Putting on a convertible top

Definitely want to stay away from the dealer. Might try a respectable garage mechanic and ask him kindly how to go about it. If they know anything about it, I'm sure they can give you advise. You could also purchase a repair manual for the car, this will come in handy when your next problem comes along also. Manuals are around 10-20 bucks and well worth the money.

Duplicate question

my 0 8 mitsubishi eclispse spyder was hot wired went i got back
my top will not open check fuse

All three wire showing 3 it should be all 4 wires, In the back of the rear seat is the convertable top module, the yelloow black wire should go ground to bring it down.Other than that a new module will be needed,this gets its command from the window main switch so see if yellow/black wire switches over

MITSUBISHI ECLIPSE ECLIPSE SPYDER SERVICE REPAIR MANUAL 2000 2001 2002... Repair your vehicle right away. Just click on the link I attached

te stops may have to be adjusted but must be done professionally or window can hit top when shutting the door . Also inspect the seal .

in the exhaust , behind the catalytic converter.
autodoc

Brought the car to my Mitsu dealer.

There is a switch located just above the left rear brake light, peal bake the trunk liner and you will see it. It says manual/auto, switch it back to auto and the top should work. You probably just bumped it as my brother in law did, no convertible for over a year...good thing he lives in Seattle.

There are 7 screws all together to remove the door pannel. First, you have to take off the hanlde for the door. the 2 plastic covers on the handle pop off revealing 2 screws on the top and bottom, remove those. then behind the the door handle on the inside, pull it as if you were to open it and there is a screw that you have to remove. Then there are 2 screws on either side of the door pannel, both are farily close to the top, remove those, and then its just a matter of popping the pannel off. start from the bottom, pop it off then slide it up. becarefull, after the door panel is free, there is a connection for the power doors and windows unhook that then the pannel will be free. after that the speaker will be right there and its common sense on removing that. good luck.