Question about Hyundai Tiburon

1 Answer

I am puting in a new block heater into my 2001 Hyundai Tiburon since it never came with one. I was wondering if someone had a picture of this or could tell me how I could do it. I am a little unsure where it is on the engine. After I know where it is I can take it from there. Thanks.

Posted by on

1 Answer

  • Level 1:

    An expert who has achieved level 1.

    Hot-Shot:

    An expert who has answered 20 questions.

    Corporal:

    An expert that hasĀ over 10 points.

    Mayor:

    An expert whose answer gotĀ voted for 2 times.

  • Contributor
  • 53 Answers

The block heater goes in the firewall side of the engine. There is what is called a frost plug there (actually there is more then one) locate the one next to the ac compressor that is the plug u must remove to install the block heater ( the frost plug is the second one from the front of the engine)

Posted on Oct 18, 2008

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Can you put a 1998 Transmission in a 2000 Hyundai Tiburon


25402423-wgliprilfu5r4kryfc4mevsd-4-0.jpg
HMA/HAC shows a span of 1996-2001 Transmissions, there are a few different options to choose from, Depending on motor size, and year, The picture enclosed shows all manual transmissions. Hopefully this helps you.

Feb 06, 2015 | Hyundai Motor 2000 Tiburon

1 Answer

Hyundai tiburon heater core installation


Usually you pull the hoses off the core at the firewall, under the hood.

Feb 15, 2013 | 2003 Hyundai Tiburon

1 Answer

2001 hyundai tiburon front heated seats not working


Cars.com does not have NHTSA crash-test ratings for the 2001 Hyundai Tiburon. Ratings may be available for other styles.
if you need an auto tool you can click here : chinasinoy.com
hope it can help you and good luck

Nov 12, 2012 | 2001 Hyundai Tiburon

1 Answer

How to change a heater core on 2001 hyundai tiburon?


Inspect/Replace If it is necessary to remove the heater assembly, the cooling system must be drained before removing the heater core.
When a heater core leaks, a new heater core is installed or the old one repaired.
Heater Housing
  • The heater housing is usually under the dash and must be removed to gain access to the heater core.
  • Procedures for replacing the heater core vary with the year, make, and model of car. It threfore necessary to consult the manufacturer's repair manuals for the proper procedure for replacement.
f74-01.gif The heater housing is disassembled to get to the heater core. Heater Core
  • Remove the access panels(s) or the split heater/air conditioning case to gain acess to the heater core.
  • Remove the heater coolant hoses.
  • Remove the cable and/or vacuum control lines (if equipped).
  • Remove the heater core securing brackets and/or clamps.
  • Lift the core from the case. Do not use force. Take care not to damage the fins of the heater core when removing.
  • To reinstall the heater core, reverse the removal steps.
When the heater core leaks and must be repaired or replaced, it is a very difficult and time-consuming job primarily because of the core's location deep within the firewall of the car. For this reason always leak test a replacement heater core before installation.

Dec 08, 2010 | 2001 Hyundai Tiburon

1 Answer

How often do i need to change the oil in my 2001 hyundai tiburon


Hyundai,for all of Europe, say every 10,000 miles or every year and use 10/40 semi sythetic oil with a new filter.

Sep 13, 2010 | 2001 Hyundai Tiburon

2 Answers

Did they make a repair manual for the 2001 Hyundai Tiburon ??


There are several sources from which to get your owner's and service manuals, including going to the manufacturer of the car, and these:

http://yourhandymanzone.com/Your_Handyman_Zone_How_To_Pages_Vehicle_Car_Zone_Cars_Trucks_Vans_Owners_Manual_Lost_Need_Replacement.htm

May 25, 2009 | 2001 Hyundai Tiburon

1 Answer

Change water pump on 2001 hyundai tiburon


It is a 2.0L (the delta blocks weren't in tibs until '03). You have to remove the timing belt tensioner, and then you can remove the bolts for the water pump. I would strongly recommend not only taking careful precaution not to disturb the orientation of the gears in this process, but also to replace the timing belt and water pump at the same time. You don't want to go through this process all over again do you?

Apr 06, 2009 | 2001 Hyundai Tiburon

1 Answer

Need to replace my right front fender fo my 2003 hyundai tiburon


try www.autozone.com to see if they have your car listed for diagrams pictures and step by step instructions if your car is not listed then try your local library they have all the car manuals and even copy them for you

Mar 20, 2009 | 2001 Hyundai Tiburon

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

407 people viewed this question

Ask a Question

Usually answered in minutes!

Top Hyundai Experts

yadayada
yadayada

Level 3 Expert

60667 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

21936 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

6811 Answers

Are you a Hyundai Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...