Question about 1996 Isuzu Rodeo

1 Answer

96 isuzu 4wd 3.2 motor

The car starts , but if you shut it off it takes 5 times turning it over again is it the battery ,or thestarter help if you can much appriciated thanks

Posted by on

1 Answer

  • Level 2:

    An expert who has achieved level 2 by getting 100 points

    MVP:

    An expert that gotĀ 5 achievements.

    Governor:

    An expert whose answer gotĀ voted for 20 times.

    Hot-Shot:

    An expert who has answered 20 questions.

  • Expert
  • 92 Answers

If the engine turns over fast enough it is not the batt or starter.do you perform regular services like oil and filter changes.check fuel filter for restrictions,pull a spark plug and check plug condition and gap.you may just need a tune up.use good NGK spark plugs not cheap ones,when it comes to ign sys cheaper is not better,but dont get hosed,check around for price.

Posted on Oct 21, 2008

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Does anyone know how to reset the service reminder on a 2015 isuzu d-max 2.5 twin turbo?


I would ask the dealer to do this but here is what I show to get the light reset. This is courtesy of expert Techmecho

If the tech 2 device is indicating the code for 4wd module then it has to be replaced.Get the module and its connections checked before going to replace the module.If the module connections are getting short or loose then getting the connections repaired solves the problem.But most probably when it shows module problem,the module has to be replaced.The actual testing procedure is as follows:--- If you have an ODBII code reader, you can check if there are any codes stored in the ECU. There is also a diagnostics mode you can go into for transfer case issues:

1. Warm up the engine. Turn it off.
2. Turn the ignition switch on and off at least twice, then turn the ignition switch to off.
3. Shift into park.
4. Turn the 4WD selector to Auto.
5. Turn the ignition switch to on. Do not start engine.
6. Is the 4WD warning lamp on? Continue if no.
7. Shift into reverse.
8. Turn the 4WD selector to 2WD, Auto, 2WD.
9. Shift into drive.
10. Turn the 4WD selector to 4H, Auto, 4H.
11. Shift into neutral.
12. Turn the 4WD selector to Auto.
13. Shift into park.
14. The 4WD indicator light will come on for 2.5 seconds, then go out. It will then flash a series of times to represent a one or two digit code, with half-second delays within a number and 1 second delay between numbers. e.g. to represent the code 23, it will flash twice with 0.5 seconds between flashes, wait a second, then flash three times with 0.5 seconds between them.Get it rechecked again by disconnecting the 4wd module and reconnecting again,. --------------------Thank you.

May 12, 2016 | Isuzu Cars & Trucks

4 Answers

What is the solution for the durango turning off while driving? mine-2000 5.9 4wd


I would take it to an autoparts store that does a free 'code scan' and see if the computer has captured the failure. I suspect this is computer related issue so the code(if any) could be misleading. Had an 90's model New Yorker in the 90's shutting down for no reason and replacing the computer fix it.

That said a battery getting old (most commonly) or something in the electrical system not working correctly can cause a good computer to malfunction. Have the battery tested as well or switch to known working battery.

Jun 02, 2014 | 1999 Dodge Durango

1 Answer

My 96 isuzu drove fine then i stopped turned off engine for 5 min started back up started to go and it just stopped shut down in the middle of traffic.it turns over, timing belt seems to be okay mine is...


Q: What would cause my 1996 Isuzu Rodeo, 6 cyl. ... Can you help me to help it???...or should I just shoot it and put it out of it's misery?? write back ... Then one day I started the car up and I let down the power windows and was .... The problem is the radio...have to turn the radio on and off as many as 20 times before it will. ...

Sep 22, 2011 | 1996 Isuzu Rodeo

1 Answer

My isuzu dmax 4x4 manual (year model 2004) have a problem . . . "CHECK 4WD" warning light is always on. isuzu service shop tells me that the 4wd module and actuator needs to be replaced upon...


If the tech 2 device is indicating the code for 4wd module then it has to be replaced.Get the module and its connections checked before going to replace the module.If the module connections are getting short or loose then getting the connections repaired solves the problem.But most probably when it shows module problem,the module has to be replaced.The actual testing procedure is as follows:--- If you have an ODBII code reader, you can check if there are any codes stored in the ECU. There is also a diagnostics mode you can go into for transfer case issues:

1. Warm up the engine. Turn it off.
2. Turn the ignition switch on and off at least twice, then turn the ignition switch to off.
3. Shift into park.
4. Turn the 4WD selector to Auto.
5. Turn the ignition switch to on. Do not start engine.
6. Is the 4WD warning lamp on? Continue if no.
7. Shift into reverse.
8. Turn the 4WD selector to 2WD, Auto, 2WD.
9. Shift into drive.
10. Turn the 4WD selector to 4H, Auto, 4H.
11. Shift into neutral.
12. Turn the 4WD selector to Auto.
13. Shift into park.
14. The 4WD indicator light will come on for 2.5 seconds, then go out. It will then flash a series of times to represent a one or two digit code, with half-second delays within a number and 1 second delay between numbers. e.g. to represent the code 23, it will flash twice with 0.5 seconds between flashes, wait a second, then flash three times with 0.5 seconds between them.Get it rechecked again by disconnecting the 4wd module and reconnecting again,. --------------------Thank you.

Jan 24, 2011 | Isuzu Pickup Cars & Trucks

2 Answers

I have a 97 Toyota Avalon XLS that won't start, had a new battery installed, still makes clicking sound when I try to start. After a few tries it may or may not start.


hi it does sound like the starter is stuck, there could be a way to free it and find out for sure if it is u/s, what you have to do is, locate starter on your vehicle, depending on its location you can try tapping it with a small hammer or a long bar of sorts, at the same time get someone to turn the ignition at the same time while you are tapping the starter, this should free the solenoid and then thestarter should work, if it does, turn the motor off, and try again and see if it works if it does your ok, if not then try the above again, if you have to do it every time you turn the motor off then you will need to replace your starter....hope this helps please vote thanks

Jun 03, 2010 | 1999 Toyota Avalon

1 Answer

Isuzu B/horn 3.0 hard start.


for this problem only 3 cause would be there.
1 check your battery -ve (body earthing) is it properly tighten and end of wire is soldered .
if ok
2 take one trail for 3 to 4 hr. with another service battery, if you found the problem is solved then replace battery.
if not then last possibility is
3 check starter motor may problem with armature and carbon bursh, replace that.

Jan 27, 2010 | 1996 Isuzu Trooper

1 Answer

Not starting


maybe the ecm?

May 26, 2009 | 1996 Isuzu Rodeo

1 Answer

Electrical ?


I have a '96 tahoe. Look for a code on the battery to see when it was installed. L09 would be december 09. if it is less than 3 years old have it charged and then try.

Jan 09, 2009 | 1995 Chevrolet Tahoe

2 Answers

Shifting into 4wd


pull out your courtesy lamp and ATC fuses for 1 minute then reinstall then cycle key on and off 5 times this will reset the 4x4 computer and should fix your problem. and for that question by boscia they do not have locking hubs manual or automatic.

Dec 02, 2008 | 1999 Chevrolet Blazer

Not finding what you are looking for?
1996 Isuzu Rodeo Logo

Related Topics:

177 people viewed this question

Ask a Question

Usually answered in minutes!

Top Isuzu Experts

yadayada
yadayada

Level 3 Expert

60960 Answers

Steve Hurc
Steve Hurc

Level 3 Expert

450 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

21949 Answers

Are you an Isuzu Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...