Question about 2006 Land Rover Range Rover
If there is no mention of it in the drivers handbook, you may need to get some stick on patches which go on the glass surface of the headlights to overcome the problem. You will find these in most auto accessory shops.
Posted on Oct 20, 2008
The adjustment screws/nuts should be located either on the top of the headlamp assembly,
behind the headlamp assembly, or near the frame rail by the radiator
You will have vertical adjustment screws for each independent beam (separate highs and separate lows, but will be same screw if highs and lows are the same bulb). You may also have additional horizontal adjustment screws as well
Park your car on a level ground 30 feet from a wall and measure the height from the ground to the bulb and mark on a wall (do this for highs beams and low beams if the bulbs are separate, if highs and lows are the same bulb, only do it for the lows)
For Low Beams: If the headlights read VOR, then aim the brightest part or cutoff part just below the mark on the wall. If it says VOL or nothing, aim them 2 inches below the mark on the wall.
For High Beams (if separate from low beams): Aim the headlight directly at the line you marked on the wall.
The lenses themselves cannot be adjusted to conform between left hand and right hand drive. The reflector or projector of a left hand drive vehicle is designed to throw more light towards the right side of the vehicle and vice versa for right hand drive vehicles.
Posted on Nov 04, 2009
Tips for a great answer:
Nov 17, 2013 | Ford Cars & Trucks
Jul 18, 2012 | 1997 Mazda Protege
In the U.S. the type,
adjustments, and illumination factors of all automobile lighting devices
are regulated by the Federal Motor Vehicle Safety Standard 108. The
headlights must function and be adjusted correctly. Your high beams must
disperse their beams straight forward and low beams down and to the
right while safely providing illumination without too much or too little
glare. It is wise to check the headlight adjustment on your Mercedes at
least every year. Doing it yourself will save you time and money. It
will also make driving safer for you and others you may meet on the road
at night. All it takes is time, some basic tools and a little patience.
Other People Are Reading
Apr 05, 2012 | Cars & Trucks
Oct 19, 2010 | 2001 Volkswagen Passat
Jul 31, 2010 | 2008 Mercedes-Benz M-Class
Jul 20, 2010 | 2008 Kia Optima
Sep 15, 2009 | 2004 Jeep Grand Cherokee
Sep 04, 2009 | 2006 Mercedes-Benz B-Class
Jun 22, 2009 | 2006 Land Rover Range Rover
459 people viewed this question
Usually answered in minutes!
Step 2: Please assign your manual to a product: