Question about 2004 Mercury Mariner

1 Answer

Mariner 40 hp outboard

Wiring diagram needed

Posted by on

1 Answer

  • Level 1:

    An expert who has achieved level 1.

    Corporal:

    An expert that hasĀ over 10 points.

    Mayor:

    An expert whose answer gotĀ voted for 2 times.

    Problem Solver:

    An expert who has answered 5 questions.

  • Contributor
  • 6 Answers

If you know the year you should be able to go to http://www.crowleymarine.com/parts.cfm and pull up the wiring diagram out of the manual.

Posted on Jan 21, 2010

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

I have a mariner 40 hp 1988 model not used for two years, motor has only done about 200 to 300 hours, it now starts but i will not go to mid or higher revs and is runing very rich


first up replace the water pump in the shaft housing as the impeller blades will be breaking off. The rich running will be from will be from corrosion build up in the fuel system (carby -needle and seat or injectors). I suggest that you pull the side plate off the engine and check the sacrificial plate for corrosion . The plate between the water cooling and the exhaust
Really because of the risk when in use it is advisable to have it all done by accredited outboard specialists.

Jan 16, 2015 | Cars & Trucks

1 Answer

W55M Mariner Outboard wiring problem


this is the only site i could find with a wiring code, now i'm not sure it is right but let me know and i will see if i can find something on some of my old papers. but will need the serial number.
http://www.maxrules.com/fixmercwiringcodes.html

May 24, 2013 | 2003 Chevrolet Cavalier

1 Answer

1979 mariner 80 hp outboard engine carburator flooding over with fuel


It sounds like maybe the float is sticking open on the carburetor. Check the bowl and needle for debris. The float may be worn out and needs replaced, or another part is bad. if nothing else, put a shut-off valve in the fuel line to stem the flow when the motor is not running.

May 25, 2012 | 1979 Austin Marina

1 Answer

Carburetor runs too rich


sounds like you need to get the carburater cleaned and install a new set of spark plugs

Jul 08, 2010 | 2003 Mercury Mariner

1 Answer

2stroke 8 HP mercury outboard,newish engine no spark


Clean or change the Spark Cables>
to cleab the pull them out and with antirust spray and clean

May 06, 2010 | 2009 Mercury Mariner Hybrid

1 Answer

Mariner outboard motor starts runs, then fuel comes out overflow and motor dies.


If you have carburetors your float is stuck. It can happen more than it should and if it is a smaller engine, laying it on its side can cause it.
You would have to look at the float and imagine which way to lay the engine down in the future. The float could also be bad. You would take it out and float it in Gas, not water to see if it sinks.

If this is a big HP outboard and injected your fuel regulator is bad.

Apr 06, 2010 | 2000 Mercury Mariner

2 Answers

40 hp mariner outboard 2 stroke oil leak at injector pump


without seeing it in front of me its difficult to advise,i had a mercury but it wasnt oil injection so i iam not sure exactly how this injection system works but i should imagine its nothing more than a O ring thats perished or a copper washer needs cleaning with some wet and dry.I bought a new 4stroke mercury in the end because i got fed up with fuel consumption from the 80hp two stroke ,this four stroke 50hp will do about 12 14 nautical miles to roughly 6/7 litres of petrol at about 1200 rpm because iam only a sunday driver and the bumping on the waves makes my back ache unbearable,Well this is the land of fiesta /siesta /manaña --spain .Have a closer look and see where its leaking its only a mechanical pump running off the engine ,so it will have a push rod with some sort of diaphragm that pumps a tinysquirt of oil into the crankcase so it can mix with the incoming fuel ,nothing complicated

Sep 15, 2009 | 2003 Mercury Mariner

1 Answer

Gear shifter for 40 h. p. mariner outboard


With your lower unit off have someone shift the engine into forward while watching the gear shift select shaft's rotation,let gearshift remain in forward,now place your lower unit in forward and reinstall. In the future just put engine in forward when installing a water pump as there won't be a need to move gearshift

Jul 23, 2009 | 2004 Mercury Mariner

Not finding what you are looking for?
Cars & Trucks Logo

1,449 people viewed this question

Ask a Question

Usually answered in minutes!

Top Mercury Experts

yadayada
yadayada

Level 3 Expert

60792 Answers

Fordexpert

Level 3 Expert

5331 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

21949 Answers

Are you a Mercury Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...