Spark plug firing order and plugs number location on engine to mazda

Question edited for clarity and spelling.
Question mode to model category.

Mazda Tribute 2001-06 Firing Orders Repair Guide

AutoZone https://www.autozone.com > diy > mazda-tribute-2001...
3.0L engine Firing order: 1-4-2-5-3-6 Distributorless ignition; Fig. Coil and spark plug arrangement-2.3L engine; Fig. 2.0L engine Firing order: 1-3-4-2 ...

Mazda Tribute

mazdabg.com https://www.mazdabg.com > 9308CH10_Mazda_Tribute
Mazda Tribute. Fig. 14: 2.0L (VIN B) Engine Firing order: 1-3-4-2 Distributorless ignition system. Fig. 15: 3.0L (VIN 1) Engine Firing order: 1-4-2-5-3-6 ... Pictures

https://www.google.com/search?q=2001+Mazda+Tribute.+Firing+order

Which engine do you have in the vehicle? They fitted them with an in-line four cylinder and a V6. The firing orders are different for each version. I'm assuming the distributor has NOT been removed and is set correctly!
**Note, Take your time to make sure you get this right!**
The Four cylinder is the standard 1,3,4,2, firing order with number One being the nearest cylinder, (spark plug), to the belts and pulleys on the engine. Use the plug leads as a guide as they should be four different lengths. The longest plug lead to the spark plug furthest away, shortest to the nearest spark plug.
With the distributor cap removed make sure the engine is at Top Dead Centre for cylinder One. Check where the metal tip on the rotor arm is pointing as this is where the plug lead for Number One should go.
Refit the the distributor cap and insert the lead for the Number One spark plug into the hole nearest where the rotor arm tip was pointing. Now refit the remaining 3 plug leads in the Correct Order, (1,3,4,2,) into the remaining 3 outside holes in a CLOCKWISE direction. The centre hole should connect to the coil pack lead.
A V6 engine uses the same setup BUT a different firing order. (See photo). 1,4,2,5,3,6. In the photo numbers 1 and 4 are nearest the belts and pulleys.
Set your distributor as you would for the four cylinder engine, fit plug lead one and going CLOCKWISE fit them as the 1,4,2,5,3,6 sequence.

Here's the information you are looking for:

Firing order 1-4-2-5-3-6
Location:
1 - 2 - 3

4 - 5 - 6
Front of Engine

Hello Mohamed...It depends on the type of motor in your Mazda.

This may help (If you have the six cylinder engine)


FIRING ORDER FOR MAZDA 6 3 0LITER 2003 Mazda Mazda6

theres no distributor and the firing order for your 3.8 is 1-6-5-4-3-2-the following link shows the coil pack
Buick General Motor 3800 V6 Engine Firing Order DIS IDI ignition timing 3.8 Buick Engine Coil Pack Firing Order Spark Plug Wire Location Which way do the spark plug wires go on & what cylinder is what?
.
For the Buick V6 231 3.8 liter turbocharged engine:
.
Answers!
.
Firing order:
1 - 6 - 5 - 4 - 3 - 2.
.
Spark plug wire location on coil pack:
.
Closest to the back of the car, left to right: 1 - 5 - 3.
Closest to the front of the car, left to right: 4 - 2 - 6.
.
Spark plug wire location on engine:
.
drivers side, front to back of car: 1 - 3 - 5.
passenger side, front to back of car: 2 - 4 - 6.
.----and this link shows the coil pack to cylinders
.
3 8 Buick Turbo Engine Coil Pack Firing Order Spark Plug Wire Location

The cylinder order is 1,2,3 (rear row, left-to-right) and then 4,5,6 (front row, left-to-right).
When replacing spark plug wires or plugs, it's very helpful to do one at a time to avoid connecting them incorrectly.
Hope this helps, Sherwin

The non-turbo 2.2 Liter engine?
6 Degrees.
Should be on your Emissions label under the hood.

(Firing Order is 1-3-4-2. Front of the vehicle is Number 1 spark plug. Distributor rotation is -> Counterclockwise. Spark plug gap is .044
44 thousandths of an inch)

Turbo 2.2 Liter engine?
9 Degrees. Emissions label is under hood.

(Firing Order is 1-3-4-2 Front of vehicle is Number 1 spark plug. Distributor rotates ->Counterclockwise. Spark plug gap is .044)

If it's the four cyl., the first coil pack bolts over the #2 spark plug. The #2 coil pack wire plugs into #3 spark plug. The number two coil pack bolts directly over the number four spark plug, and the #2 coil pack wire plugs into the #4 plug. The firing order is 1-4-2-3.

The firing order on all four cylinder engines is 1.3.4.2. and number one cylinder is at the opposite end of the engine to the gearbox, at the end with the belts and pulleys.