Question about 1999 Ford Ranger SuperCab

1 Answer

99 Ford Ranger flex fuel with plugged fuel injector

Runs like it has a plugged fuel injetor how do i find out if the injector is plugged?????

Posted by on

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

    Master:

    An expert who has achieved Level 3.

  • Master
  • 426 Answers

They would need to be removed cleaned and bench tested.Considering the age of the vehicle id be suprised if it was an injector What are the symptoms your experiencing

Posted on Oct 18, 2008

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

2 Answers

What sh0uld fuel press be 99 ford ranger 2.5 4 cyl ?


45 minimum to 65 maximum depending on the injector system
most fuel injector systems operate around the 55 psi mark

Apr 21, 2017 | Ford Cars & Trucks

1 Answer

How to put a fuel rail in a 99 ford ranger with a 3.0 motor


Unbolt the fuel rail and lift up, then replace the injector seals (lightly oil seals) and reinstall new rail on injectors and push rail and attached injectors back into the intake holes, very easy job.

Nov 08, 2016 | Ford Cars & Trucks

1 Answer

I swap my engine on my 03 ranger 3.0 flex fuel,with one from a 02 ranger gas fuel. It was running rough until I put my old fuel rail and injectors.But I still have a miss on cylinder #3 already install new...


Check compression in number three. You could have bought a bad engine. And yes. You need to change every sensor. If they don't match with the plugs. replace the engine. There is a reason for different engine codes. You should have stuck with them.

Jul 25, 2015 | Cars & Trucks

1 Answer

Old '87 ranger been sitting in folks yard few years. fires up fine, but spits and sputters going down the road


Old fuel in tank, fuel filter clogged, plugged/clogged carb. or fuel injectors.

1. Drain fuel from tank and replace with new fuel with SeaFoam or Lucas

2. Repace fuel filter

3. With engine running at a high idle and air cleaner off, spray or pour carb/fuel injection cleaner into carb/fuel injectors.

If problems persist, check plug wires for cracks and/or breaks. Pull spark plugs checking for fouling.

Apr 09, 2011 | 1987 Ford Ranger

1 Answer

Ford ranger #4cylinder misfire, 4.0/ v-6 already changed plugs, wires& coil pack.


the misfire may be caused by a fuel injector that is not working. Do you have a good spark at that cylinder?. If so try the redneck approach to fixing a stuck fuel injector. first make sure the fuel injector plug is clean(terminals) and on tight. With the engine running, Take a long socket extension and place an end on the fuel inector plastic housing, tap on the other end with a hammer. LIGHT taps!!! remember its just plastic! sometimes this is enough to free up a stuck injector. If not, then replace the injector.

before you do this Unplug the injector and see if the engine idle changes. Also check for an electrcal pulse at the injector plug with engine running.

Nov 03, 2010 | 1998 Ford Ranger SuperCab

1 Answer

No spark or current from ignition coil


possibly the flex fuel sensor- its on the frame rail just behind the drivers door- check the conector and connections on the sensor itself.

Jun 03, 2009 | 1999 Ford Ranger SuperCab

2 Answers

Truck stalls while driving, will start again if wait ten minutes


if it is a flex fuel vehicle, it most likely is the flex fuel sensor and/ or connector- it's located on the driver's framerail just behind the door.hope this helps and good luck

May 29, 2009 | 2005 Ford Ranger

1 Answer

Fuel rail noise


You may be hearing the pressure regulator that is relieving the pressure on the rail and returning it to the tank.

Mar 19, 2017 | 1999 Ford Ranger SuperCab

Not finding what you are looking for?
1999 Ford Ranger SuperCab Logo

Related Topics:

165 people viewed this question

Ask a Question

Usually answered in minutes!

Top Ford Experts

yadayada
yadayada

Level 3 Expert

74311 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22082 Answers

fordexpert

Level 3 Expert

5426 Answers

Are you a Ford Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...