Question about 2002 Chevrolet TrailBlazer

2 Answers

Shift cable my shift cable needs to be replaced and we don't know how the center console comes out in order to replace it. Can anyone help us?

Posted by on

  • Anonymous Mar 26, 2014

    will not shift right

×

2 Answers

  • Level 1:

    An expert who has achieved level 1.

  • Contributor
  • 1 Answer

Gear got stuck on reverse doesnot move or change

Posted on Oct 14, 2009

  • Level 1:

    An expert who has achieved level 1.

  • Contributor
  • 2 Answers

I believe there is 4 screws (2 in cup holders and 2 hidden in cd stash under rubber mat). Also you may nee to take the instrument panel off, which is simple (2 screws by speed cluster and then should to just be able to pull it off. You kinda have to play around the steering wheel.

Posted on Nov 08, 2008

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

2009 buick lacrosse console gear indicator bulb


Transmission Floor Shift Control Indicator Lamp Replacement

Remove the front floor console. Refer to Front Floor Console Replacement.
Rotate the floor shift control indicator lamp socket (2). Pull the socket from the trim bezel.
Remove the bulb from the socket.

Front Floor Console Replacement

Preliminary Procedures
Remove the rear floor console. Refer to Rear Floor Console Replacement.
Remove the instrument panel lower trim plate. Refer to Instrument Panel Lower Trim Plate Replacement.
Set the parking brake, then shift the transmission into drive and push the shift indicator down until it locks, to allow clearance to remove the console.
1
Front Floor Console Screw (Qty: 2)
Caution: Refer to Fastener Caution in the Preface section.
Tighten
2 N·m (18 lb in)
2
Front Floor Console Bolt (Qty: 2)
Tighten
10 N·m (88 lb in)
3
Front Floor Console Assembly
4
Front Floor Console Retainer Clip (Qty: 2)

Feb 24, 2017 | 2009 Buick LaCrosse

1 Answer

2006 ford taurus heater control door


Electric box is motor straight in front of center console if you have floor shift,but anyway it's in the center.What's the problem? Need info. in order to help. don-ohio

Oct 12, 2011 | 2006 Ford Taurus

1 Answer

When putting in park, sometimes key wont come all the way back or come out. have to restart the engine put it in drive, then back into park. what could be causing this?


The linear shift cable (Also called Park Lock Cable) is sticking. This happens a lot due to beverages getting spilled in the center console. Removing the center console and cleaning and lubricating the shift mechanism and the end of the cable usually fixes the problem. In other cases, the cable must be replaced.

Sep 16, 2011 | 2002 Pontiac Sunfire

1 Answer

On a 2005 Honda Civic I need to know how to remove the center console cover to replace a burned out bulb for the gear shift.


Detach the clips (A, B) by pulling the center console box (C) up, and removing it from the center console (D).


k42282_21.jpg

  1. Remove the screws (A, B) and clips (C), and remove the center console (D).

  2. Install the console in the reverse order of removal, and note these items


k42282_22.jpg

Dec 17, 2010 | 2005 Honda Civic

2 Answers

1999 mazda 626 key stuck in ignition


sound like the tummblers are sticking use graphite to lubricate the tummblers

Aug 14, 2009 | 1999 Mazda 626

1 Answer

1991 ford t-bird


your shift cable has snapped and needs to be replaced there is not really any reliable quick fix but you can shift by pushing or pulling on the snapped portion of the cable

May 19, 2009 | 1991 Ford Thunderbird

1 Answer

Need instructions on how to remove center console to access electric window switch.


Here is what I could find, hope it helps.
Good luck.
Regards,


REMOVAL & INSTALLATION

See Figures 1 and 2
The following procedure is a general procedure for console removal. You may have to modify or skip certain steps depending upon your vehicle.
  1. Disconnect the negative battery cable.
  2. Remove the shift knob, floor compartment door and console trim plate.
  3. Remove the instrument panel accessory trim plate.
  4. Unfasten the retaining bolts, detach the connector, then remove the console door.



0900c152800900b7.jpg enlarge_icon.gifenlarge_tooltip.gif Fig. Fig. 1: Remove the retainers, unplug the connector, then remove the console door
  1. Remove the seats, as outlined later in this section, in order to get to the lower rear screw(s) on the side trim panels.
  2. Remove the console side trim panels.
  3. If equipped, remove the switch pack housing with the switches.
  4. Remove the console compartment floor protector, bolt covers and bolts.
  5. Unfasten the screws mounting the console to the instrument panel and tunnel.
  6. Unclip the harness and accessory plug.
  7. Tag and detach all necessary electrical connectors.
  8. If necessary, remove any remaining retainers.
  9. Tilt the rear of the console up, then slide the front tab back out of the instrument panel and remove the console from the vehicle.



0900c152800900b8.jpg enlarge_icon.gifenlarge_tooltip.gif Fig. Fig. 2: Exploded view of a typical console mounting
To install:
  1. Position the console in the vehicle by placing the front tab of the console into the instrument panel slot, making sure to align the screw holes.
  2. Attach the electrical connectors as tagged during removal.
  3. The remaining of installation is the reverse of the removal procedure. Tighten the console retaining screws to 89 inch lbs. (10 Nm).

May 04, 2009 | 1986 Chevrolet Corvette

1 Answer

How can I remove gear shift knob on a 2003 Navigator?


it looks like you disconnect the shift cable and remove the center console finish panel with the shifter.


SECTION 501-12: Instrument Panel and Console 2003 Expedition/Navigator Workshop Manual
REMOVAL AND INSTALLATION Floor Console —Front, Navigator Removal and Installation
  1. Apply the parking brake.
  1. Position the front seat forward.
  1. Remove the two front floor console rear bolts.
  1. Position the front seats rearward.
  1. Disconnect the battery. For additional information, refer to Section 414-01 .
  1. Remove the pin-typ retainer and the window control switch panel.
    • Disconnect the electrical connectors.
  1. Move the shift lever to NEUTRAL and position the shift indicator bezel aside.
  1. Remove the screws and the center console finish panel.
    • Disconnect the electrical connectors.
  1. Disconnect the shift cable.
  1. Disconnect the front floor console electrical connectors.
    1. Loosen the electrical connector bolt.
    1. Disconnect the connector.
    1. Disconnect the electrical connector.
  1. Remove the front floor console side finish panel.
    • If equipped, disconnect the electrical connector.
  1. Remove the front floor console front bolts.
  1. Remove the floor console.

Apr 17, 2009 | 2003 Lincoln Navigator

3 Answers

Gear shift difficulty moving/gear shift stuck in 1st gear


First of all, I need to know whether you will be working on a lift or on jack stands as this will determine if you will just drop the transmission or have to pull the entire engine and then pull the transmission.

Heres what you should do before getting started.

1. Get a Haynes manual from the local AutoZone or any autoparts store.
2. Get to know your local Dodge 5 star dealer phone number as it will be helpful on quick on the fly questions if you need to talk to a mechanic or need to order parts.

Once you answer my first question, then I will let you know where to start, the haynes manual will also be very helpful with pictures while you are working if you get stuck.

Dec 22, 2008 | 2002 Chrysler PT Cruiser

Not finding what you are looking for?
2002 Chevrolet TrailBlazer Logo

499 people viewed this question

Ask a Question

Usually answered in minutes!

Top Chevrolet Experts

yadayada
yadayada

Level 3 Expert

70374 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22041 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

6878 Answers

Are you a Chevrolet Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...