Question about 1995 Chevrolet C2500

1 Answer

95 chev truck blows fuses

Blows turn signal fuse when key is turned on. Have replaced turn switch and ignition switch.

Posted by on

  • Anonymous Mar 17, 2014

    Ignition fuse blows every time van is started. Why?

×

1 Answer

  • Level 2:

    An expert who has achieved level 2 by getting 100 points

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

    Sergeant:

    An expert that has over 500 points.

  • Expert
  • 314 Answers

Your truck has a trailer hitch? Right! Check out the wiring! Frankster016

Posted on Oct 19, 2008

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

I have a 03 isuzu rodeo and every time I turn the ignition the turning signal fuse blows


Most likely a short in the directional circuit. Start at the blubs and disconnect the connectors at the bulb sockets. disconnect one at a time and see if the fuse continues to blow. When the fuse stops blowing you have found which circuit it is. Also, this could be the stalk switch on the steering column. disconnect and see if the fuse blows, and don't forget the 4 way flasher switch also. Lastly, pull the relay and check if the fuse still blows.

Sep 29, 2015 | Isuzu Cars & Trucks

1 Answer

Ignition fuse switch keeps blowing


you have a short in that circuit chck your harness for wiring that might be exposed to ground or pinched

Apr 13, 2014 | 2006 Kia Sedona

1 Answer

Ford 99 Taurus ignition fuse keeps blowing every time key is turned


A bad something, yes.
The fuse may be the primary fuse for the key switch. If it is, you would need to disconnect the key switch harness and check for a short to ground on each circuit.

Jun 01, 2013 | Ford Cars & Trucks

1 Answer

Turn signals on a 1995 lesabre keeps blowing fuses when I turn key on. I have lights everywhere else. need answers PLEASE


Have you unplugged the turn signal switch to see if the short is inside the switch or harness ?

May 11, 2013 | Cars & Trucks

1 Answer

30 amp Starter/Ignition fuse keeps blowing when i turn the ignition key. The instrumentpanel lights are dim and then the fuse blows.


I am assuming you are talking about the circuit that powers the key switch. I'm showing a fuseable link to the starter relay instead of a fuse.
If it is the circuit that powers the switch, I would disconnect the switch and see if the fuse blows as each circuit is powered one at a time using a jumper wire. You can get 30amp circuit breakers that plug into the fuse slot to use while you are testing circuits.
You may need a repair book or shop manual to find out what is powered by that fuse since it is most everything on the car.

Mar 01, 2013 | 1997 Dodge Avenger

1 Answer

I have a 1993 ford explorer, every time i turn the ke to the run position, it blows the ignition 60amp maxi fuse under the hood. The first time this happened, I replaced the fuse and the SUV ran fine for a...


I'm no expert but when you turn key to run position, this turns the fuel pump on if the pump is faulty i would think it would blow the fuse also. Or its your theory a short in the ignition system wiring.

Mar 20, 2011 | 1993 Ford Explorer Limited

1 Answer

20 AMP FUSE BLOWS WHEN IGNITION IS SWITCHED ON IGNITION SWITCH TESTED AND OK


something connected too ignition sdwitch has short to ground. remove all fuses except 20amp that blows turn on ignition see if blows. if not replace one by one till it does to isolate circuit. which fuse is blowing and where is it located.

woodysmechan kiesha76@hotmail.com

Mar 10, 2011 | 1999 Suzuki Vitara

1 Answer

Blows 15amp ecm fuse


replace ignition switch

May 29, 2009 | 2005 Toyota Corolla

1 Answer

30 amp ignition fuse in engine compartment blows at start


It sounds like a bad ignition switch or something is grounding out.Try to isolate the problem to key positions.See if the fuse blows when you turn the key to ACC(when your dash lights come on without starting)If the fuse does not blow then when you go to start it and it blows it could be one of many problems,the more common ones could be ignition switch,wiring,starter relay,starter soleniod,or perhaps the starter itself is shorting out,this can sometimes happen when a starter goes bad.

Apr 12, 2009 | 1996 Hyundai Accent

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

98 people viewed this question

Ask a Question

Usually answered in minutes!

Top Chevrolet Experts

yadayada
yadayada

Level 3 Expert

60667 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

21936 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

6811 Answers

Are you a Chevrolet Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...