So I just bought myself a Xb and it seems the only problem so far has been with the locks on the doors.
My main problem is with my back passenger side door, it seems like it has child lock on it, but I fiddled with the child lock latch and had no changed result. Is it broken? the CL latch won't move. When you lock the door, you can hear it locking, but when you unlock it, there's no sound.
Also, sometimes when I hit the lock all doors button (I don't have an alarm) it locks all doors multiple times, sometimes 3 or 4 times it clicks. Is it just a weird malfunction? Am I worried about nothing?
- If you need clarification, ask it in the comment box above.
- Better answers use proper spelling and grammar.
- Provide details, support with references or personal experience.
Tell us some more! Your answer needs to include more details to help people.You can't post answers that contain an email address.Please enter a valid email address.The email address entered is already associated to an account.Login to postPlease use English characters only.
Tip: The max point reward for answering a question is 15.
the gear is stripped in the lock transmission the electronic lock needs to be replaced. you might be able to find the removal by googling the year and make of the car and door lock removal, if that doesn't work go to www.alldatadiy.com they will have detailed instructions for any repair you might make. costs a little money but by far the best repair manual out there.
I just bought a 1999 Suburban and all of the door lock actuators were bad including the rear (barn style door) while I was replacing the rear door acuator I noticed that even with the factory mounting bracket on the actuator it was causing the door lock rod (the rod from the keyed cylinder lock to the actuator) was on a bind......the solution I came up with is adding an additional 3/4" spacer between the factory mount bracket and the door attach point. this solved any binding and the door lock works great now........also I used a lubricant on all the doors where the rods run through the plastic guides, which seemed to help quite a bit! Hope this help's.
I had that issue with my scion xb. When I installed my audio system somehow the vibrations loosened the button wires clip . I removed the door panel and clicked it back in, also it could be a dead solenoid or disconnected door wire that goes from the 'noid to the door lock pin.
I have recently had this problem I believe this to has been caused by a fault in the drivers door lock assembly It seems this contains the remote receiver. In my case I think there had been some radio interference being the main cause. The remote system seems to be working OK, The door lock will still not operate with the key. Remove and replace the fuse 25 resetting the ignition module. Starting the engine, switch off remove the key from the ignition, stay in the car lock the doors using the door button, press and hold the remote unlock button for approx 5 seconds, listen to see if you can hear the clicking of the door receiver when you press the remote buttons. Press and hold lock/unlock button. You may be lucky.