Question about 1999 Ford F250 Regular Cab

1 Answer

Clutch pedel springs out

My clutch pedel way out further than normal and i cant get it back in and stay were it should be

Posted by on

1 Answer

  • Level 2:

    An expert who has achieved level 2 by getting 100 points

    Hot-Shot:

    An expert who has answered 20 questions.

    Corporal:

    An expert that hasĀ over 10 points.

    Mayor:

    An expert whose answer gotĀ voted for 2 times.

  • Expert
  • 68 Answers

Take off all paneling above the pedals and there should be a screw that u tighten to get it to go out that far,.put the clutch in where u want it but were itll stilll work and then tighten it and put everything back on hope that works

Posted on Nov 20, 2008

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

2 Answers

My clutch pedal stay close to the floor in my Acura CL. Doesnt return fully like it used too. Cant figure it out and I've replaced everythin


Bobbie, If your sure the system is bled properly,did you get the clutch fork back in correct position, was it the correct bearing etc., you may have to adjust the clutch pedal and / or if it has a mechanical return spring, change the spring, it could be weak.
Check the attached links,instruction and guides for clutch pedal adjustment., bleeding,etc.Good luck
"I hope this helped you out, if so let me know by pressing the helpful button. Check out some of my other posts if you need more tips and info."

Clutch Kit Installation Acura CL 2 2L 2 3L

Apr 02, 2016 | Cars & Trucks

1 Answer

My Nissan 95 sentra clutch had crunched and pedal would not spring back, found that clutch cable had snapped, replaced this and now my clutch pedal is still not 100% springing back, it springs back en


Check the spring to see if it has snapped anywhere within it's coil.

Remove the cable and check operation of the pedal and spring mechanism.
If all is well, then with a lever, check that the clutch release arm on the gearbox is operational. If that is also sticking, then you will have to remove the gearbox to investigate further.
If not sticking, then also remove the clutch cable outer sleeve, and replace.

Nov 10, 2012 | Cars & Trucks

1 Answer

Wont go into any gear after installing a new clutch kit


Either it was not installed properly or... your clutch linkage (cable) is stuck or too tight and not releasing the clutch all of the way.


Disconnect the clutch cable/rod from the clutch arm and see if you can move it or if when you remove it does it goes back further with the spring i.e. not seated with the linkage in place...? (you should feel the spring action of the clutch on the plate)
if it does spring back further the cable/rod linkage needs to be adjusted
Otherwise take it apart and reinstall. Also check the clutch pedal to make sure it did not become misalligned while it was diconnected.

Apr 08, 2012 | 1998 Nissan Sentra

2 Answers

I was parked on the side of the road in my ford ranger ute for about 3 to 4 minutes with the clutch pedal to the floor i was on the phone and then i could smell the clutch burning. I took my foot off the...


The clutch might be a hydraulic system. When it's leaking oil the pedal sticks to the floor and has to be pulled back manually. Because it's designed to be fail safe, it still works but only for some time till all the oil has leaked out.

The burning smell might be clutch oil dripping on the exhaust - meaning the seal on the clutch servo is leaking oil.

There are repairkits for clutch servo's - usually it's suggested to replace the cylinder seal on the clutch pedal also.

Jul 01, 2011 | Ford Ranger Cars & Trucks

3 Answers

The clutch peddle will not come up it stays on the floor


Check on the upper part of the pedel to see if the clip that connects the pedel to the clutch master cylinder has poped off If the clutch pedel is on the floor this is a likely sulition and relitively easy repair you just reattach the clip

Nov 06, 2010 | 1992 Honda Accord

1 Answer

I have a rattling sound when i ever i dip my clutch pedel


sounds like the shock springs on the clutch friction plate,nothing to worry about unless it judders....

Jun 15, 2010 | 2002 Jaguar X-Type

2 Answers

Clutch pedel stuck on floor


The clutch master has blown out

Jan 19, 2010 | 1990 Ford F250

1 Answer

The cluch petal on my 1993 VW golf wount spring back up


If it is a hydraulic clutch system,,then you have a failure of the hydraulic clutch system, if its a cable,,then either the cable has snapped inside the harness or at either end,,or has become disconnected at the clutch release arm.

Jan 29, 2009 | 1999 Volkswagen Golf

4 Answers

Clucth pedel


hey man, i had a similar problem
you should look under at the clutch bracket to see if that broke
then check above the same bracket to see if the upper mount broke

idk
hope this helps

May 24, 2008 | 1992 Toyota 4Runner

Not finding what you are looking for?
1999 Ford F250 Regular Cab Logo

Related Topics:

42 people viewed this question

Ask a Question

Usually answered in minutes!

Top Ford Experts

yadayada
yadayada

Level 3 Expert

60769 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

21949 Answers

Fordexpert

Level 3 Expert

5331 Answers

Are you a Ford Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...