Question about 1999 Buick Regal

1 Answer

Theftlock code what is the default theftlock code for the cdplayer i forgot my code?

Posted by on

  • 2 more comments 
  • El Beefo Nov 14, 2008

    i got the code from my radio and called the number but it says the 206010 code is invalid i was just wonderin if u have an updated account number.



    thank u

  • Anonymous Jan 11, 2009

    same invalid code message....

  • Anonymous Mar 04, 2009

    nothing happen. When i press and hold the 1 and 2 button for ten second the word locked stayed in place no three digits appears so i let the engine run for an hour and tried again still no three digits. What can i try now.

  • okayisok Apr 27, 2009

    Lost my owner's manual that has the code in it; the code given under 1999 suburban didn't work either...I have a 99 blazer, so it should be the same code.

×

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

    Vice President:

    An expert whose answer got voted for 100 times.

  • Master
  • 341 Answers

GM DELCO THEFTLOCK RADIO UNLOCK CODE:
1. Press and hold presets 2 and 3 for about 5 to 10 seconds until you
get 3 digits on your display. This is the first 3 of 6 digits you will
need, so write 'em down.
2. After doing step one and writing down the code, immediately press
the
AM/FM button to get the last 3 of the 6 numbers you'll need, and write
'em down. (if you wait too long between steps 1 and 2 and the LOC code
displays again, just start over).
3. Call this number, it's a prerecorded message, so don't worry about
having to talk to anyone...1-800-537-5140. The voice will ask if
you're
calling for Chevy, Pontiac, Cadillac, etc... When you here him tell
you
to press "2" for Pontiac, press 206010 and hit the # key. He'll ask
you
for the 6 digit code that you've written down. Enter that and press
the
* key. He will then give you a code, and the option to get additional
4
digit codes, but one should be sufficient.
4. Follow the normal procedure in your owners manual for unlocking the
radio with your new code...press the hour set button on your radio
until
you get the first two numbers of the code, then press the minute set
button until you've entered the last two numbers. Immediately press
the
AM/FM button once the correct code is entered and the code SEC or
"secured" will be displayed on the display screen. Now, just turn the
radio on, and your ready to roll.
There is an additional step you can take to remove all codes from the
radio and start from scratch by entering your own personalized 4 digit
code so that it won't get you in a pickle again! Just repeat step 4
and
you should get a display screen that reads ---. This means the code is
out, and you can now program your own code. Of course, once you
receive
the 4 digit code from the GM recorded message, just keep it in a safe
place, because you can use that same code again and again should you
have any more problems with it in the future. Good luck, and yes, it
does work.

Posted on Oct 21, 2008

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

2004 GRAND PRIX RADIO THEFTLOCK REMOVE


You need to enter the unique code for your radio that was given to the orig owner. If you do not have that you will need to see the GM dealer.

Jun 25, 2012 | Cars & Trucks

1 Answer

Locked car radio


The stereo has "TheftLock". If the power is disconnected from the stereo, it will not turn back on without first inputting the four digit security code. This renders the stereo useless if someone steals it from your car. If you've never set a code, the factory default code will be listed in the owner's manual. If you do not have one, call your local dealer for the default code.
www.DelcoLockCode.com will get you your unlock code for you. It's only $5 so it's better than going to the dealership.

Nov 09, 2010 | 1998 Chevrolet Monte Carlo

2 Answers

I have a pontiac 2004 van i need to unlock the radio


Your '04 is too new to unlock on your own.

There are 2 types of GM Theftlock, Theftlock I and Theftlock II. The Theftlock I is found in pre 2000 vehicles, and Theftlock II is in the later models.


Theftlock I - Uses a volatile user settable code that is input through the key pad on the front of the Radio. If the power is lost (dead battery etc.) the code is gone and must be re-entered for the radio to work. But with the correct procedure the owner can unlock it.

Theftlock II - Uses an EPROM (erasable/programmable read only memory) or a PROM (the difference is you can not alter the prom once it is programmed).

In either case the code is burned in and holds even when the power is lost. With Theftlock II the radio is married to the vehicle by way of the VIN. When the vehicle is started the computer compares the number in the radio with the VIN in the body control module. If they match, the radio works, if not the radio displays LOC and you are finished, there is no easy way around it. The radio will not work until you make a trip to the dealer.


The dealer will use a TECH 2 scanner to change the VIN stored in the radio. The radio does not need to be removed (for the serial number or any other nonsense). The technician just plugs into the computer and resets the VIN in the radio.

Thank you for using fixya, you can try removing the fuse to your radio for 5 min and reconnect it. This will reset the radio back to default and re-read the Vin number to the PCM to match with the radio. At most time this will get your radio working again and all you have to do is to re program the pre-set and clock.

Aug 06, 2010 | 2004 Pontiac Montana

1 Answer

Unlock radio need code to lock radio mufflerman08@yahoo.com


Your '02 is too new to unlock on your own.

There are 2 types of GM Theftlock, Theftlock I and Theftlock II. The Theftlock I is found in pre 2000 vehicles, and Theftlock II is in the later models.


Theftlock I - Uses a volatile user settable code that is input through the key pad on the front of the Radio. If the power is lost (dead battery etc.) the code is gone and must be re-entered for the radio to work. But with the correct procedure the owner can unlock it.

Theftlock II - Uses an EPROM (erasable/programmable read only memory) or a PROM (the difference is you can not alter the prom once it is programmed).

In either case the code is burned in and holds even when the power is lost. With Theftlock II the radio is married to the vehicle by way of the VIN. When the vehicle is started the computer compares the number in the radio with the VIN in the body control module. If they match, the radio works, if not the radio displays LOC and you are finished, there is no easy way around it. The radio will not work until you make a trip to the dealer.


The dealer will use a TECH 2 scanner to change the VIN stored in the radio. The radio does not need to be removed (for the serial number or any other nonsense). The technician just plugs into the computer and resets the VIN in the radio.

Thank you for using Fixya and you may want to try pulling the fuse to your radio for 2 min and then reinstalling it. This may reset your radio and have the ECM recognize the radio matching VIN number to the Trailbalzer.

Jul 15, 2010 | 2002 Chevrolet TrailBlazer

1 Answer

I need a radio code to unlock gm part 10356164


Your '05 is too new to unlock on your own.

There are 2 types of GM Theftlock, Theftlock I and Theftlock II. The Theftlock I is found in pre 2000 vehicles, and Theftlock II is in the later models.


Theftlock I - Uses a volatile user settable code that is input through the key pad on the front of the Radio. If the power is lost (dead battery etc.) the code is gone and must be re-entered for the radio to work. But with the correct procedure the owner can unlock it.

Theftlock II - Uses an EPROM (erasable/programmable read only memory) or a PROM (the difference is you can not alter the prom once it is programmed).

In either case the code is burned in and holds even when the power is lost. With Theftlock II the radio is married to the vehicle by way of the VIN. When the vehicle is started the computer compares the number in the radio with the VIN in the body control module. If they match, the radio works, if not the radio displays LOC and you are finished, there is no easy way around it. The radio will not work until you make a trip to the dealer.

The dealer will use a TECH 2 scanner to change the VIN stored in the radio. The radio does not need to be removed (for the serial number or any other nonsense). The technician just plugs into the computer and resets the VIN in the radio.

Thank you for using fixya and keep us posted.

Jul 10, 2010 | 2005 GMC Yukon

1 Answer

I NEED TO UNLOCK MY STERO IN A 2004 TAHOE


There is no actual "security code" in the radio as in past model years. The newer theft deterrent system utilizes the class 2 serial data to determine if the radio is in the appropriate vehicle...in other words it compares the VIN it has stored in it's memory with the VIN of the other modules (body control and PCM) in the vehicle to "check" to see that it's in the correct vehicle.

Each time the radio receives the "run" power mode message, it compares the VIN information it has stored to the VIN information received from a module on the class 2 serial data circuit responsible for transmitting that information. If a mis-match occurs, the radio display will indicate to the user the radio is locked. Once this takes place the radio will not respond to any buttons/commands and becomes inoperative. But the dealer can reestablish the radio into a different vehicle with a scanner.

There are 2 types of GM Theftlock, Theftlock I and Theftlock II. The Theftlock I is found in pre 2000 vehicles, and Theftlock II is in the later models.


Theftlock I - Uses a volatile user settable code that is input through the key pad on the front of the Radio. If the power is lost (dead battery etc.) the code is gone and must be re-entered for the radio to work. But with the correct procedure the owner can unlock it.

Theftlock II - Uses an EPROM (erasable/programmable read only memory) or a PROM (the difference is you can not alter the prom once it is programmed).

In either case the code is burned in and holds even when the power is lost. With Theftlock II the radio is married to the vehicle by way of the VIN. When the vehicle is started the computer compares the number in the radio with the VIN in the body control module. If they match, the radio works, if not the radio displays LOC and you are finished, there is no easy way around it. The radio will not work until you make a trip to the dealer.

The dealer will use a TECH 2 scanner to change the VIN stored in the radio. The radio does not need to be removed (for the serial number or any other nonsense). The technician just plugs into the computer and resets the VIN in the radio.

Thank you for using fixya and good luck. you might get luck by removing the fuse toy our radio for 5 min and reinstalling it, this will reset the radio to default and all you need to do is reset the clock and radio presets.

Jun 15, 2010 | 2004 Chevrolet Tahoe

1 Answer

Codigo de cdplayer camioneta honda2001


I NEED THE CODE MY CDPLAYER IS LOOKED WHEN II CHANGED MY BATTERY
CARMEN

Jan 20, 2010 | 2001 Honda CR-V

2 Answers

How do I unlock my radio if I forgot my password


Sorry bud,
gonna have to a GM dealership to have them reset it.
good luck,
Jay

Oct 04, 2009 | 1999 Chevrolet Corvette

1 Answer

I need a theftlock code to unblock it!


Try 0000 first and if that does not work, go to www.radio-code.com they should be able to get your radio working again. Good luck and let me if this helped.

Jun 29, 2009 | 2000 GMC Safari

Not finding what you are looking for?
1999 Buick Regal Logo

1,980 people viewed this question

Ask a Question

Usually answered in minutes!

Top Buick Experts

yadayada
yadayada

Level 3 Expert

70387 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22041 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

6880 Answers

Are you a Buick Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...