Question about 1995 Ford Ranger Supercab

2 Answers

1995 xlt ford ranger

High idle can you give me some ideas about what to do?

Posted by on

  • tknielsen Nov 28, 2008

    my 1999 ford ranger 6 cylinder idles erratic at initial start up on a cold morning, works fine after i rev it a bit and fine on the road. check engine light is on.

×

2 Answers

  • Level 1:

    An expert who has achieved level 1.

  • Contributor
  • 1 Answer

In my 1996 ranger xl my high idle problem was due to a bad ect sensor. After I replaced that I have had no problems with high idle. Not sure if yours is idleing high all the time like mine was but that sensor fixed the problem for me. Hope this helps!

Posted on Dec 23, 2008

  • Level 2:

    An expert who has achieved level 2 by getting 100 points

    MVP:

    An expert that gotĀ 5 achievements.

    Governor:

    An expert whose answer gotĀ voted for 20 times.

    New Friend:

    An expert that has 1 follower.

  • Expert
  • 55 Answers

Check for vacuum leaks and IAC codes stored in pcm

Posted on Oct 16, 2008

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Inside lights what fuse runs it


Keith, 1995 ford ranger, looks like interior light fuse is # 27, 10 amp. in interior fuse box panel and module #3 in under hood fuse/relay. Pg. 308 to 315 in the attached manual show fuse locations for all. Check the attached links,instruction and guides, Good luck
"I hope this helped you out, if so let me know by pressing the helpful button. Check out some of my other posts if you need more tips and info."
Ford Ranger 1996 2007 fuse box diagram USA version Auto Genius
Diagram of 1996 ford ranger fusebox which fuse is
Ford Ranger Owner Manual
1995 ford ranger xlt interior light fuse location Google Search

Aug 21, 2016 | Ford Cars & Trucks

1 Answer

Trying to bleed the brake system on a ford ranger xlt two wheel drive 1995 model year


Same as any vehicle you have ever done

Helper in the drivers seat & you open the bleeders

Nov 26, 2012 | Cars & Trucks

1 Answer

I have a 2002 Ford Ranger XLT pickup. During the holiday the truck sat idle for seven days. When I started it up again, the check engine light came on and truck would shudder while idling. And when I press...


The flashing engine light gives it away, it has a engine misfire. It needs to be checked with a scantool to see which cyl is misfiring, then see what is causing it, bad coil, injector, ect.

Jan 09, 2010 | 2002 Ford Ranger Regular Cab

1 Answer

2000 ford xlt 3.0 ranger, sudden intermitent idle problems


Study up on what an Idle Air Control Valve does then make your decision. They can be expensive.
Search fault symptoms

Nov 25, 2009 | 2000 Ford Ranger SuperCab

1 Answer

1995 ford ranger Xlt it idles like its missing but when i put in drive and drive off its fine i tried injector cleaners ran higher octane did wires plugs cap/rotor cheacked all the leads im hoping its a...


they have egr issues that cause that they also have valve issues that could cause that! i have replaced a few injector here and there also so i would start there and then go to the egr valve! and so on...

Sep 18, 2009 | 1995 Ford Ranger Supercab

1 Answer

My 1995 ranger rev's high on start up and takes a few seconds to slow down


Unplug the IAC motor when it's warm. It should be idling at below 500. If it is faster than this check for vac leaks. If non are found, adjust the base idle. Then plug the IAC back in and let the Idle stabilize. Now it should be about 800. Shut it off and try it again and see if it revs high.

Apr 25, 2009 | 1995 Ford Ranger Supercab

1 Answer

2000 ranger xlt supercab. idles high while driving


It sounds like you have a leak somewhere in your intake manifold. Have all hoses and seals checked. If the idle air control valve is malfunctioning it would cause the engine to idle high even after the engine is warmed up. Have it checked also.

Jan 10, 2009 | 2000 Ford Ranger SuperCab

1 Answer

1995 ford ranger coolant leak


frost plugs on the side of the block or something that you installed may have not sealed. can happen know the drill.

Jan 07, 2009 | 1995 Ford Ranger Supercab

Not finding what you are looking for?
1995 Ford Ranger Supercab Logo

Related Topics:

726 people viewed this question

Ask a Question

Usually answered in minutes!

Top Ford Experts

yadayada
yadayada

Level 3 Expert

60667 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

21936 Answers

Fordexpert

Level 3 Expert

5331 Answers

Are you a Ford Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...