My FOB is transmitting, but my 4Runner has no action from it. I have had the FOB tested, so I wonder about the receiver in the truck. Where is it located? I have been searching, and still can not find the actual name of the part or its location. Can someone help me?
Remote Entry Receiver is inside the back lift-door panel. Open the panel and check the receiver antenna (a wire hanging out from the receiver). Try to stretch out the antenna as far from the receiver as you can so the receiver gets the maximum range for signal receiving. Since you said you had the FOB tested and it worked fine, your signal transmission side is OK. The issue is at your receiver side. Good luck.
SOURCE: I have a toyota highlander (2002). It came with
Open the remotes up...Are the boards the same...?
SOURCE: 1997 Toyota Avalon Key Fob is not working
you can take it to a dealer and they can reprogram it for you.. good luck keith...
SOURCE: Keyless Remote 2008 RAV4
You can take it back to the dealer, and have them change the battery, or go to Autozone, buy the battery and do it yourself. They can show you how to do it. And which battery it takes. It's not hard to do. Good luck.
SOURCE: Toyota 4runner gate window, wiper, and keyless entry not working
make sure the back window is all the way up then try the wiper, if it still does not work then it is a sensor for the rear window (about $30.00) if you installed it yourself
I’m happy to help further over the phone at https://www.6ya.com/expert/john_5260ce46f2f674cc
SOURCE: Don't understand buttons on keyless entry remote fob.
If it is a factory remote it is either for the trunk release or the "panic" feature. Are the buttons not labeled?
2,375 views
Usually answered in minutes!
×