The brake rotor needs to be removed, drive shaft nut in center of hub then 3 bolts hold the hub assembly to spindle from back side. if it has abs unplug it then some work will need to be done with a hammer and chisel to work the bearing out of spindle and axle shaft from bearing
- If you need clarification, ask it in the comment box above.
- Better answers use proper spelling and grammar.
- Provide details, support with references or personal experience.
Tell us some more! Your answer needs to include more details to help people.You can't post answers that contain an email address.Please enter a valid email address.The email address entered is already associated to an account.Login to postPlease use English characters only.
Tip: The max point reward for answering a question is 15.
The bearings on a LeSabre are part of the hub assembly. The hub and bearing will have to be replaced as a unit. To do this you'll need to raise the car, remove the wheel, remove the caliper guide bolts, lift and support the caliper-I use a bent metal clothes hangar to support. Do not loosen the brake line. Slide the brake rotor off the lugs. Disconnect the electrical connector for the antilock brake system. The connector is behind the wheel. Then remove the four bolts holding the hub assembly. The bolts are behind the wheel. Be sure to hold the hub while removing. To install reverse the order. Be sure to check and tighten bolts to specifications when reassembling.