on and then turning the dial to the right.something so simple had me busier than a cat trying to bury **** on a frozen lake.once again thanks!!

  • Anonymous Apr 21, 2009

    i have the same poblem to

×

1 Answer

  • Level 1:

    An expert who has achieved level 1.

    Hot-Shot:

    An expert who has answered 20 questions.

    Corporal:

    An expert that hasĀ over 10 points.

    Problem Solver:

    An expert who has answered 5 questions.

  • Contributor
  • 26 Answers

Idk about on your car, but usually there is a seperate switch, try pulling out on the headlamt turn dile, other than that just look for switches around the dash area

Posted on Oct 22, 2008

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Fog lamps on 2004 Tahoe won't come on.


You need to check the bulbs.These are known to go out a lot.Also you can check that you have power to the lights with a test light.Sounds like a bulb or wiring problem.I have had a few of these that are broken off because they are so close to the ground.Depending on if your four wheeling or in snow country.Hope this helps.Good luck.

Feb 16, 2012 | Chevrolet Tahoe Cars & Trucks

11 Answers

Drivers side headlight works only in highbeam while the passenger side light doesnot work at all on my 96 honda odyssey,what seems to be the problem?


I agree, first start with bulbs, and sockets...be sure to clean sockets (corrosion) spray with PB Blaster to clean as necessary...use bulb grease when re-installing...ALSO be sure not to touch finger sweat on bulbs...this always shortens the bulb life...Hope this helps.

Oct 06, 2011 | 1996 Honda Odyssey

1 Answer

Passenger side head lamp and fog lamp not working.I have changed the headlight bulb and checked the bulb and its ok,but the headlight still does not work


check the fuse box may be a fuse broke if not check the wires and conections see if everything is ok and if still not working bring the car to an electrician

Jan 12, 2011 | Chrysler PT Cruiser Cars & Trucks

1 Answer

I need a detailed instructions on how to connect a toogle switch to a fuceable link to a battery and to a halogin headlight bulb?


Ok there are 2 ways todo this ,, the first is the easiest but not the cleanest..

First ..
1.) connect 8 guage wire from postive battery terminal to (2 port fuse holder)..
2.) from each of the fuse in the holder connect to the positive lead of each bulb (which should be in the bulb holder and in the headlamps or fogs or whatever).
3.) connect negative to a bolt on cars body.. Lamps will come on..
4.) remove positive from battery terminal..
5.) connect to your spst switch (what ever kind of switch u are using.)
6.) mount switch inside car,
7.) connect wire from other lead of switch to battery terminal..(pos)
Switch the lamps on and off using the switch..

Second method..

you will need
2 4-pin relays
8 guage wire
tester

1.) remove connectors from both head lamps
2.) turn on head lamps and test to see which is positive on each
3.) bridge this wire to the Com on the relay .. (1 head lamp to 1 relay)
connect positve wire from battery termial to relay (each relay seperate wire)
connect negative wire from cars body to relay (each relay seperate wire)
4.) connect Out from relay to Positive on Halogen bulb
6.) connect negative from bulb to cars body

now the lamps will come on and off with the head lamp switch..

Alternatively you can connect the fuse holder to the battery, and connect a switch to that and then that to the positive in on the relay..

Sorry I dont have any diagrams didnt have the time to draw one,, answered this quickly this morning before work..

Sep 08, 2010 | Lincoln Mark VIII Cars & Trucks

2 Answers

How do you change the headlight bulb on 1996 olds delta 88? I cannot get to the bulb assembly.



REMOVAL & INSTALLATION

See Figures 1, 2, 3 and 4
  1. Disconnect the negative battery cable.
  2. Remove the fog lamp-to-bumper assembly retaining screws. Be careful not to disturb the adjusting screw.



0900c152800b1fa2.jpg enlarge_icon.gifenlarge_tooltip.gif Fig. Fig. 1: Unfasten the 2 Torx® fog light retaining screws (1), making sure not to disturb the adjusting screw (2)
  1. Squeeze the bulb and socket assembly retaining clip prongs inward, and pull the bulb and socket from the rear of the fog lamp.



0900c152800b1fa3.jpg enlarge_icon.gifenlarge_tooltip.gif Fig. Fig. 2: Squeeze the bulb and socket retaining clip prongs inward ...


0900c152800b1fa4.jpg enlarge_icon.gifenlarge_tooltip.gif Fig. Fig. 3: ... then pull the bulb from the rear of the fog lamp
  1. Unplug the fog lamp electrical connector.



0900c152800b1fa5.jpg enlarge_icon.gifenlarge_tooltip.gif Fig. Fig. 4: Unfasten the fog lamp electrical connector
  1. Install the assembly, retaining bolts and connect the negative battery cable.


AIMING

  1. Park the car on a level surface, at least 25 ft. (7.6m) from a wall that is perpendicular to the ground surface. Make sure there is no excess weight in the trunk, unless you normally travel with that amount of weight in the car. Bounce the car a few times to settle the suspension.
  2. Measure and record the distance from the ground to the center of each fog light lens.
  3. Turn the fog lights on and adjust so the hot-spots (lit area of most concentrated intensity) are 4 in. (10cm) below the height of the lenses. The ADJUSTING screw is located at the top right corner of the fog light.

Jan 25, 2010 | 1996 Oldsmobile 88

1 Answer

How do I turn On fog Lights?


LOOK ON SWITCH TO TURN ON HEADLIGHTS..IF THEY ARE FACTORY FOG LAMPS,PULL OUT ON END OF HEADLIGHT SWITCH..IF NOT FACTORY,CHECK FOR A SEPERATE SWITCH,OR THEY MAY NOT BE WIRED UP

May 31, 2009 | 2006 Chrysler Sebring

1 Answer

Hyundai Sonata 2003 FOG LIGHTS DONT WORL


No.. power is supplied to both bulbs in parallell... when power is present at one, it's also present at the other. Clarification needed - have you checked to see if you have power (battery voltage) and ground at the fog lamp connectors?.. if so, the problem is the bulb(s) it/them/self/selves. If you have an ohm meter or a test light, it's a simple procedure. Check the bulbs with an ohm meter. Then using a test light (12 volt, make sure the test light bulb is good by connecting it to a charges 12 v battery) connect the test light bulb to each of the fog lamp connectors with the fog lamp sw turned on and the ignition key in the 'run' position. If the test light illuminates at both fog lamp connectors, then the problem is in the fog lamp bulb(s) themselves. If not, there's a wiring/control circuit problem. You can go to http://www.hmaservice.com/ and register and gain access to lots and lots of technical info about your Sonata.

May 26, 2009 | Hyundai Sonata Cars & Trucks

1 Answer

Fog lamps won't turn on


OK, you will need to first check the fog light wiring harness. make sure there are no worn wire lines or connections, replace if you see noticeable flaws in the wiring harness. Next, check the clip that fits over the back side of the fog light bulbs. Make sure that the inside copper pins are in good condition and, the the fit is tight. replace the wiring harness if these clips are worn or not fitting properly.

If the above inspections show no apparent wiring harness issues, you will then need to check for bulb failure. make sure that your fog light bulbs are operational. if the bulbs are ok, replace the switch.

Please rata and have a great day:)

May 20, 2009 | 2008 Chevrolet Malibu

3 Answers

Ford expedition yr'00 headlight not working checked fuses..


The low beam headlamps have a seperate fuse for each lamp in the central or underdash fuse panel.
The right headlamp is fuse fuse 26 (10amp) and the left is fuse 28 (10 amp). These fuse are hot only when headlamps are on so you need to test them with a test light with headlamps on. If they do not have power to them then concern is either headlamp switch or daytime running lamp relay if your vehicle is equipped with this feature, or a bad multifunction switch.
Power leaves the headlamp switch on the RD/YE wire and goes to multifunction switch. It leaves multifunction switch on the other RD/YE wire The wire will then go thru either a connector c2003 located behind the passenger side air bag behind the dash or to the DRL relay if your vehicle has this feature and leaves there on RD/BK wire to the headlights .

Feb 24, 2009 | 2000 Ford Expedition

1 Answer

Fog lights don't come on


DID YOU TURN ON THE HEADLIGHTS, AND THEN ~~PULL~~ OUT THE HEADLIGHT SWITCH? THAT IS THE ONLY TIME THAT THEY WILL WORK. WHEN YOU TURN OFF YOUR HEADLIGHTS, THEY GO OFF AS WELL, AND WILL NOT TURN ON THE NEXT TIME UNLESS YOU, AGAIN, ~PULL~ THE SWITCH. HOPE THAT HELPS!

Nov 18, 2008 | 2008 Dodge Caliber

Not finding what you are looking for?
1995 Pontiac Bonneville Logo

Related Topics:

52 people viewed this question

Ask a Question

Usually answered in minutes!

Top Pontiac Experts

yadayada
yadayada

Level 3 Expert

70346 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22041 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

6869 Answers

Are you a Pontiac Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...