Question about 1985 Ford Bronco

1 Answer

1985 ford bronco

After driving for 5 or10 minutes headlights begin to blink off and on, help please

Posted by on

  • Anonymous Apr 20, 2009

    Can't seem to figure out the wiring diagram for the heater blower on a 1985 ford bronco.

  • tony yeatman
    tony yeatman May 11, 2010

    Have you checked immobiliser and/or indicator issue



1 Answer

  • Level 2:

    An expert who has achieved level 2 by getting 100 points


    An expert that gotĀ 5 achievements.


    An expert whose answer gotĀ voted for 20 times.

    Night Owl:

    An expert who has answered 10 or more questions between 12 midnight and 6am on the same day.

  • Expert
  • 84 Answers

Most likely the alternator is going out. check the voltage with a meter it should read about 14v
or take it to a shop and ask them to check it

Posted on Feb 17, 2010


1 Suggested Answer

  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

a 6ya Mechanic can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repair professionals here in the US.
click here to Talk to a Mechanic (only for users in the US for now) and get all the help you need.

Posted on Jan 02, 2017


Add Your Answer

Uploading: 0%


Complete. Click "Add" to insert your video. Add



Related Questions:

1 Answer

Unsecure hood

When you open the hood on each front corner above the headlights are ajustment bolts that should have a black rubber top on them. try to asuts them up a little at a time untill the hood stops rattling around

Mar 10, 2014 | 1985 Ford Bronco

1 Answer

1986 f150 lights flicker

This problem is caused by a burnt headlight switch and the headlight switch connector. Pop the panel out and remove the switch, you will see the contact blades which should be a bright brass color are burned looking. The headlight switch and the connector are available from most parts stores like Carquest and Napa and the Ford dealer of course. When you install the repair connector do one wire at a time, solder the connections and shrink tube them. YOU MUST REPLACE BOTH PARTS

Nov 05, 2012 | 1986 Ford F150 SuperCab

1 Answer

I am looking to replace the tranny in my 1986 bronco 2. what other bronco 2 year models will fit?

well first off which tranny do you have?? if the vin code is T it is automatic-A4LD, which was used in the years of 1984-1990 if you have a manual tranny then it might be one of these two.. toyo koygo tk5 vin code is 5 which was used in the years of 1985-1987, they also used a mitsubishi FM145 vin code D in the years of 1985-1987 hope that helps..

Nov 16, 2010 | 1986 Ford Bronco II

1 Answer

Can I tow a 1985 ford bronco II 4x4 with hubs and a 5 speed manual trans. without disconnecting the drive line

yes if you make sure the front hubs are disengaged(turn little hub releases in middle of the wheel,man trans is ok auto not ok you do need to remove the drive shaft of an auto not man

Oct 26, 2009 | 1985 Ford Bronco II

2 Answers

1985 ford bronco 11 has loud sqeeling noise after 15 minutes of running

sounds like you have a defective accessory drive belt or a locked up engine cooling fan clutch whioch causes the belt to slip, more so cold..

Oct 19, 2009 | 1985 Ford Bronco II

1 Answer

Where is he starter in 1985 ford bronco 2 at

oh i get it, the starter is at the bottom rear of the engine where it mates to the transmission bell housing, u must get under the truck to see it, it is no the drivers side i believe.

Oct 01, 2009 | 1985 Ford Bronco

1 Answer

What size bolt

if you have a good place that sells only truck parts only stop by there they can help you with the leveling kit and the bolt extenders you need here is a place truck and van specialties the website is and the toll free # 1-866-272-8407

Feb 13, 2009 | 1985 Ford Bronco II

1 Answer

Spark plug and cap wiring for 1985 ford bronco 2

When your facing the front of your bronco looking into engine compartment, on left hand side in sequence is 1, 2, 3 front to back. on right hand side it's 4,5,6, front to back. The distributor rotates clockwise. On the top of the distributor, is 1-4-2-5-3-6 starting at the little mark on the cap or TDC. Hope that helped.

Jan 04, 2009 | 1987 Ford Bronco II

1 Answer

Help me please

Yes, they can. As long as the engines in both cars are the same. The Ranger and Bronco II are essentially the same truck and mechanical parts are interchangable between the 2.

Aug 23, 2008 | 1985 Ford Bronco II

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

98 people viewed this question

Ask a Question

Usually answered in minutes!

Top Ford Experts


Level 3 Expert

77499 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22306 Answers


Level 3 Expert

5623 Answers

Are you a Ford Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides