Question about 1996 Ford F350 Crew Cab

1 Answer

No start will excess fuil in the cylinders cause an air lock in the fuil system

Posted by on

1 Answer

  • Level 2:

    An expert who has achieved level 2 by getting 100 points

    MVP:

    An expert that gotĀ 5 achievements.

    Governor:

    An expert whose answer gotĀ voted for 20 times.

    Hot-Shot:

    An expert who has answered 20 questions.

  • Expert
  • 41 Answers

NO, it will not cause an air lock in the fuel system. It can cause a hydraulic lock in the affected cylinder however. A leaking fuel injector or a leaking injector cup can allow air to enter the fuel system.

Posted on Nov 10, 2008

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

2 Answers

Why the spark plug keeps burning after a couple of days.Then i renew it and it will happen again.


does it start every time
check list
running hot
too much revs and load
fuel mixture too rich /lean
coil problem
burnt valve
burning oil




26228526-035vjdxxs0ku3tdpzp0izks4-1-0.jpg

Jun 30, 2016 | Cars & Trucks

1 Answer

Excessive exhaust smoke


You may have a broken ring or scored cylinder wall and piston. Have a cylinder leak down test performed to confirm this. Other causes can be a plugged crankcase ventilation system causing pressure to build in the engine, if that is the case the air cleaner box should have oil in it. The grey color of the smoke means you are burning a lot of oil.

Mar 14, 2014 | Mercedes-Benz Cars & Trucks

1 Answer

Having problem starting my truck, security light is on most of the time it happens, can move around relays under hood, then it will start till i shut it off then have to move fuil pump relay around ag


The security light is a visual indication that something in the car's antitheft system is failing. In most GM cars and trucks there is a hidden system that most people are unaware even exists. From the moment you put your key in the ignition, there begins a constant line of communication between your key's security chip or transponder, to the ignition's lock cylinder, and then to the car's TDM (Theft Deterrent Module). These 3 parts are in CONSTANT communication. If the key is in the ignition, then these parts are sending signals to each other. The security light illuminates when that signal gets broken, even just for a second. When the signal breaks, the car misinterperates this as an attempt at theft and goes into antitheft mode. The car thinks its being stolen or hotwired because it is not getting that signal from YOUR specific key. This is why the security light turns on and shuts down your vehicle. This link explains it pretty well.
http://vatspasslockpasskeysecurityhelp.yolasite.com/

Mar 25, 2013 | 1999 Chevrolet Silverado 1500

2 Answers

What does error code p0172 and p0174?


P0172 - Fuel Injection System Too Rich Bank 1 Symptoms - Engine Light ON (or Service Engine Soon Warning Light)
- Excessive Fuel Consumption
Possible causes - Intake air leaks
- Front Heated oxygen sensor may be faulty
- Injectors may be faulty
- Exhaust gas leaks
- Incorrect fuel pressure
- Lack of fuel
- Mass air flow sensor may be faulty
- Incorrect PCV hose connec
Possible solution Dirty air filter of faulty air flow sensor are common causes of the problem.



P0174 - Fuel Injection System Too Lean Bank 2 Symptoms - Engine Light ON (or Service Engine Soon Warning Light)
- Excessive Fuel Consumption
Possible causes - Intake air leaks
- Front Heated oxygen sensor may be faulty
- Injectors may be faulty
- Exhaust gas leaks
- Incorrect fuel pressure
- Lack of fuel
- Mass air flow sensor may be faulty
- Incorrect PCV hose connection
Possible solution Dirty air filter of faulty air flow sensor are common causes of the problem. Bottom line possible defective Mass airflow sensor and or O2 sensor in cylinder bank number two.

Feb 21, 2011 | 1998 Ford Expedition

2 Answers

Has gas to fuel rail,fire to spark plugs.Will not start...timing belt not broken. code reader showing an P 1131 code.


P1131 -1. Misfire on bank 1
2. Vacuum leak affecting bank 1
3. Fuel injector problem bank 1

P1130 - 1. Fuel pressure high or low
2. MAP sensor dirty/defective
3. Vacuum leak on engine
4. Leaking fuel injector or fuel pressure regulator

Dec 16, 2010 | 1998 Ford Escort

2 Answers

I've changed the oxygen sensor and the O2 sensor and new plugs on my 97 dondge 3.9 van and it still blowen black smoke (rich) seems to run real good on top end but theres is a flat spot where theres no...


Black smoke indicates no air, check your air filter, if you have done that and it is ok, check the PCV valve. Thats about all that I can suggest. Hope that helps.

Dec 07, 2010 | 1996 Dodge Dakota

1 Answer

I have a 1997 nissan sentra that wi have a 1997 nissan sentra that wont pass emisions fuil system lean bank1 p0171 code so i changed the maf sensior,fuil pressure reg, pcv valve, and all four fuil...


Have you checked your fuel pressure at the fuel rail? The problem could be a clogged fuel filter, pinched fuel line, or under-performing fuel pump (either faulty part, or not receiving enough voltage).

The only other thing I can think of that would cause the loss of power symptom and failing e-test would be a plugged catalytic converter, but that wouldn't likely cause the lean running.

Jun 27, 2010 | 1997 Nissan Sentra

1 Answer

How do i burp the air out of my gas 1997


oil in the air filter is caused by one of 3 things, excessive oil level in the crankcase or excessive engine cylinder leakage causing to much back pressure and blowing the oil up the and into the crankcase vent hose, this same condition can also be caused by a plugged Positive Crankcase vent system valve. (PCV for short)

Jan 19, 2010 | 1997 Volkswagen Jetta

2 Answers

I have a 2001 gmc sonoma with obd error codes p0410 p0300 p0100


P0410 Secondary Air System PerformancePossible Causes Setting Conditions AIR solenoid Ignition circuit is open (check the U/H IGN fuse) AIR pump has failed (inspect air pump for water) AIR system check valves and/or pipes are damaged or leaking AIR system hoses or lines are damaged, pinched or kinked Base engine problem (e.g., excessive exhaust back pressure) PCM has failed P0300 Multiple Cylinder Misfire DetectedPossible Causes Setting Conditions Base engine mechanical fault that affects one or more cylinders EVAP system problem or the EVAP canister is fuel saturated EGR valve is stuck open or PCV system has a vacuum leak Fuel delivery component fault that affects two or more cylinders Ignition system fault (a coil) that affects more than one cylinder

Jun 08, 2009 | 2001 GMC Sonoma Extended Cab

2 Answers

Problim starting


check your mass air flow sensor. There is a thin filliment in it check to see if it is dirty.

Mar 18, 2009 | 1994 Chevrolet S-10 Blazer

Not finding what you are looking for?
1996 Ford F350 Crew Cab Logo

Related Topics:

120 people viewed this question

Ask a Question

Usually answered in minutes!

Top Ford Experts

yadayada
yadayada

Level 3 Expert

60769 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

21949 Answers

Fordexpert

Level 3 Expert

5331 Answers

Are you a Ford Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...