Question about 2000 Ford Expedition

1 Answer

Back window While driving the back window sensor will send a door open signal. But the window is shut. How can I corret the problem

Posted by on

1 Answer

  • Level 2:

    An expert who has achieved level 2 by getting 100 points

    MVP:

    An expert that gotĀ 5 achievements.

    Governor:

    An expert whose answer gotĀ voted for 20 times.

    Hot-Shot:

    An expert who has answered 20 questions.

  • Expert
  • 92 Answers

Lube lock and latch area with WD 40.open and close gate or window several times,this may free up the door ajar switch.

Posted on Oct 21, 2008

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Shuts off while driving and doesn't restart


One of the most common causes would be a faulty crankshaft position sensor. When the sensor malfunctions, it overheats and stops sending a signal to the computer. If the sensor stops sending a signal to the ignition module, it will cause the car to shut off. Replacing the crankshaft position sensor should cure this problem. There are a lot of other possibilities such as a faulty ignition control module. When the car stalls suddenly while driving it is usually due to loss of ignition spark. Clean all the fuses in the main fuse box. Some of the fuses provide power to the ignition system. If you have poor fuse connections it can cause the problem also. If you need more help on how to repair your crankshaft position sensor I would suggest checking out this sites HowTo section http://www.buyautoparts.com/howto/

Jul 10, 2013 | Mercedes-Benz S550 Cars & Trucks

1 Answer

ABS light on a 1998 chrysler cirrus comes on only after the doors lock when driving down the street,why?


This is the short story.The transmission sends a signal to the ECM that sends a signal to the BCM (This is what locks the doors) The ECM also sends that signal to the ABS. When the ABS doesn't sense a signal from the wheel sensors, the ABS light comes on. Have the codes checked. Let me know. Randy

Sep 26, 2011 | 1998 Chrysler Cirrus

1 Answer

I have a 2007 Mini Cooper. Earlier today, the window shifted down as it does when the door handle is being opened and the signal showed up on the dash stating that the door wasn't shut. The door had...


you probably have two switches in your door. one for the door ajar and the other for the door handle. It sounds like the door handle switch is stuck; sending a constant signal to the module showing the door handle being actuated when in fact it is not.

Jun 16, 2011 | Mini Cooper Cars & Trucks

1 Answer

I have a vw 2003 beetle convertible, with a problem with the window. It wont drop down to open door...or go up after i close the door. It opens ok with the button otherwise?


That sounds like a door lock problem.The door lock sends a signal to the convienience control unit to activate the window so you can openthe door and raises the window when you close the door.Try another door lock.good luck.

Oct 26, 2010 | Volkswagen Beetle Cars & Trucks

1 Answer

Why does my door light on my console stays on and make a loud chime noise while driving?


one of the door sensor/switch is defective. it's sending a signal that a door is still open

Jul 05, 2010 | 2003 Kia Sorento

2 Answers

While driving a bell ringing happens when i make a right turn. sometimes the bell rings continually while i'm driving. what the problem?


Sounds silly but this is how i fixed my bell ringing. !st the ringing is the alarm when you open the door and the key is in the ignition or the car is running. I found the push switches that are on the side of the car and are operated when the door is shut have become loose. All you need to do is tighten them up a bit and the bell ringing will stop. When you make your right turn you probably push a bit on the door and that helps open the switch more. The switches are the contact switches that turn on the light as well as the warning sensors for open door. See if your dome lights flicker a bit as well.

Mar 05, 2010 | Hyundai Motor 2004 Sonata

1 Answer

Scion tc 2005: door indicator on gauge wont shut off?


check all of your door latches to see if they all work. If there are sensors on the body where the door closes toward the center B PILLAR of the car it has sensors for the doors, then push them in and see which one is bad. Sometimes the door sensors are located in the door actuator which usually goes to the driver;s door due to it's high use.

Jul 16, 2009 | 2006 Scion tC

1 Answer

Door sensor


one of the sensors in the door pillars has come loose.rear door is a problem as you will need to remove panel from inside to release mechanism,sometimes it can be done by lowering window , remove the rubber strips either side of window and with a coat hanger pulling the lever on the lock.if your lucky ,better off calling out your local mobile mechanic to open door for you

Oct 21, 2008 | 2002 Kia Rio

1 Answer

Oxygen sensor


Somwhere along the lines someone might have installed an oxygen sensor eliminator kit. It basically sends a straight even signal back to the computer to tell it everything is ok. These are often used when people are trying to trick the computer on the vehicle to dump more fuel into the motor. I would check for a wire harness near the sensor that might just have a plug of some sort stuffed into it. If this is not the case, I would have to ask a few questions about the vehicle before I could give a more complete answer.

Jul 31, 2008 | 1996 Honda Civic

Not finding what you are looking for?
2000 Ford Expedition Logo

110 people viewed this question

Ask a Question

Usually answered in minutes!

Top Ford Experts

yadayada
yadayada

Level 3 Expert

60769 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

21949 Answers

Fordexpert

Level 3 Expert

5331 Answers

Are you a Ford Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...