Question about 2006 Jeep Grand Cherokee

1 Answer

Automatic interior illumination

My interior automatic illumination just stopped working, is this a fuse issue, or is this possibly something indicating a more severe problem?

Posted by on

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

    Master:

    An expert who has achieved Level 3.

  • Master
  • 426 Answers

Sounds like a blown globe.Nothing to worry about just take the cover off the interior light and take the globe out and replace it with a new one you can easily buy from auto parts outlets

Posted on Oct 20, 2008

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

2005 f150 4x4 power windows ,interior lights a/c ,radio gauges are not working fuses are ok and already check for voltage and it has but still not working . It has something else in betwen..?......


Checked voltage where ?
The instrument control module (ICM) controls power to the power window system by activating or deactivating the delayed accessory relay.
Symptom Chart Condition Possible Sources Action
  • All power windows are inoperative
  • Fuse(s).
  • Circuitry.
  • Instrument cluster module (ICM).
  • Accessory delay relay.
  • Driver window control switch.
  • Go To Pinpoint Test A .
Vehicles equipped with remote keyless entry (RKE) have an illuminated entry feature, which enables the instrument cluster module (ICM) to illuminate the interior lamps (and if equipped, the puddle lamps in the exterior mirrors) when an unlock signal is received from the vehicle security module through the UBP network, or when any of the doors are opened. The ICM controls the interior lamps illuminated entry feature by activating the battery saver relay. When active, the illuminated entry feature will be canceled when any of the following conditions are met:
Instrument Cluster Diagnostic Trouble Code (DTC) Index DTC Description Source Action B1342 ECU is Defective Instrument Cluster Module REFER to Section 413-01 . B2499 Courtesy Lamp Output Failure Instrument Cluster Module Go To Pinpoint Test A . B2659 Courtesy Switch Fault Instrument Cluster Module Go To Pinpoint Test C . - All Other DTCs Instrument Cluster Module REFER to Section 419-10 . Do you have a professional grade scan tool ? If not your best bet would be to take your vehicle to a qualified repair shop .

Oct 23, 2016 | 2005 Ford F-150

1 Answer

2002 ford expedition interior lights are not on what fuse is it?


Courtesy Lamps - central junction box. fuse # F1.21 that goes to interior lamp relay in the instrument cluster and F.24 this fuse powers battery saver relay .
Interior Lighting The interior light system consists of the following:
  • front map lamp assembly
  • front door courtesy lamp
  • generic electronic module (GEM)
  • glove box lamp assembly
  • central security module
  • interior lamp switch
  • interior lamp relay
  • illuminated vanity mirrors (Navigator only)
  • reading lamp assembly
  • rear courtesy lamp
  • running board lamp
  • underhood lamp assembly
  • The generic electronic module (GEM) illuminates the interior lamps when an unlock signal is received from the remote anti-theft personality central security module. The illuminated entry feature will be canceled when any of the following conditions are met:
    • 25 seconds have elapsed since the illuminated entry feature was activated and the interior lamp control is not activated (door ajar or courtesy lamp switch on).
    • The GEM receives a request from the central security module (remote transmitter lock button pressed) and the interior lamp control is not activated.
    • The ignition is in the RUN or START position and the interior lamp control is not activated.
    The GEM will illuminate the interior lamps when any door is open or ajar. The interior lamps are; the dome lamp, the rear cargo lamp, the door courtesy lamp and the side rail lamps. The courtesy lamps will shut off when the doors are closed and the illuminated entry feature is not active or when the vehicle speed is greater than 5 mph (8 km/h). The interior lamps will not be reactivated until the vehicle speed is less than 3 mph (5 km/h) and a new door open warning lamp switch is received.
    The GEM controls the interior lamps illuminated entry function by activating the interior lamp relay.
  • You have an electronic control module and relays involved in the operation of these lights also !

  • What

    Jan 08, 2015 | 2002 Ford Expedition

    1 Answer

    1998 ford taurus interior lights and windows stopped working at the same time


    Check the fuse is bad? Open look at best. Using the multimeter measure the are in good condition,more auto knowledge

    Apr 03, 2013 | 1998 Ford Taurus

    1 Answer

    Interior lights and radio stopped working and locks won't lock unless keys are in ignition


    Hi Laura, Im glad to help!

    Laura, anytime a fuse is blowing that means that the power side of the circuit is shorting out against something that's metal, it also can be a part itself that's shorting out. This is a very time consuming issue to find and can wind up costing you an arm and a leg. Call me Al 314-374-5218. Shorts are very common but must be traced down on the circuit fuse that is blowing. Hope this helps and have an awesome day Laura.

    Apr 02, 2013 | 1999 Mazda Millenia

    1 Answer

    The lights that illuminate the gears next to the Automatic shifter don't light up, but all of my other interior lights do. Could it be a fuse?


    More likely, the bulb has gone bad. Remove the bulb and check for voltage with a meter...or just replace the bulb and see if it works.

    Aug 03, 2010 | 2006 Scion tC

    1 Answer

    Door lights will not go out.


    Spray a lot of WD-40 or Blaster in the latches on the inside rear of each door. Most likely the drivers door is the issue because it sees the most use. There is a switch on the interior side of the latch that gets stuck. If that does not work, it is possible the GEM module has failed. I believe I have a couple of these if you need one, but usually the switch sticks open (on or depressed and it's normally closed) on the driver door.
    Illuminated Entry Illuminated entry is included as a function of the generic electronic module (GEM). The illuminated entry system may be activated in the following three ways:
    • Raise the outside door handle (22404).
    • Press a code button on the keyless entry keypad (14A626).
    • Press the UNLOCK button on the keyless entry remote transmitter (15K601).
    Electrical flow through the system is as follows:
    • An interior lamp switch (13752) mounted on the front door latch (21812) closes, completing the circuit of the GEM. This switches the system ON.
    • This illumination will remain on for approximately 25 seconds and then automatically turn OFF.
    • During this 25 second period, the system can be deactivated by turning the ignition switch (11572) to RUN position, locking the doors with the keyless entry remote transmitter or keyless entry keypad or by battery saver time out.
    • The system will turn on every time the outside door handles are operated.
    • Opening the front doors (20124) or rear doors (24630) from the inside of the vehicle will not turn on the system.
    • If the outside door handle is held up so that the interior lamp switch is continuously closed, the system will operate as normal and turn off after 25 seconds.
    • If the door handle is still in the raised position, the system will remain off and it will be impossible to activate the system from the other front door handle until the raised door handle is returned to its normal position.
    • This is built into the logic circuitry of the system to prevent battery discharge should the outside door handle be propped up or become jammed in any way.
    The system consists of:
    • generic electronic module (GEM).
    • interior lamp switch.
    • wiring harness.
    The GEM is mounted directly to the fuse junction panel (14A067) The interior lamp switch is retained to the front door latch by a keyed slot and is twisted into position.

    Jan 08, 2010 | 1996 Ford Taurus

    1 Answer

    My interior lights and the twilight switch has stoped working


    its more than likely the twilight sentinal sensor which is in the dash and would cause this issue. it will be a little blue sensor about the size of a dime under the left hand or possible centre of the dash. happy holidays

    Dec 29, 2009 | 1997 Cadillac DeVille

    1 Answer

    I have a 2002 Freelander 2.5 SE automatic V6. All the interior lights are working apart from the centre console lights. The fuel, temperature, rev counter and speedo are all working. The heated rear screen...


    The internal panel lights work off the left hand side of the side lights and are protected by the 10 amp fuse for this side. I had replaced both stop and tail lights with a heavy duty bulbs and because the left hand side powers the panel lights as well, obviously it was too much for the circuit. The right hand side was okay.

    Oct 30, 2009 | 2002 Land Rover Freelander

    1 Answer

    WHAT IS A BTN FUSE ON A 1992 MAZDA MPV . IT HAS SOMETHING TO DO WITH THE HEADLIGHTS OR DIMMER SWITCH I THINK


    BTN stands for Body/Tail/iNterior. It protects the HAZARD, ANTENNA, ROOM, STOP, ILLUM and ABS fuses in the cabin fuse box, which in turn protect the hazard lights, antenna, ECU memory, brake lights, tail lights2.gif, ABS, power locks, clock, horn, illumination, stereo, HVAC, interior lights and alarm. smile.gif __________________

    Jul 21, 2009 | 1992 Mazda MPV

    1 Answer

    Instrument panel and interior lighting not operating, 2004 F150


    sounds likke u got grounding problem with ur wiring. if ur fuse pops wen u install a new fuse. this means ur grounding wire is cut or touching with metal. if doesnt pop,then it is ur power wire that is cut or touching the metal (grounding out)

    Jan 12, 2009 | 2004 Ford F150

    Not finding what you are looking for?
    2006 Jeep Grand Cherokee Logo

    Related Topics:

    102 people viewed this question

    Ask a Question

    Usually answered in minutes!

    Top Jeep Experts

    yadayada
    yadayada

    Level 3 Expert

    61168 Answers

    Colin Stickland
    Colin Stickland

    Level 3 Expert

    21949 Answers

    Jeff Turcotte
    Jeff Turcotte

    Level 3 Expert

    6812 Answers

    Are you a Jeep Expert? Answer questions, earn points and help others

    Answer questions

    Manuals & User Guides

    Loading...