Question about 2000 Audi TT

2 Answers

Fuel pump relay

Need to find fuel pump relay no power to fuel pump

Posted by on

  • 1 more comment 
  • jdpatt369 Oct 19, 2008

    where is it located

  • jdpatt369 Oct 20, 2008

    where is the fuse located and also where is the relay located

  • jason May 11, 2010

    have you checked the inline fuse?

×

2 Answers

  • Level 1:

    An expert who has achieved level 1.

    MVP:

    An expert that gotĀ 5 achievements.

    Governor:

    An expert whose answer gotĀ voted for 20 times.

    Hot-Shot:

    An expert who has answered 20 questions.

  • Contributor
  • 29 Answers

Located under the steering wheel. The fuse should be #28 and the relay will have 167 or 409 on it. Here is a link to a wire diagram for the TT
http://mk1tt.montebellopark.com/pdf/2002MYStdEquipWiring.pdf

Posted on Feb 06, 2009

  • Level 1:

    An expert who has achieved level 1.

  • Contributor
  • 1 Answer

Where is the fuel pump relay on a audi tt 2000 modal

Posted on Dec 27, 2009

5 Suggested Answers

jmeyer847
  • 185 Answers

SOURCE: need location of fuel pump relay

This relay will be in the Power Distribution Center under the hood in the engine bay. Thanks for using fixya!

Sincerely,

jC

Posted on Jan 08, 2009

  • 330 Answers

SOURCE: i can get power th the fuel pump when i run a hard wire from the battery to the relay but when i put the relay back in no power to the fuel pump

I have a question. Turn the ignition on you should hear the pump for about 3 seconds. then it should stop. this is normal operation. then when a signal is sent to the ignition that you are going to crank it then it switches on. I can see how this can seem like the pump is not working but after you crank it you should be able to hear the pump for about 1-1.5 seconds after the crank then it will stop. The pump will not turn on until it is told to do so by the computer.

Posted on May 25, 2009

  • 979 Answers

SOURCE: 1996 CADILLAC DEVILLE, NO POWER TO FUEL PUMP

Check for a burned fusible link under the hood. If you have power at the fuel pump relay, you could have a bad ignition switch or bad oil pressure switch...accordianman

Posted on Dec 15, 2008

  • 3 Answers

SOURCE: Don't have owners manual for a 1999 mercury

uoe can retrieve that on line for free All I did was goggle mercury cougar 99

Posted on Mar 20, 2009

localwonder
  • 6784 Answers

SOURCE: no power at fuel pump chev.S-10 looking for fuel pump relay and fuse

The fuel pump relay is located Under hood, driver side, upper firewall, mounted in relay block.

The fuse is located under the instrument panel to the left of the steering column. The fuse block should be visible from underneath the steering column, near the pedal bracket. If the panel is not visible, check for a removable compartment door or trim panel which may be used on later models to hide the block.



Posted on Jun 03, 2009

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

2 Answers

1997 sunfire not getting poer to fuel pump relay


Which pin at the relay socket , pin 85,86 or 30 ,87 ? Here check out this video ! GM Fuel Pump Relay Testing

Aug 29, 2015 | 1997 Pontiac Sunfire

1 Answer

No fuel pressure in efi system


Either the fuel pump is not working, or the filter is totally blocked.
The fuel pump circuit needs checked to see if it's a wiring problem or a failed fuel pump. There will be (probably) a fuel pump fuse in your fuse block, and a fuel pump relay under the hood.
If you check the fuel pump wire for power at the gas tank connector while the engine is cranking over, and there is power there, and the ground for the pump is good, then the pump is not working and will have to be replaced. If you do not have power when cranking, the wiring at the fuel pump relay will have to be checked. Simple relay- has a power feed for the pump at one relay terminal (it is hot at all times), and a fuel pump wire to pump on another terminal (the power out for relay). When relay coil side is energized from a signal from computer, the relay contacts close and power is sent to the pump. The other relay terminal is a ground for the coil side of relay. Pull the relay out and you will see the diagram etched on it. If there is a fifth terminal, that could be a pump prime terminal, or a way to keep the pump running when engine is running through the oil pressure switch. But when cranking the engine, the computer will signal the relay to send power to the pump.

Dec 31, 2013 | Cars & Trucks

1 Answer

I have a 1996 mustang v6 no power to fuel pump. Bought used fuel pump relay still have np power. Safty switch is good. Unpluged fuel turned switch on and i have constant power of 9.52 volts plug in pump...


9.5 volts sounds like the power coming from the gas gauge.
I am showing a relay module with the fuel pump and pcm relays built in along with two other relays. The fuel pump relay should not be accessable. In most cases the pump relay gets power from a 20amp fuse and the computer grounds the relay when needed. Power goes from the pump relay to the inertia switch then to the pump. So the inertia switch should be hot when the pump relay is activated.

Jun 12, 2013 | Cars & Trucks

1 Answer

No power to fuel pump or pump fuse on a 1996 saturn sl1. whats up?


The fuel pump fuse gets its power from the fuel pump relay, which is located in the Instrument Panel Junction Block.

The fuel pump relay gets its ground from G102, which is located just forward of the left strut tower.

The fuel pump relay gets its power from the Powertrain Control Module Connector "C" Pin 10 ( DARK GREEN/ WHITE wire) for the primary side of the relay.

The sencondary side (the side that provides power to the fuel pump fuse) of the fuel pump relay gets its power from the IP BATT Fuse (30 Amp) HOT AT ALL TIMES in the underhood fuse block.

This should be enough information to figure out why your fuel pump is not getting power. Let me know what you find.

Apr 14, 2012 | Saturn SL1 Cars & Trucks

2 Answers

No power to fuel pump to make it work in gas tank


Have you checked the fuse/relay or the reset button (if equipped)?

Mar 03, 2011 | 1987 Nissan Pickup

1 Answer

1990 ford festiva no power to fuel pump. replaced relays , fuel pump, checked safety shutoff. nothing .. ran hot wire to fuel pump and pump worked but car still not trying to start. got spark. now what


The pump should have a fuse in the fuse block. You need to check for power in the fuse block and you need to check power to the pump relay.

Sometimes there is a fusible link to the Relay. If you check the connector terminals for power where the Relay plugs in, you can determine if the fusible link has blown. You could have already replaced the bad parts and now need to restore power to the Relay.

Oct 10, 2010 | 1991 Ford Festiva

1 Answer

Fuel pump not geting power


CHECK THE INERTIA SWITCH FIRST , IT'S LOCATED BEHIND THE PASSENGER SIDE KICK PANEL THERE IS A ACCESS HOLE TO CHECK RESET BUTTON.. CHECK FOR POWER AT THE TERMINALS WHILE THERE ...THE FUEL PUMP WILL RECIEVE POWER FOR 2 SECONDS WHEN IGNITION IS TURNED ON IF NO POWER (12VOLTS) CHECK FUEL PUMP RELAY IN ENGINE COMPARTMENT RELAY BOX , IF NEEDED SWAP RELAYS AND RETEST , ALSO THE POWER RELAY SUPPLIES VOLTAGE TO PCM WHICH IN TURN ENERGIZES FUEL PUMP RELAY SO CHECK BOTH RELAYS ALSO

HOPE THIS HELPS

Aug 08, 2010 | 1996 Ford F150 Regular Cab

1 Answer

FUEL PUMP NOT GET POWER


You need to verify that the pump is not getting power,if this is true then you need to see if the fuel pump relay is being powered and if not then check the inertia switch,if it is being powered up check to see if the relay is swithing power to the pump,if not replace the relay,if so you have a broken wire between the relay and the fuel pump,repair as needed

Jul 28, 2010 | 1991 Ford F150

3 Answers

I have power at fuse but not in plug for fuel pump? any thoughts


You should test your fuel pump relay. Do you have any codes in the computer?

Mar 18, 2010 | 1995 Pontiac Grand Prix

3 Answers

No power to fuel pump


Hi..my name is Keith..and the 2 things that i know of...that will not let power go to the fuel pump is 1..the fuel pump relay being bad..or 2..that something has tripped the Inertia Switch...and it needs resetting..i hope this will help

Jun 30, 2009 | 1994 Ford Ranger Supercab

Not finding what you are looking for?
2000 Audi TT Logo

2,835 people viewed this question

Ask a Question

Usually answered in minutes!

Top Audi Experts

Colin Stickland
Colin Stickland

Level 3 Expert

21949 Answers

yadayada
yadayada

Level 3 Expert

61249 Answers

Thomas Perkins
Thomas Perkins

Level 3 Expert

13160 Answers

Are you an Audi Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...