Question about 1996 Plymouth Grand Voyager

1 Answer

Engine codes i have a 1996 grand voyager and code 21 comes up...what does that code mean?.........and i just changed the resister for the speed control for my heater and a/c.........works good till i turn on the a/c........and it will blow.....then stop,and then start blowing again after a few minutes?

Posted by on

  • yadayada
    yadayada May 11, 2010

    Where do you get this code 21, is it an AC code??

×

1 Answer

  • Level 1:

    An expert who has achieved level 1.

  • Contributor
  • 1 Answer

Where is the ECM on a 96 voyager van? we need to replace it. thanks.

Posted on Oct 17, 2008

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Engine code 15


use a real scan tool ($9 ask), if in USA and is 1996 or newer.
plug it in and read all the codes.
No vehicle distance (speed) sensor signal detected during road load conditions.
this means the VSS is dead.
the veh, speed ,sensor.
is the speedometer dead too?
is the A/T shifting funny? (tranny)??

the fsm is here, you can read all about it .
emission control chapter,.

http://www.jeep4x4center.com/knowledge-base/index.htm?utm_source=cj#service


then
wiring
8w-30-12 (8w-80-38, 3 pin connector fell off tranny tail, or loose or pins corroded, or wires there mangled.)
VSS
chapter 21 tranny page 32 bam there it is.

Apr 08, 2014 | 1996 Jeep Grand Cherokee

1 Answer

Transmission will not shift stuck in second gear! Speedometer does not work & I have replaced both the input & output speed sensors on the transmission & neither still works! I have a 97 Plymouth Grand...


the check engine light should be on with a code P0700 present. This means that the transmission control module has codes in it. You will need a high end scan tool (not an OBDII code reader) to get those codes. Once you know what those codes are post them here and I'll be happy to assist you further.

Sep 06, 2013 | 1998 Plymouth Grand Voyager

1 Answer

Error codes 738


All I have for code 738 is "trans control module speed output circuit low" which means the data going to the trans control module needs to be checked.
You would probably need a scanner to watch the data flow from the transmission to find the problem

Apr 11, 2013 | 1996 Plymouth Grand Voyager

1 Answer

P0140 bank 1 sensor 2 1996 plymouth grand voyager minivan


Code 140 is for a problem with the O2 sensor bank one sensor two.
This sensor is behind the catalytic converter and tells the computer if the cat is working or not.
The code means the sensor voltage has not changed as often as it should.
Could be a faulty sensor, wiring harness problem, or other issue.
The sensor would need to be tested using a scanner.

Dec 14, 2012 | 1996 Plymouth Grand Voyager

1 Answer

1999 plymouth grand voyager se transmission shifts into 2nd imediatly and stays there, speedometer and odometer not working. overhead console comes on but not working


probably has a bad input or output speed sensor gone bad.they have a known 100% fail rate.check codes first if there is a bunch of them and one is input or output speed sensor then thats whats wrong, replace both they are only 20 bucks each and just screw in

Mar 22, 2010 | 1996 Plymouth Grand Voyager

1 Answer

1991 plymoth voyage comes uyp with code 12 and 21


If the engine is running fine and you disconnected the battery recently then don't worry about it. To clear the check engine light and the code�s you can do one of two thing�s. One pull the negative battery post off the battery for 30 second�s. This clears the computer codes and the light. However it also clears your radio presets and clock. Another way is to pull the fuse labeled �Fuel Pump�. This fuse is in a box under the hood behind the battery (See photo to the left), Should be the only yellow 20AMP fuse in there. This fuse also disconnects power to the PCM "computer" as well � Kind of a secret to the general public� Just leave this fuse out for 30seconds or so. Then replace. This will keep your clock and radio presets. The engine might be a little hard to start or die the first time since the computer has to relearn everything again

Jul 27, 2009 | 1991 Plymouth Grand Voyager

1 Answer

My grand voyager check engine light keeps coming on,but i do not know the problem.its a van.


cycle key, on,off,on,off,on & leave on (not start) now count flashes of check engine light, 2 digit numbers. For example. flash,flash,flash, pause, flash, flash, flash, is code 33. or flash, flash, pause, flash, is code 21. Write them down & get back to me. when you get code 55, that's telling you end of message.

Apr 18, 2009 | 1995 Plymouth Grand Voyager

1 Answer

What does code #31 for a plymouth voyager mean?


According to minimopar.knizefamily.net, fault code 31 is "Purge Canister/EGR Solenoid".

Feb 27, 2009 | 1996 Plymouth Grand Voyager

1 Answer

Plymouth voyager 1994 check engine code 34 35 5


34 = Speed Control Solenoid Circuits: An Open or Shorted Condition has been detected in the Speed Control Vacuum or Vent Solenoid Circuits.
35 = Radiator Fan Relay Circuit: An Open or Shorted Condition has been detected in the Radiator Fan Relay Circuit.
That 5 at the end should have had another 5 after. Did it? 5-blinks and 5-blinks means the system has finished sending the Codes.

Oct 31, 2008 | 1999 Plymouth Grand Voyager

Not finding what you are looking for?
1996 Plymouth Grand Voyager Logo

Related Topics:

236 people viewed this question

Ask a Question

Usually answered in minutes!

Top Plymouth Experts

yadayada
yadayada

Level 3 Expert

64052 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

21990 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

6812 Answers

Are you a Plymouth Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...