Question about 2001 Chrysler Sebring

1 Answer

1996 sebring convertible will not start

My car will not start. The lights, a/c, windows will work. When I turn the key in the ignition, there is nothing. There is a new battery.

Posted by on

  • 1 more comment 
  • prpl77 Jan 09, 2009

    I'm having a similar problem with a 1996 Sebring convertible.The car was running fine, then one day it wouldn't start- engine wouldn't even turn over.A friend found that my ignition fuse was blown and replaced it.That seemed to fix the problem for about 6 months.Then, one day I go out to start the car ,and nothing.So, I bought a packet of fuses and blew 3 as soon as I would turn the key. I had the car towed to a Chrysler dealer, where they replaced the fuse yet again, and it started right up.They kept the car 4 days, periodically restarting the car, and checking the electrical system. They found nothing wrong electrically, and the car started right up every time. So, I go pick up the car, drive home no problem. Two days later I go out to start the car, and once again it blows fuses as soon as I turn the key.Also, I've noticed when this happens I dont' seem to have any power at all.Lights, heater,electric windows, - everything is dead.Can somebody tell me if I need to check anything differently since it's blowing fuses, or does it sound like it could be the same problem as above ? Thanks for any and all suggestions, as I'm about ready to pull my hair out !

  • juju_k38 Jan 12, 2009

    after replacing the battery the car ran good for about a week. then one morning it would not do anything. the lighys, radio and everything worked, but nothing happened when you tried to start it. where is the ignition fuse located

  • Anonymous Mar 31, 2014

    when turning key to start the car nothing working no lights or turnover

×

1 Answer

  • Level 2:

    An expert who has achieved level 2 by getting 100 points

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

    Sergeant:

    An expert that has over 500 points.

  • Expert
  • 359 Answers

Your starter sylinoid is most likely toast. Unfortunately most of the time you need to replace the entire starter nowadays to remedy this situation.

Replace your starter, or you may have corrosion on your battery cables.

Posted on Oct 21, 2008

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

2 Answers

Windshield wipers stop working when the defroster is on


The only thing they have in common is the ignition switch.

Dec 18, 2015 | 2007 Chrysler Sebring Sedan

1 Answer

Car alarm preventing car from starting


Try removing the alarm system relay, some car alarm has also a fuse on the alarm that you can remove.
Many car alarms unlock by inserting and turning car key while you connect the battery.

Aug 19, 2008 | 1998 Chrysler Sebring

1 Answer

I have a 1996 sebring convertible. I do not have the remote. The anit-theft system turned on one day and began alarming when opened door---car would start then turn off. Disconnected battery and...


You can try putting everything back as it was, then lock and unlock the driver's door with the key.
Otherwise you may have to visit the dealer.

Feb 28, 2014 | 1996 Chrysler Sebring

1 Answer

1996 chrysler sebring convertible....sometimes when we turn key on the car starts but no power to windows,radio,top..


its most likely a wiring issue or fuse, check your fuses to see if there is a one that corroded or has a bad connection.

Mar 29, 2012 | 1996 Chrysler Sebring

1 Answer

I have a 1996 Sebring Convertible that ran perfect one day and the next day wouldn't start. It is getting fuel, the battery turns it over fine and if I shoot Starting Fluid into the air intake, it will...


There's a computer controlled circuit that will kill fuel pressure on some cars right at the last inlet valve at the fuel rail.A bad key or ignition can cause this. don-ohio

Aug 26, 2011 | 1995 Chrysler Sebring

2 Answers

After my recent Oil Change my Chrysler Seabring 2008 Seabring Convertible gives me a Change Oil Message each time I start the engine.


TRY RESETTING OIL CHANGELIGHT BY TURNING THE IGNITION SWITCH TO THE ON POSITION WITH ENGINE OFF.TURN IGNITION SWITCH ON 10 SECONDS PUMP ACCELRATOR SLOWLY 3 TIMES .UNTIL OIL CHANGE LIGHT FLASHES THEN IT HAS RESET.

Oct 18, 2010 | 2008 Chrysler Sebring

1 Answer

I have 1996 sebring my key is stuck in the ignition


first thing to try would be to remove car from park to a gear and then put firmly back into park...... then retry,
if doin that a few times dont work, you will prob need to replace the ignition cylinder....... make sure it appears gear selector levers parts are all in their place,, visually that is

Jan 22, 2010 | 1996 Chrysler Sebring

1 Answer

Diagnostic Troubleshooting Codes for 1996 Chrysler Sebring Cvtble


FIRST YOU TURN IGNITION SWITCH ON WITH ENGINE OFF.LOOK AT MIL LIGHT IT SHOULD COME ON 3 SECONDS THEN GO OFF IT NOT THEN YOU GOT BURN OUT BULB OR A CIRCUIT PROBLEM.IF ALL IS WELL. ATTEMPT TO START ENGINE.TURN OFF IGNITION. WITH OUT STARTING ENGINE.TURN IGNITION ON OFF ON OFF AND WITHIN 5 SECONDS RECORD 2 DIGIT DIAGNOSTIC TROUBLE CODES.DISPLAYED BY FLASHING MIL LIGHT.YOUR MIL FLASHES WILL BE YOUR CODE LIKE THE MIL LIGHT FLASHES 5 TIMES THEN PAUSE FLASHES 3 TIMES THAT CODE 53 THAT YOUR CODE.IT LIKE MORSE CODE.WHEN DONE TURN OFF IGNITION SWITCH.GO TO AUTO ZONE OR ADVANCE AUTO GET HAYNES COMPUTER CODE BOOK. TO GET CODE MEANING OR WHAT SENSOR GONE BAD.HOPE THIS CAN BE SOME HELP.

Jul 27, 2009 | 1996 Chrysler Sebring

Not finding what you are looking for?
2001 Chrysler Sebring Logo

442 people viewed this question

Ask a Question

Usually answered in minutes!

Top Chrysler Experts

yadayada
yadayada

Level 3 Expert

63661 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

21981 Answers

chargerhp
chargerhp

Level 3 Expert

813 Answers

Are you a Chrysler Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...