My doge caravan 2000 driver side signal not working keep burning the light soon i put it in it will work about few hr or day then just burn not only burn it crack the light bulb in half plz help what can i do to solve this problems
An expert who has achieved level 2 by getting 100 points
An expert that got 5 achievements.
An expert whose answer got voted for 20 times.
An expert who has written 20 answers of more than 400 characters.
Re: side signal driver side
What your describing sounds like incorrect bulb positioning. If the socket is not located correctly then water can enter the light housing and blow the bulb, sometimes in pieces. This is the only condition that a bulb blows to pieces, when a hot bulb meets water. If needed remove the entire lamp assembly to make sure it is properly located in the socket. Good luck.
- If you need clarification, ask it in the comment box above.
- Better answers use proper spelling and grammar.
- Provide details, support with references or personal experience.
Tell us some more! Your answer needs to include more details to help people.You can't post answers that contain an email address.Please enter a valid email address.The email address entered is already associated to an account.Login to postPlease use English characters only.
Tip: The max point reward for answering a question is 15.
Yes - the fast flashing is a warning that a bulb is burned out. Change the bulb (be careful to put it in the same as the old one as it probably is 2 bulbs in one , parking and turn/stop) and you should be fine.
The oil doesn't leak from the head gasket, Unless it is broken. The oil is inside the engine, the head gasket seals out the water from the cylinder walls, and keeps the compression in. No oil, It could be coming from the rocker cover gasket just above the heads. They always leak. The engine sits at a slight pitch to get the oil out and down. And it usually leaks at the rear the most. Changing those gaskets is a job, you have to remove everything up top of the engine to get to them, then seal up the spark plugs too if they are in the covers. I did mine a few years back and they are just starting to leak again. It only has 250,000 miles, go figure. Check it out, hope this helps.
It happened to my 98 Intrigue. It stopped as soon as I changed the sockets. It is very simple to do this, just pull it out the the plug from the connector about 4 inches from the socket. I got used ones at the junk yard, 2 bucks a piece. Been working fine for almost 2 years.
there should by a small pully (called a tentioner) under the alternator pully, get a wrench that fits the nut in the middle and turn it counter clockwise this will loosen the belt to get it around the other pully. Ps. this is easier with two people, one to release tention and one to put the belt on.