An expert who has achieved level 2 by getting 100 points
An expert that got 5 achievements.
An expert whose answer got voted for 100 times.
An expert that has over 500 points.
Re: Peugeot Expert 2005 locking problems
Open your key pad again, and you will see hte little connector that the battery touches, take a small screw driver or a butter knife and gently pull the tab up some, it is common for them to get mashed down from pushing on the key pad.....
- If you need clarification, ask it in the comment box above.
- Better answers use proper spelling and grammar.
- Provide details, support with references or personal experience.
Tell us some more! Your answer needs to include more details to help people.You can't post answers that contain an email address.Please enter a valid email address.The email address entered is already associated to an account.Login to postPlease use English characters only.
Tip: The max point reward for answering a question is 15.
put key in icnition turn on but don"t start engine,press door lock and hold for a few seconds,then turn off,key fob should now work,if not try again,also make sure you have the correct battery in key fob.
put the van on full lock to the left, look under the L/H wheel arch in front of the wheel, just in front of the drive shaft you will see a tin cover held on by 13mm headed bolts, on the back row the tin is cut away a little way up is a bigger bolt head (maybe 16mm) that is the fill plug.
I have done this procedure for my peugeot 307, but you can give it a try for your Pug expert and let me know if it works.
Disconnect the battery for 5 minutes then after connecting the battery perform the following steps
1. Turn the Ignition switch to the ON position using your key.
2. Press the LOCK button for 10 seconds. It will set your ECU in programming mode.
3. Remove the key and wait for 10 seconds.
4. Press the buttons on the key repetedly for operation (lock und unlock doors) to synchronise the key signals.
5. Again turn the ignition on and start the engine.
6. Turn the ignition OFF
If fails in step 4, then disconnect the battery and reconnect it and wait about 10 minutes to check the remote. Some new ecu units synchronises itselfs if you disconnect the battery while in programiing mode.
Had same trouble with my 406, fixing no problem, with new battery in fob, insert into ignition, turn key, BUT DO NOT START ENGINE, hold button for about 10 seconds release button and remove key from ignition, then try and see if doors lock on remote, if not try again, had to do this a couple of times, and it worked, sorry to say that now my key fob button has completely fell apart, through ware and tare