Car not starting or turning over indicates towards multiple possibilities.
It can be issue with battery or weak battery. But if battery checks out ok, then
it can be starter issue or faulty alternator or problem with low fuel pressure
or no spark at spark plugs due to dirty spark plugs or faulty
ignition coil or injectors getting cracked or dirty and needs to be cleaned. To confirm the problem, the basic troubleshooting is required. Click this link below and follow the troubleshooting:------ http://technoanswers.blogspot.in/2012/02/car-starting-issues.html --------- This will help.
Thanks.
SOURCE: rear brakes scrubbing on 1998 chevy venture van
Removal Procedure
Tools RequiredJ 38400
Caution: Keep fingers away from rear brake shoe springs to prevent fingers from
being pinched between spring and shoe web or spring and backing plate.
Installation Procedure
Notice: Do not over stretch the adjuster spring. Damage can occur
if the spring is over stretched.
Important: Ensure that the adjuster (2) engages the brake shoes (4 and 5), the
park brake actuator (3), and the adjuster actuator (1) properly.
Notice: Do not over stretch the adjuster spring. Damage can occur
if the spring is over stretched.
SOURCE: 1998 chevy venture stumbles when you accelerate
check the throttle position sensor and also check for air intake leaks at the throttle body
SOURCE: 98 chev blazer wont start or make any noises...
Listen for a click from under the steering column when you turn the key on. If you hear no electrical click then your ignition switch could be bad. If you hear an electrical click the you starter soleniod is bad.
SOURCE: 1998 chevy venture will not start only starter
battery is dead or too much corrosion on the terminals.
SOURCE: Where is the abs sensor on a 1998 chevy venture
there are four ABS sensors. one behind each wheel in the hub assmebly just follow the shielded wiring harness down to the sensor, it is at the behind the brake rotor in the hub assmebly, the lock up problem is not the sensor, the function of ABS is to stop lock up of the wheel, this problem is caused by a leaking ABS hydraulic control unit, that is the part with all the brake lines coming out of it
181 views
Usually answered in minutes!
×