Question about 1999 Jeep Grand Cherokee

2 Answers

Check engine light on and clunking going into first gear not going to second

On way home my 99 jgc started to clunk while changing gear then check engine light came on, doesn't go into second gear just runs at 2500rpms

Posted by on

  • get_r_done12 Oct 21, 2008

    thank you for your help, I'm not a tech will this cost me big time?

  • dtalley1977 Oct 22, 2008

    just got my jeep out the shop because it would cut off sometimes when i came to a stop light or stop sign. however it would start right back up with no problems. now it stays in first gear and won't change into second. what is the problem

×

Ad

2 Answers

  • Level 1:

    An expert who has achieved level 1.

    Problem Solver:

    An expert who has answered 5 questions.

  • Contributor
  • 7 Answers

Check output speed sensor located on the bottom of the driver side u should be able to see it one's an input at the front and the other an output at the back.

Posted on Nov 26, 2008

Ad
  • Level 1:

    An expert who has achieved level 1.

    Corporal:

    An expert that hasĀ over 10 points.

    Mayor:

    An expert whose answer gotĀ voted for 2 times.

    Problem Solver:

    An expert who has answered 5 questions.

  • Contributor
  • 13 Answers

Your syncros are going out. Try matching revs and you might get it into each gear okay, but get them checked. They'll be in the top of the tranny.

Posted on Oct 21, 2008

  • Andrew
    Andrew Oct 24, 2008

    It can. Take it into a reliable but cheap shop. I tend to find the best rates are at the guys who don't specialize and are in backwater shops. They get a bad rap as not reputable but those of us who frequent them know otherwise. They're often great deals. Stay away from transmission specialists and dealerships for sure.

×

Ad

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya Mechanic can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repair professionals here in the US.
click here to Talk to a Mechanic (only for users in the US for now) and get all the help you need.
Goodluck!

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

1992 toyota corolla gearbox clunking when changing gears


clutch not fully disengaging
air in the system /problem master cylinder or clutch cable failing

Aug 23, 2017 | Toyota Corolla Cars & Trucks

1 Answer

After sitting in garage unused for 2 weeks 2008 gmc sierra 2wd starts fine, but ABS light stays on, in D clunks into gear then check engine light came on. 18000 miles. had no issues when parked


That is really low mileage for issues but clunking into gear is a symptom of a bad universal joint on your drive shaft. Does it clunk in D and R?

Nov 26, 2011 | 2008 GMC Sierra 1500 2WD

2 Answers

2005 Dodge Grand Caravan 3.3L, hear clunking near right side of vehicle while in drivers seat facing forward. More pronounced over bumps, large or small as if something is not mated properly or...


check the stabilizer bar bushings and the stabilizer bar links. They are very common to wear out and cause clunks over bumps. In an open area and just barely moving turn the wheel to the left and right fast and far enough to get the whole vehicle rocking back and forth. If you hear it under these conditions than it is 99% of the time either the links or the bushings.

Nov 15, 2010 | 2002 Dodge Grand Caravan

2 Answers

2000 GMC Jimmy SLT 4wd, 65k miles, baby'd, driven


bad transmission, it will need rebuilding or replacement. sorry....hopefully this helps

Aug 16, 2009 | GMC Jimmy Cars & Trucks

2 Answers

Tranny clunks when shifting gears


Check motor and transmission mounts.

Jun 15, 2009 | 1999 Buick Park Avenue

1 Answer

1996 FORD TAURUS GE


Just a piece of advice: could be the oil which lubricates the gears. Try changing your engine oil, maybe it has gotten a little too old and lost its lubricating properties.

Jul 21, 2008 | 1996 Ford Taurus

Not finding what you are looking for?
1999 Jeep Grand Cherokee Logo

136 people viewed this question

Ask a Question

Usually answered in minutes!

Top Jeep Experts

yadayada
yadayada

Level 3 Expert

77194 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22265 Answers

Kevin Daniels

Level 3 Expert

1455 Answers

Are you a Jeep Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...