Question about 1998 Pontiac Trans

1 Answer

How to change the igniton on a 1998 pontiac ws6

I need to find out how to change out the ignition on my 1998 WS6!!! The ignition went out and I'm trying to change it.

Posted by on


1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points


    An expert that got 10 achievements.


    An expert that got 5 achievements.

    Vice President:

    An expert whose answer got voted for 100 times.

  • Master
  • 341 Answers

Remove steer wheel with puller. u will see black cover remove 3 tork screws.remove. next u will need a special tool push dowd on plate . remove clip in center. lift turn arm . remove bolt for lock cly. turn key lock will slide out

Posted on Oct 21, 2008


1 Suggested Answer

  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

a 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of.(from cars to computers, handyman, and even drones)
click here to download the app (for users in the US for now) and get all the help you need.

Posted on Jan 02, 2017


Add Your Answer

Uploading: 0%


Complete. Click "Add" to insert your video. Add



Related Questions:

1 Answer

2001 ws6 6speed Trans am no start. Will crank over but will not fire. Can hear fuel pump turn on with key. Also smells like raw fuel. Fuel is new 91 octane.

Its flooded at this point. let it sit & plugs dry. Diagnose no spark problem, Don't keep turning it w/o spark. The oil is getting all the unburned fuel. Change that oil after u diagnose spark problem. could be coil, ignition relay, ect.

Feb 19, 2017 | Pontiac Cars & Trucks

1 Answer

What would cause the right blinker light on the dash stay on but only when the headlights are on and blinker still blinks on my 2001 Pontiac trans am ws6 ?

That would be caused by a bad ground connection to either the front or rear parking/turn (probably rear) signal bulb socket. When the ground is bad, the parking light filament with find a ground through the blinker filament, then through the turn signal indicator, keeping it turned on. I have seen this on many cars over the years. Hope this helps, good luck.

Jan 29, 2015 | Pontiac Cars & Trucks

2 Answers

2001 Trans Am WS6 My windshield wipers only work on high and stop in the middle of the windshield or whayever point I turn the switch off. I just replaced the control lever (turn signal stalk) and that...

This sounds like the wiper control module.Most of these are a module attached to the wiper motor but are replaceable seperate from the wiper transmisson.

Oct 27, 2010 | 2001 Pontiac Firebird

1 Answer

How do i wire engine fans to a toggle switch in the cabin of a 1997 pontiac firebird trans am ws6?

The simplest way would be to run a wire from the positive battery post to your toggle switch. Make sure you put a fuse in it. Then run from the toggle switch back out to the fan. Unplug the factory wiring and plug you wire onto the power feed terminal at the fans. To find that, just use a jumper wire from the battery to each prong on the fan until it turns on. Plug your toggle switch to that prong. Hope this helps.

Apr 28, 2010 | 1997 Pontiac Firebird

1 Answer

I am looking for a wiring schematic for a 2002 Pontiac Trans Am

If you become an on-line member of they give you free access to any car's online manuals that have wiring schematics and diagrams.


That's the online manual though the quality isn't the best and it takes a long time to download.

Apr 18, 2010 | 2002 Pontiac Firebird

1 Answer

96 formula

If you have the formula, then more than likely you have the ws6 option. To b sure take the vin # to your GM dealer and ask them to check.

Aug 15, 2009 | 1996 Pontiac Firebird

1 Answer

2001 Pontiac Trans Am WS6

check all wires at the starter, sounds like a bad fusable link located at the starter

Jun 27, 2009 | 2001 Pontiac Firebird

1 Answer

How do I change the front turn signal bulb in my 2001 WS6 Trans am? How do I get to it?

Remove two bolts that secure the plastic panel on the underside of the front end of the car, directly below the turn signal housing. The panel will then hinge down allowing you to reach up and access the bulb socket, which has a lock ring that must be compressed while you turn the socket to remove it from the housing. If yours is like mine, the wires are too short to drop below the access panel, so you'll have to reach up with both hands to change the bulb. Also, if yours is like mine, you may see evidence that the bulb gets so hot that the socket shows evidence of burning and/or heat degradation. I'm actually on this site looking for information on a possible recall by Pontiac for this, or at least maybe an upgrade socket.

Jun 03, 2009 | 2001 Pontiac Firebird

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

121 people viewed this question

Ask a Question

Usually answered in minutes!

Top Pontiac Experts


Level 3 Expert

77169 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22258 Answers

Jeffrey Turcotte
Jeffrey Turcotte

Level 3 Expert

8725 Answers

Are you a Pontiac Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides