Question about 2005 Peugeot 405

2 Answers

Peugeot 206 glowplugs

I have a peugeot 206, 1.4 hdi 05 model and it is not starting, iv been told its the glowplugs and have goten new ones to replace the old but do not know how to change them.

Posted by on

  • 3 more comments 
  • peterhrrsn7 Dec 05, 2008

    hi i have a 206 1.4 hdi 2002 my car turns over but will not start,it did it now and again but will not start at all now

  • Anonymous Feb 05, 2009

    The car is not starting.

  • Anonymous Mar 25, 2014

    peugeot 206 coils spring replacement instructions

  • Anonymous Mar 29, 2014

    Hi, is it necessary to remove the entire steering column to replace the clutch cable ? The Haynes Manual says Yes it is, but wondered if anyone had a FIX around this ?

  • Anonymous Mar 31, 2014

    fuel pump broken

×

2 Answers

  • Level 1:

    An expert who has achieved level 1.

    MVP:

    An expert that got 5 achievements.

    Scholar:

    An expert who has written 20 answers of more than 400 characters.

    Hot-Shot:

    An expert who has answered 20 questions.

  • Contributor
  • 36 Answers

If your not good at mechanicing I suggest you take the car to someone that is experenced.
The reason I say this that we have loads of cars into the workshop with glowpugs broken in the head of the engine with the result of us having to remove the cylinder head.
What happens is that the tip of the glowplug breaks in the head when being removed if it is not done properly.
There is a way that we have found that they can be removed easily without breaking them.
Firsty run the car engine until warm, then we pour a little Diesel fuel onto each plug & let them sit for 15mins or so.
Then we remove them with a deep socket 1/4" drive so we don't put to much pressure on them.
they should screw out easily but we turn them out 1 whole turn then back a 1/4 add a little more diesel ( thimble full) & gently screw them out.
If they start to get really tight screw in again a little then screw out again.
The nuts that hold on the wires just need to be nipped up with a small 8mm spanner, but do not over tighten.

Posted on Dec 11, 2008

  • Level 2:

    An expert who has achieved level 2 by getting 100 points

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

    Vice President:

    An expert whose answer got voted for 100 times.

  • Expert
  • 345 Answers

An hdi should start even if glowplugs arent working,give me more details of what is happening and i might be able to help vagman54@btinternet.com.

Posted on Oct 23, 2008

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

My automatic headlights won't turn off on my peugeot 206 2.0 hdi (2001) any idea's?


yes put key inignition turn to first turn at the end of the indicator stalk there is a button press and hold in until it displays and makes beeping sound same scenario to turn back on

Mar 17, 2013 | Peugeot 206 Cars & Trucks

1 Answer

Back door on peugeot 206 estate car wont open how do i fix


Peugeot 206 hdi 2006 all doors been opening fine and the back passengers door has been sticking sometimes but we could here like a whistling noise from back rear door behind passenger seat. we cantopen it now please can someone help

Feb 23, 2012 | 2005 Peugeot 206 1.4

1 Answer

Hi, i have a x reg peugeot 206 hdi, the serpentine belt snapped, i have a new 1 but cannot find a diagram on how to fit it. please help.....i need my car!!


Peugeot 206 1.4 HDi - DV4TD (8HZ) 2004 ...

1. The serpentine belt routing diagram - without A/C (Air Conditioning)

tdisline_888.jpg


2. The serpentine belt routing diagram - with A/C (Air Conditioning)

tdisline_889.jpg

Sep 18, 2011 | Peugeot 405 Cars & Trucks

3 Answers

I have a peugeot 206 gti the clutch has gone but the car wont start now i was told it had a safety thing on it to stop it starting until its fixed is this right and how can i over ride it?


i have been fixing peugeots for 12 years and never heard anything like that.
it is mrer then likley a faulty crank position sensor, coil pack or quite simply the fuel cut off switch needs resetting which should be located under the bonnet on the n/s (black unit with a red rubber top) just press the top and try starting the car..

if this helps let me know
cheers
big mike

Mar 06, 2010 | 2005 Peugeot 405

2 Answers

PEUGEOT 206 HDI STARTING PROBLEM


your ecu monitor.. emissions control unit mod is done! i dont think this is a cheap fix. either wait for warmer weather,, sell the car or find a dealer to fix this diesel puppy...word of advice .. dont buy peugeot in this country .. or any country...joke.!!

Feb 26, 2010 | 1989 Peugeot 405

2 Answers

Peugeot 206 1.4 hdi has developed a fault where the engine will not start.After leaving the car rest for a couple of hours it will not start .I have to manually bleed the system and the car will start and...


expensive to repair properly,quick fix??? fit two non return valves ,one in the feed and one in the return to the injector pump ,weither conventional pump or common rail pump .this will cure your problem and its cheap to do ,two valves (observe direction) in the lines .works every time on any diesel engine weither its plant or road use

Oct 18, 2009 | 2005 Peugeot 405

1 Answer

I can't found fuel filter on my peugeot 206 1.4 lx 2002


if its diesel 2000 hdi .........its under the hdi cover under the bonnet

if its a 1400 hdi.........
its to the right of the air filter at the back of the engine

May 27, 2009 | 2006 Peugeot 405

2 Answers

Peugeot 206 1.9 diesel help ? I have the above car and i'm having problems in the morning getting it to start i start the car and wait for the orange light to go out ? but it takes at least 15 times before...


Hello Michele,
Thank you for your full description, I wish others were more like you!
Although your light is going out all your Glowplugs/heater plugs may not be operating leavin just one two making it hard to start.
Do you feel up to testing them as this will need a few tools and a Multi meter??
If you do then you'll be coming back to me, if not pop into a quality repairer and tell them you feel maybe two of your heater plugs are burntr out so a test is required? or go for the throat and have the lot replaced as they don't live forever. There a 4 of them.
I hope this helped? if so press the Blue button or Appraise My FREE Effort, Thank You!
Paul 'W' U.K.

Feb 02, 2009 | Peugeot Liberte Cars & Trucks

Not finding what you are looking for?
Cars & Trucks Logo

1,975 people viewed this question

Ask a Question

Usually answered in minutes!

Top Peugeot Experts

Colin Stickland
Colin Stickland

Level 3 Expert

21949 Answers

Wahs Team

Level 2 Expert

205 Answers

yadayada
yadayada

Level 3 Expert

60792 Answers

Are you a Peugeot Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...