Question about 1996 Mitsubishi Eclipse

2 Answers

Fuel injectders ,not opening up - 1996 Mitsubishi Eclipse

Posted by on

2 Answers

  • Level 1:

    An expert who has achieved level 1.

    Corporal:

    An expert that has over 10 points.

    Problem Solver:

    An expert who has answered 5 questions.

  • Contributor
  • 5 Answers

The problem is most likley caused by the crank sensor it controles the injectors and cam sensor opperate the spark email if need more help gtaylor1987@yahoo.com

Posted on Jan 16, 2009

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

    Vice President:

    An expert whose answer got voted for 100 times.

  • Mitsubishi Master
  • 329 Answers

1 : If the engine is hard to start when hot, check fuel pressure and check the injector for leaks.

2: If the injector does not operate when the engine that is hard to start is cranked, the following as well
as the injector itself may be responsible.
(1) Faulty power supply circuit to the engine control unit, faulty ground circuit
(2) Faulty MFI relay
(3) Faulty crankshaft position sensor, camshaft position sensor

3. If there is any cylinder whose idle state remains unchanged when the fuel injection of injectors is cut
one after another during idling, make following checks about such cylinder.
(1) Injector and harness check
(2) Ignition plug and high tension cable check
(3) Compression pressure check

4: If the injector harness and individual part checked good but the injector drive time is out of
specification, the following troubles are suspected.
(1) Poor combustion in the cylinder (faulty ignition plug, ignition coil, compression pressure, etc.)
(2) Loose EGR valve seating
(3) High engine resistance

if you need more info, you can download the fuel system service manual from my mediafire account. 3000gt fuel system FSM

Posted on Oct 16, 2008

1 Suggested Answer

frcs68
  • 1605 Answers

SOURCE: fuel injectder won't open no

most likely is the ECU. all injector ae control be the ECU.

Posted on Oct 16, 2008

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Fuel filler door want open how do I get it to open?


Ford Escape Questions - Gas tank door - CarGurus

www.cargurus.com > Questions > Ford > Escape

CarGurusApr 17, 2014 - If you have to use a gas can (from running out of gas), the car will come with a ... If it's not big enough, the metal door won't release. ... ford 2009 escape cap less fuel tank I cannot get the flap door open go fill the tank 1 answer.

Opening gas tank - Ford Explorer and Ranger Forums "Serious ...

www.explorerforum.com/forums/showthread.php?t=312717

Apr 6, 2011 - 12 posts - ‎10 authors
Opening gas tank Stock 2011 - 2016 Ford Explorer Discussion. ... open the fueldoor. I am out of town so I was trying to get some feed back to let her know tonight when I talk to her. ... Push on the gas door and it will pop open for you. ... Your fuel tank is equipped with an Easy Fuel "no cap" fuel filler system.

Cap-less fuel fill stuck shut!!! - F150 Ecoboost Forum

www.f150ecoboost.net/forum/.../8119-cap-less-fuel-fill-stuck-shut.html

Oct 30, 2014 - 10 posts - ‎6 authors
So this morning I stop to fill up with fuel and I can't put the nozzle in the tank! ... station where their fuel nozzle didn't "fit" the capless thing so the door didn't open. ... You need the Ford funnel. ... Like they're saying, if the pump end isn't big enough it won't hit the latch. ... You'll get the nozzle stuck in the filler.

Jan 24, 2016 | 2013 Ford Explorer Limited

1 Answer

Fuel filter location 08' volvo v50 1.8 petrol?


Removal & Installation

Print

NOTE The fuel filter is either on the left side of the firewall or next to the fuel pump near the left side of the fuel tank.

  1. Before servicing the vehicle, refer to the Precautions section.
  2. Relieve the fuel system pressure.
  3. Remove or disconnect the following:

    Negative battery cable Fuel filler cap Fuel lines from the fuel filter Fuel filter from the bracket

To install:
  1. Install or connect the following:

    Fuel filter to the bracket Fuel lines to the fuel filter Fuel filler cap Negative battery cable
  2. Start the engine and check for leaks.


  3. 0900c152801c13b0.jpg enlarge_icon.gifenlarge_tooltip.gif

    Fig. Using an open end wrench to push the quick disconnect coupler sleeves back-5-cylinder models
    Using an open end wrench to push the quick disconnect coupler sleeves back-5-cylinder models



NOTE The fuel filter is either on the left side of the firewall or next to the fuel pump near the left side of the fuel tank.
  1. Before servicing the vehicle, refer to the precautions in the beginning of this section.
  2. Relieve the fuel system pressure.
  3. Remove or disconnect the following:

    Negative battery cable Fuel filler cap Fuel lines from the fuel filter Fuel filter from the bracket

To install:
  1. Install or connect the following:

    Fuel filter to the bracket Fuel lines to the fuel filter Fuel filler cap Negative battery cable
  2. Start the engine and check for leaks.

    0900c152801c13b0.jpg enlarge_icon.gifenlarge_tooltip.gif

    Fig. Using an open end wrench to push the quick disconnect coupler sleeves back-5 cylinder models
    Using an open end wrench to push the quick disconnect coupler sleeves back-5 cylinder models



NOTE The fuel filter is either on the left side of the firewall or next to the fuel pump near the left side of the fuel tank.
  1. Before servicing the vehicle, refer to the Precautions Section.
  2. Relieve the fuel system pressure.
  3. Remove or disconnect the following:

    Negative battery cable Fuel filler cap Fuel lines from the fuel filter Fuel filter from the bracket

To install:
  1. Install or connect the following:

    Fuel filter to the bracket Fuel lines to the fuel filter Fuel filler cap Negative battery cable
  2. Start the engine and check for leaks.

    0900c152801c13b0.jpg enlarge_icon.gifenlarge_tooltip.gif

    Fig. Using an open end wrench to push the quick disconnect coupler sleeves back-5-cylinder models
    Using an open end wrench to push the quick disconnect coupler sleeves back-5-cylinder models


On these models, the fuel filter is part of the fuel pump assembly. Refer to Fuel Pump removal and installation.

May 12, 2012 | 2005 Volvo V50

1 Answer

How to replace a diesel pomp


.
  1. CAUTION
  2. Smoking or open flame of any type must not be present when working near fuel or fuel vapor.


  1. Disconnect both battery ground cables.


  1. Raise and support the vehicle.
  1. Before servicing the vehicle, refer to the Precautions Section.
    CAUTION Smoking or open flame of any type must not be present when working near fuel or fuel vapor.
  2. Disconnect both battery ground cables.
  3. Raise and support the vehicle.
  4. Open the fuel/water separator drain valve to release the fuel pressure.
  5. Disconnect the electrical connectors.
  6. Disconnect the fuel pump electrical connector.
  7. Disconnect the fuel warmer electrical connector.
  8. Disconnect the water-in-fuel electrical connector.
  9. Disconnect the fuel hoses.
  10. Remove the fuel hose retaining clips and discard. Disconnect the fuel hoses from the fuel pump.
  11. Press in the retaining clips and release the fuel hoses.
  12. Remove the mounting nuts and the fuel conditioning module.
  13. To install, reverse the removal procedure. Torque the nuts to 11 ft. lbs. (15 Nm).

  1. Open the fuel/water separator drain valve to release the fuel pressure.

12_18_2011_10_53_10_pm.jpg

Dec 18, 2011 | 2007 Ford E-350 Super Duty Length XLT

1 Answer

2004 BMW 530i how to replace fuel filter


The fuel filter is serviced only as part of the left fuel level sensor assembly in the fuel tank


1. Remove rear seat bench

2. Fold carpet forwards

3. Fold back rubber mat

4. Remove the nuts and fold back metal cover

5. Disconnect electrical connector

6. Release and disconnect fuel feed and return lines

CAUTION: The fuel gauge must roughly indicate zero before the left tank opening is opened. Large quantities of fuel may emerge upon opening. If necessary, keep the left tank opening closed and feed an extraction hose through the right service opening to the left tank half and drain the fuel out of the left tank area before proceeding.

7. Release the screw cap

8. Carefully raise fuel level sensor until sensor flange emerges.

CAUTION: Risk of breakage! When raising sensor unit, do not pull excessively on connecting piece of fuel return line.

9. Disconnect line to fuel filter

10. Disconnect suction jet pump from fuel filter (Press catch downwards to detatch suction jet pump)

11. Remove left sensor unit from the tank.

12. Reverse order to install

Feb 19, 2011 | 2007 BMW 530xi Sports Wagon

1 Answer

1999 cadi fuel dor will not open


Hello,

when you pull the fuel door from inside, there is a hook that releases that makes the fuel door opens. Its is possible that the hook is not releasing, that's why the door won't open.

At this point, you will have to manually open the fuel door with a flat screw driver. Ask someone to put the fuel door control from inside the car, while you deep a flat screw driver to release/free the door.

This should open the fuel door. After the fuel door is opened, you can check the hook and see why its not responding.

Good luck.

Dec 03, 2010 | 1999 Cadillac DeVille

1 Answer

Can't open the fuel door. Need to replace fuel


Check out your trunk. Many times there is an auxillary pull cable to open the gas door in the trunk.

Oct 04, 2009 | 1998 Lincoln Mark VIII

1 Answer

Same problem on mye A3 97 mod


To manually unlock, open the trunk/boot lid, pull back the carpeted panel directly behind the fuel door, look for the manual fuel door release cable. pull it to open.

Aug 24, 2009 | 1997 Audi A4

1 Answer

Thermostat problem Daihatsu Applause a101 engine


The new thermostat will be marked with an arrow,the spring side points towards the motor.

May 25, 2009 | 1992 Daihatsu Charade

1 Answer

Fuel door won't open


ok check the sliding door on the side the fuel door is on. there is a safety mech. there the door needs to be closed all the way. if its not you can't open the fuel door. so slam that door then find out where and how it keeps the fuel door from opening. because if you open the door with the fuel door open it may damage fuel door

Jan 27, 2009 | 2002 Honda Odyssey

1 Answer

Fuel injectder won't open no fuel getting in to the pistons


most likely is the ECU. all injector ae control be the ECU.

Oct 16, 2008 | Mitsubishi 3000GT Cars & Trucks

Not finding what you are looking for?
1996 Mitsubishi Eclipse Logo

386 people viewed this question

Ask a Question

Usually answered in minutes!

Top Mitsubishi Experts

yadayada
yadayada

Level 3 Expert

60667 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

21936 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

6811 Answers

Are you a Mitsubishi Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...