- If you need clarification, ask it in the comment box above.
- Better answers use proper spelling and grammar.
- Provide details, support with references or personal experience.
Tell us some more! Your answer needs to include more details to help people.You can't post answers that contain an email address.Please enter a valid email address.The email address entered is already associated to an account.Login to postPlease use English characters only.
Tip: The max point reward for answering a question is 15.
You can try hitting the bottom of the door panel, if the motor brushes are the problem it may start working again, for awhile.. If not you need to replace the window lift motor and most likely the regulator with it.
There are 2 screws just above the door handle you need to remove. Remove the plastic trim around door handle. Then starting at bottom of door panel pull out to disengage the push pin clips and work your way up both sides of panel. Then lift up on door panel to disengage the weatherstip on top of panel.
You did not mention whether it was a front or rear door? I assume its a front because u stated no screws.
Here are instructions for front door:
Remove the plastic trim from behind mirror(just snaps on).
Remove the window switch panel(just snaps on).
Remove the screw behind the mirror cover.
Remove the screw behind the window switch panel.
Remove the courtesy lamp lens.
Remove the screw in the courtesy lamp housing.
Remove the inside door handle trim cover.
Remove the inside door handle bolt.
Lift upward and then outward to remove the front door trim panel
alot of cars and mount door panels the same ways . if look were fingers grab the door to close it and were arm rests you will see small plastic plugs remove the plugs and you will see screws remove the screws. also were the widow swicth is remove and look behind it . also open door all up and look in door jam for other fasteners when all screws are removed then trie to pull at bottom of panel while pulling look between door and panel some cars pull out and some cars lift up . once u get loose then u lift up to remove from sill of door. then disconnect any electrical connectors. sounds like window linkage hitting door handle linkage inside the door.