Question about 1999 Jeep Cherokee

1 Answer

Get power windows up manually

My power window on drivers side will not go up

Posted by on

1 Answer

  • Level 2:

    An expert who has achieved level 2 by getting 100 points

    MVP:

    An expert that got 5 achievements.

    Vice President:

    An expert whose answer got voted for 100 times.

    Sergeant:

    An expert that has over 500 points.

  • Expert
  • 475 Answers

Try hitting the door towards the middle of the door panel with your fist if it moves, you got a bad window motor (more than likely thats your problem).

Posted on Oct 22, 2008

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

The battery got disconected now windows dont work tried re program checked fuses nothing now what


You need to do a window reset. Its in your owners manual

This is a quote from the workshop manual

Note
? A driver side window will not fully close automatically under following the conditions:
? The battery has been disconnected during vehicle maintenance or for other reasons.
? The power window main switch connector, or driver-side power window motor connector has been
disconnected.
? Carry out the following procedure to resume operation:
1. Turn the ignition switch to the ON position.
2. Press the driver side power window main switch and fully open the driver side window.
3. Pull up the driver side power window main switch to manual-up position to fully close the driver side window,
and keep holding the switch up at the position for about 2 seconds to complete initial setting.

TWO-STEP DOWN FUNCTION OPERATIVE/NON-OPERATIVE SWITCHING PROCEDURE

Note
? By following the procedure below, the two-step down function is switched to non-operative when it is
operative, and to operative when it is non-operative.

Turn the Ignition on
Within 5 sec
perform the auto open two times
perform the auto close two times

turn the ignition off and within 40 seconds and repeat the above sequence.

Repeat for all the windows.

Aug 14, 2016 | 2007 Mazda 6 2.3

1 Answer

Why doesn't my 2000 chevy blazer power windows and door locks and remote mirror doesnt work. Power window on passenger side does work


well, the first thing is to check the fuses and or relay for power windows.should be listed in your owners manual. if ok, then remove switch from drivers side window and check for power. if power to the switch then use a jumper wire from power side to motor side of switch. if window works then its the switch causing the problem. Good-day!

May 04, 2014 | 2000 Chevrolet Blazer

1 Answer

Follow me here: The driver side passenger window will go up and down while operated independently with the switch on its door. However, the driver seat master switch will not control window to go down


Not following you completely.
When you say driver side passenger window, you mean the driver side rear window ?
The window motors get power thru a power window control unit and thru the driver master switch.
You'll need a shop manual with the wiring diagrams to track down the problem.

Feb 27, 2013 | 2005 Honda Pilot

1 Answer

Similar electrical issues with driver's side door controls. Power locks, power window, and power mirror on driver's side are not functioning. I can manually unlock the door, but the buttons on...


CHECK FUSES FOR POWER WINDOW,CHECK FUSE FOR POWER MIRROR AND CHECK FUSE FOR POWER DOOR LOCK.IF FUSE OKAY DOOR CONTROL MODULE FAULTY ITSELF.

Sep 11, 2011 | 2004 Saab 9-3

1 Answer

Power windows of RX 330 from driver side do not work


Did you change or unhook the battery? If so, the power windows can be reset. I believe this is in the manual as well.

reset passenger window by running it down all the way. then run it up and continue to hold the switch up for ~3 seconds after the window is all the way up. that should reset it so it works from the driver's side controls.

I was able to reset the rear windows the same way (I did flip the child lock on the door as well).

Feb 09, 2010 | 2004 Lexus RX 330

1 Answer

1999 Jeep Cherokee Sport How do you


I WOULD CHECK THE WIRING BETWEEN THE DRIVER'S DOOR AND THE POST..YOU WILL SEE A RUBBER BOOT BETWEEN DOOR POST AND DOOR..HAVE SEEN PARTIALLY BROKEN WIRES CAUSE ALL SORTS OF PROBLEMS HERE

Sep 03, 2009 | 1999 Jeep Grand Cherokee

2 Answers

Passenger Window Stuck all the way Down


Try switching the power window switch from the passenger side to the drivers side. Before you do that try with the switch on the up position, wiggle it from side to side. The contacts may be worn and by wiggling it may make contact. Other then that try to park it in side or garbage bag taped to keep rain out till you get it to the shop.
Hint, take it to a Auto window repair shop to replace the switch if it's bad or if the motor is bad. They have more experience to removing the door panels and removing the power window regulator (motor) if that needs to be replaced.
Good luck and hope this helps. 

May 30, 2009 | 1999 Dodge Caravan

1 Answer

2003 F250 Power Windows won't work


check fuses 35 & 41 (10 amp, red).
it also shows an accesory delay relay in the fuse panel.
And fuse 601? 30 amp.

make sure you don't have lock-out on driver switch panel activated.

Power Window System
Features and Operation
NOTE: The accessory delay feature will allow power window operation up to 10 minutes after the ignition is off or until a door is opened.
If equipped with power windows, the window control switch (14529):
  • will operate the power windows only when the ignition switch is in the RUN or ACC position.
  • is located on each front door trim panel, and Crew Cab and Excursion rear door trim panel.
  • may be used to raise or lower the driver side, passenger side and rear windows from the LF control on the driver side, or the passenger window from the passenger switch.
  • includes a one-touch down (OTD) feature for the driver door window.
  • can partially lower the driver side window when the LF window control switch is depressed half way (first detent).
  • will completely lower the driver side window when the LF window control switch is fully depressed and then released (second detent).
Power Window System — Modes of Operation
There are two modes of operation for the power window system.
Manual Mode
When the LH window control switch is pressed to the first down position, the window will move down until one of the following conditions are met:
  • The LH window control switch is no longer in the first down position.
  • The LH window control switch is pushed to the OTD position, causing the windows to enter auto mode.
Auto Mode
Auto mode provides the OTD feature. The OTD feature is activated when the LH window control switch, for the LH window, is pressed to the second down position.
Auto mode will be terminated when any of the following conditions are met:
  • The LH window control switch is pushed to the UP position.
  • The LH window control switch is released (OFF position) and then moved to the DOWN position (first detent) or OTD position (second detent).
  • Note: Delayed accessory feature must be active.
The OTD feature is controlled by the window control switch.

---------------------------------------------------------
Condition Possible Sources Action
  • All power windows are inoperative
  • Fuse(s).
  • Circuitry.
  • LF window control switch.
  • Accessory delay relay.

May 23, 2009 | 2003 Ford F250 Super Duty Crew Cab

Not finding what you are looking for?
1999 Jeep Cherokee Logo

Related Topics:

110 people viewed this question

Ask a Question

Usually answered in minutes!

Top Jeep Experts

yadayada
yadayada

Level 3 Expert

61249 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

21949 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

6812 Answers

Are you a Jeep Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...