Question about 2005 Peugeot 405

Open Question

Peugeot 807 '54 reg

Can you please advise how to remove gear knob in order to replace the
gear stick gaiter? Any advise would be much appreciated

Many thanks
Frances

Posted by on

6 Suggested Answers

  • 274 Answers

SOURCE: peugeot 206 1.4 (54 reg) not starting after nock

it should be there mate it might be lower down to the rear of the battery (they are usually a black unit with a red cap)

Posted on Dec 17, 2009

czaa
  • 4481 Answers

SOURCE: p0238 diagnostic on peugeot 307 sw 54 reg,52.000

did u scan car urself-the haynes manual at discount auto sez the turbocharger sensor reads high-get another scan at the store to confirm-u may need a new one

Posted on Dec 30, 2009

  • 156 Answers

SOURCE: gears stick

If your car is a manual gear change, your clutch may need adjusting or repair or the gearbox oil may need changing.
If your car is an auto check to see if you are using the correct transmission fluid , Peugeot autos do not use normal ATF and will fail if the correct fluid is not used.
Hope this helps Marshall

Posted on May 26, 2010

alicantecoli
  • 21949 Answers

SOURCE: cannot get 54 reg peugeot

2005 ,has it been damaged ?? make sure the bonnet cable is fitted correctly at the front of the vehicle and the interior lever is going back ,push it back by hand as well to make sure

Posted on Aug 15, 2010

  • 14036 Answers

SOURCE: i can not remove the gear knob

should twist off counter clock wise.

Posted on Nov 29, 2011

  • 477 Answers

SOURCE: how do i remove a gear knob to replace the leather on a 2006 peugeot 407 2ltr hdi

Look closely at the underside of the gear knob and you will see how to unattach the gater from the lever / knob...

Then you need a very firm grip - twist the gearknob 90 degrees to the left.... once its in that position it will pull off.... may be stiff at this point too - but it should pull off now...

Posted on Sep 13, 2012

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Fitting a leather gaiter on an x type jag


that is simple.

the shift knob is threaded on to the shift lever and you need to rotate it counterclockwise to remove. the gaiter is held in place with the trim ring that is attached by 4 clips in the corners. using a couple of popsicle sticks (or other thin, protected tool, so not to damage the wood trim, etc) you can get under the corner of the gaiter surround and gently pry upward. see illustration.

hope this helps
25404563-ai1d4ga3barerea5mewg0gzj-5-0.jpg

Feb 07, 2015 | 2005 Jaguar X-Type

1 Answer

How to replace a gear lever leather boot on a Honda 2.2 crv 58 plate


First, unscrew the original gear knoband remove completely.
yannis-albums-new+gear+knob++gaiter-picture7964-simply-remove-original-gear-knob.jpg


Next unclip the panel which covers the base of the gear knob. This unclips quite easily without the use of tools or screwdrivers. Pop it off from the top end first and then lifts out from the bottom.
yannis-albums-new+gear+knob++gaiter-picture7965-remove-gear-base-cover.jpg

Screw on the new gear knob. Once tightly fitting, put the gaiterover it.
Top Tip - use a cable tie to keep the new gaitor fitting snug! This stops it slipping down and looking saggy. Clip off the excess off the end of thecable tie.yannis-albums-new+gear+knob++gaiter-picture7966-tip-use-cable-tie-keep-new-gaitor-fitting-snug-audi-tt-leather-gaiter.jpg


Finally tuck the new gaiterin and ensure it is fitting snug. Then follow clip the plastic base cover back on. Sit back and look proudly at you new smart, quality gear knoband gaiter!

Oct 11, 2014 | Cars & Trucks

1 Answer

How do I remover the gear lever gaiter


unscrew the shift knob ( rotate CCW) . remove the gaiter surround by gently prying up (use popsicle sticks or the like) at the 4 corners to remove the 4 clips
25177700-ai1d4ga3barerea5mewg0gzj-3-0.jpg

Oct 03, 2014 | 2006 Jaguar X-Type

2 Answers

How do i remove a gear knob to replace the leather on a 2006 peugeot 407 2ltr hdi


Look closely at the underside of the gear knob and you will see how to unattach the gater from the lever / knob...

Then you need a very firm grip - twist the gearknob 90 degrees to the left.... once its in that position it will pull off.... may be stiff at this point too - but it should pull off now...

Sep 13, 2012 | 2006 Peugeot 407 2.0

1 Answer

Change gear gaiter for mazda 6 2008


Remove the shift lever knob. Remove the #2 console panel by prying up with a flat screwdriver to release the clips. (The #2 panel is the one that includes your cup holders) Remove the #1 console panel (the one around the shifter) by prying straight up with a flat screwdriver to release the clips. Remove the screws securing the shifter boot (gaiter) to the bottom side of the #1 console panel.

Reverse procedure to install.

Jun 16, 2012 | 2008 Mazda 6 2.0

1 Answer

2OO5 4MOTION PASSAT I need to change my gear stick GAITER could you tell me how to get the gear stick off, or is welded it does not seem to have a thread. THANKS K C MUNNS


It is held on by a clip which is crimped
To see,un clip gaiter and pull up over gear stick
Loosen clip with small screw driver untill gear knob comes off

Mar 26, 2011 | Volkswagen Passat Cars & Trucks

1 Answer

How do i remove gear knob and gaiter on 2005 vw passat


For this year, the knob wasn't screwed on, it was more of a snap on rig. The easiest way is to just get some leverage and pull like hell! Or use a screw driver. Just be careful not to scratch anything! Good luck!

Mar 08, 2011 | 2005 Volkswagen Passat

1 Answer

Gear knob feels if it has come detached from the the gearbox and only moves forward anbackwards but the car is stuck in gear


Hi
the gear linkage has either snapped or come off, you should be able to remove the leather gear gaiter from around the gear stick pull it up and look through the hole. you may have to get under the car to pop it back into place but if it has snapped then you need a new gear linkage, its not expensive and easy enough to fix.

Hope this helps
regards
dan

Feb 26, 2010 | 2000 Ford Focus

3 Answers

Gear knob


The manual knobs are on there really tight but they're just twisted on. You need to turn like crazy on it to get it loose. You can wrap a towel around it and use channelock pliers or a big wrench if need be.

Sep 02, 2008 | 2003 Volkswagen Passat

1 Answer

Vw passatt gaiter change


The clip seems to be a use once and destroy during removal. I used a nylon tie and the home mechanics friend (duct tape) to fasten the new gaiter. Not perfect but quite usable and avoided a trip to the dealer.

Aug 08, 2008 | 2003 Volkswagen Passat

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

247 people viewed this question

Ask a Question

Usually answered in minutes!

Top Peugeot Experts

Colin Stickland
Colin Stickland

Level 3 Expert

21949 Answers

Wahs Team

Level 2 Expert

205 Answers

yadayada
yadayada

Level 3 Expert

61168 Answers

Are you a Peugeot Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...